1/2 X 3/4 Aluminum Bar Stock

Hot Products

FAQ

LED lights string broken, how to repair?
LED lights string broken: you can check one by one, which is bad, which change.
Rated voltage of LED lamp string
When normal luminescence, each LED voltage drop is more than 2 volts, the current is about 15mA, to use 220V direct current should be connected in series with nearly one hundred led, or in the LED circuit series resistance, so that the series circuit current is about 15ma.
How much is the voltage across the 20 LED lamps in series?
Each LED is about 3V, and the 20 series is 60V
Hanging on the tree string lights, each one is 10 meters long, with a controller, I asked the factory with the AB protection, but the manufacturers say that only do the general anti rain, no water, even the rain stop, I want to use plastic wrap, don't know? Which expert can give advice and advice? emergency
Now the market has launched a LED string lamp controller. Professional rainproof. You should be able to buy it at the big mall!!!
I want to do a string of LED lights that can use batteries. About 55 or so. The lights are 5MM blue. How can I work? Urgent urgent!!
55, it is blue, blue and white as the power is too large, large power consumption, even in parallel connection, the voltage of 3V certainly do not move with the battery, just to be able to provide 4.5V voltage, and three batteries of 5 words for a while no electricity, regulated power supply with advice, use parallel to, from the 3V voltage can be gradually increased, the brightness is just perfect, too high voltage lamp
Section LED lantern, no controller, can shine principleTwo now reduced brightness string string
LED string:Light emitting diodes, referred to as LED, are made from compounds containing gallium (Ga), arsenic (As), phosphorus (P), nitrogen (N) and so on.
Example: if I want to do a 40 head low voltage lamp string, do 10 lights, 1 loop, transformer is 150MA, then how can I calculate the resistance? The grid is 60 Hz of China's power grid! Give a formula, and then count the examples. What is it?! Thank you
Diode products cannot be calculated by resistors.
Why are there three lines for the controller of the LED light string? What are they?
Common positive (red line +) is the positive pole for each street lampThree road cycling (blue line) this four lines are respectively connected with the four colors of LED tube anode side run. When the positive pole is connected to the common cathode, remember that the resistor must be connected first to connect to the positive electrode of the LED tube. The bright output (white) is the word to make it bright