PVC Insulated and Sheathed Shipboard Power Cable of Rated
- Ref Price:
-
- Loading Port:
- Shanghai
- Payment Terms:
- TT or LC
- Min Order Qty:
- 100 m
- Supply Capability:
- 30000 m/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
PVC Insulated and Sheathed Shipboard Power Cable of Rated
Product Introduction
The PVC insulated and sheathed shipboard power cable with rated voltage up to and including 0.6/1kV applicable for all kinds of shipboards and over-water buildings like petrol platform at sea.
Operating Characteristics:
Rated voltage of cable：0.6/1kV.
Continuous permissible operating temperature: 60℃.
Min bending radius under installation:
Metal braid armored type：6D；
Non-armored type：4D≤25
6D＞25
Specification:
Nominal cross-sectional area mm² | Referenced current carrying capacity | |||||||||||
5 | 7 | 10 | 12 | 14 | 16 | 19 | 24 | 27 | 30 | 33 | 37 | |
1.5 | 7 | 6 | 5 | 5 | 5 | 5 | 4 | 4 | 4 | 4 | 4 | 3 |
2.5 | 10 | 9 | 8 | 7 | 7 | 7 | 6 | 6 | 5 | 5 | 5 | 5 |
Temperature for continues operating | 60℃ | |||||||||||
Surrounding temperature | 45℃ | |||||||||||
Correction Factors at Different Ambient air Temperatures:
The highest permission temperature of conductor | Correction factors at different ambient air temperatures | ||||||||||
35℃ | 40℃ | 45℃ | 50℃ | 55℃ | 60℃ | 65℃ | 70℃ | 75℃ | 80℃ | 85℃ | |
60℃ | 1.29 | 1.15 | 1.0 | 0.82 | — | — | — | — | — | — | — |
65℃ | 1.22 | 1.12 | 1.0 | 0.87 | 0.71 | — | — | — | — | — | — |
70℃ | 1.18 | 1.10 | 1.0 | 0.89 | 0.77 | 0.63 | — | — | — | — | — |
75℃ | 1.15 | 1.08 | 1.0 | 0.91 | 0.82 | 0.71 | 0.58 | — | — | — | — |
80℃ | 1.13 | 1.07 | 1.0 | 0.93 | 0.85 | 0.76 | 0.65 | 0.53 | — | — | — |
85℃ | 1.12 | 1.06 | 1.0 | 0.94 | 0.87 | 0.79 | 0.71 | 0.61 | 0.50 | — | — |
Picture
- Q: I wanted to buy this card: What power cables will it need? Thanks in advance
- You don't need any power cables. The board gets power from the mother board. You need a PCI-Express slot on your mother board. If you're asking about video cables to the monitor, it says in the listing... Interfaces 2 x DVI-I - 29 pin combined DVI , 1 x HDMI - 19 pin HDMI Type A , 2 x DisplayPort - Apple mini-DisplayPort You only need one of these unless you are running more than 1 monitor. I would look on your monitor and see what connections you have. (2) DVI-1 is common is older stuff, (1) HDMI is the newest technology and common for HDTV, (2) Apple ports for Apple enabled monitors.
- Q: it is not the power cable either
- Hi okorder Hope this helps. Thanks and Regards, Chinmay S
- Q: computer MB does not contain a power supply connector for the SATA power cable leading to the SATA HD, is this the norm? the cable connector is 5 prong female, there is no 5 prong male connector on the MB or the PSU. any suggestions?
- ur mainboard is only ide compatible then, u can add a sata pci card tho so as to add sata drives !!! :)
- Q: I have been doing research online and have found replacement power cables from Kimber, Nordost, PS Audio, Cardas, Monster and Audioquest. While Kimber did win an award in Audiophile magazine, the write up for PS Audio's SC statement cable appears to be very good as well. Nordost makes a great product too, but have read some complaints that it actually cheats the bass. So I am basically looking to see if anyone owns any of the replacement cables from these companies or what they could recommend as a good replacement power cord.
- This question does not make sense. Power cord for what equipment? Most audio and video equipment comes with the power cord attached or uses a standard 3 prong 110v power cable that you see on computers. A power cord should not affect quality. To improve quality, you should have a power conditioner or line conditioner to clean the power going to your equipment. Please elaborate on what you are trying to do.
- Q: My old card only needed one of these cables. but my new 4870 will need two. can i just use a IDE-to-PCI-e power cable? its only got 3 wires out of the 6 though. does this matter?
- That potential supply is right for that card... do not hardship approximately it... The 4890 takes much less potential than a 4870 and my previous equipment with a 4870 relatively purely used 330W with dissimilar 120mm case followers a 92mm and an 80mm... in case you have already got that PSU then save it....
- Q: where do you run the power and signal cables for a sound system in a peugeot 307
- well for convenience, id run the power cables on the side of the car that the battery is on and the rca's on the other side.
- Q: in the specs it says the power supply doesn't have a pci-e connector?Does that mean i cant use the video card, or is there a way I dont know? Please help.Thank you very much
- Okay, right off the bat I see a problem with that power supply. Aside from not having a pci-e connection it states it doesn't work with SLI or Crossfire (i.e. Nvidia or ATI). Since you're wanting to get a GeForce card, which works with a mobo with an Nvidia chipset, you'd need a more up-to-date power supply. Second - that card uses 18 amps on the 12-volt rail, and according to the specs on that power supply it runs up to 16 or 17 amps, so the power supply you're looking at isn't powerful enough to support the card. My advice - first make sure your mobo has an Nvidia Chipset. Second, spend a bit more and get a better power supply, and check the voltage - you need at least 18 amps on the 12-volt for that card.
- Q: some one told me that cisco get this router without AC power it get the power from the network cable?
- You need to make sure your Switch supports POE (power over Ethernet).
- Q: I lost the power cable to my Dell printer 922. Can anyone help me find the cable online, or at a store. Dell told me they don't sell the cable. thanks for the help!! =]
- visit OKorder
- Q: Need the cable you plug into your outlet and it's plugged into the back of your power supply on your computer. My computer is for gaming and is very modern so I need one that wont melt and can handle everything. Anyone know of anywebsites that I can order a high quality one from?
- all you need is a bog standard power lead. The power unsit runs off mains voltages so a 500W supply uses only 2A (ish) (if on a 220V system) and 4A if on 110 (approx)
Send your message to us
PVC Insulated and Sheathed Shipboard Power Cable of Rated
- Ref Price:
-
- Loading Port:
- Shanghai
- Payment Terms:
- TT or LC
- Min Order Qty:
- 100 m
- Supply Capability:
- 30000 m/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
