Product list of China Engine type Generator FX300
- Loading Port:
- Shanghai
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 1 set
- Supply Capability:
- 1000 set/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Specifications
1.Jichai diesel generator
2.Optional alternator
3.long-term spare parts
4.low fuel consumption
5.economic price
1100kw/1375kva Jichai Reliable Diesel Generating set
Engine features :
1.China most famous brand diesel engine: Jichai engine
2.Multi-cylinder in-line or veer engine,4 stork,direct injection
3.Naturally aspirated,turbocharged,water cooled or turbochaged with air intercooler.
4.Machinery or electronic governing
5.Fuel injection pump
6.Electric motor starting system
7.Forged steel crankshaft,cast iron cylinder and replaceable wet type cylinder liner
8.Low discharge,and low fuel consumption
9.Installed conveniently and maintain easily
Alternator Features:
1.World famous brand AC alternator:Leroy Somer,Stamford,Marathon.Engga ect.
2.Brushless,4 poles,rotation magnet
3.IP21-23 enclose is standard for all industrial alternators.
4.H class insulation system
5.AVR self-regulated,voltage regulation rate:±1%
6.Simple installation and maintenance with easy easy access to terminals ,rotating diodes and coupling bolts.
7.Moisture proof,sand-proof,dustproof ,salt-proof and vibration-proof.
Control system:
1.a) Automatic alarm system:the unit has the acousto-optics alarm system and arrestor for any situation as the start defeat,the water is over temperature,
the oil pulls down ,over speed,over load and over current.
b) Operation display:
i)Unit voltage,tri-phase load current and frequency display
ii)Water temperature .oil pressure display
iii)Fuel level, fuel temperature display
iv)Audible and visual alarm lamps and buzzers
2.Starting system:DC alternator is used to start engine.
3.Short circuit protection :MCCB air switch
4.Cooling system:combined cooling water tank fitted to meet the requirement of radiation at ambient
temperature 40°C
5.Filter system:oil ,fuel and air filter
6.Accessories:exhaust elbow,below,muffle
Model | Output POWER(KW) | Engine Model | Engine Power | |
PRIME | STANDBY | |||
FX300 | 45 | 300 | SC4H95D2 | 62/68 |
- Q: I have a 3 phase 30k 60hz generator what would I need to do to use this to power my home ?
- If the voltage is correct and you have access to the neutral the transfer switch is required by NEC. The electrical connections are neutral to the grounded conductor and one line to one leg and another line to the other leg with the 3rd phase isolated. Since the configuration of 3 phase generators may vary it is best to have a qualified professional electrician who has experience with them do the work. Some generators are Y configuration but others are a delta configuration with a tapped neutral. This will result in 1 high leg voltage which will damage electrical equipment. This size generator is best powered by diesel. Hope this helps. I repeat get an electrician who has worked on these units they are seldom a DIY for emergency power for a home most systems are single phase 120/240 volt 60 HZ in North America.
- Q: and diesel generator and ATS that switches between two electrical sources ??
- There may be no difference. It will depend on the application. For example, if I specified an ATS that had the proper voltage and current capacities, the only other item of concern would be to determine if the transfer would be a make before break or a break before make type of transfer. In a make before break, it would mean the sources would be placed into parallel operating condition before one of the sources was interrupted. This would require the ability to synchronize the sources. Which means the frequency, voltage and phase relationship of the sources must match before they are placed into parallel service. On a break before make switch, usually only phase rotation and approximate voltage levels are of concern. Hope this helps, Newton1Law
- Q: I have a 1992 chevy 250 with a 6.5 turbo diesel, I have built a hydrogen generator for it that produces 2lt./min. but do not know how to hook it to the truck or where before or after the turbo.
- doesn't mattereither way it will throw off the fuel mix and cause a rich or lean condition causing loss of mileage and performance and shorten engine life.
- Q: I have 6,500 gas generator to run two 12,500btu roof a/c units on my bus.Nothing but problem after problem with generator.I was advised to change unit out to diesel unit! Any advise on what size i should be looking for?
- You don't say what the generator problems are. It may be undersized for the AC units you are trying to run plus other things you are trying to run. The AC unit may require all of the generator's capacity for about 2 seconds to start. So if one AC is running, there may not be enough capacity to start the second AC unit. What other things are you running off the generator at the same time? The 6,500 watt generator can only supply a maximum of 27 amps out of the 240 volt outlet or 15 amps out of each of the 120 volt outlets or any combination that does not exceed the 6,500 watt capacity of the generator. A diesel engine has nothing to do with the capacity of the generator. Diesel engines are used on larger capacity generators or continuous duty generator sets. The generator itself doesn't care what type of engine is spinning the rotor. Will the generator run just one of the units? If it does, then my thoughts are the generator doesn't have the capacity to run the loads you have.
- Q: I know a train runs on an electric engine powered by a diesel generator. Would something like this be feasible for cars?
- Not at the present cost of diesel. Nothing mechanical is 100% efficient, and when you start converting the different power sources - diesel to electric, electric to rotary, for instance - the torque and power may be sufficient for a particular application, but the inefficiencies simply add up from one source to the next.
- Q: If i had a remote alaskan town of 1000 residents, how much power would I need to generate to run the whole town. Would a diesel generator work?
- You need kilowatts, not kilowatt hours. The amount of power you need varies depending on who turns on what at any given time, and especially on what kind of equipment you are using in the mine. Mines can use huge amounts of electric power. Assuming you are talking about a fairly small mine, you are probably looking at something around 500 kilowatts peak demand. This would require a small power plant. You may be able to get a diesel generator this size, but it would be more efficient to use several smaller generators. This would allow you to shut down some generators to vary the output to meet the varying demand.
- Q: i have a 2004 duramax 6.6 diesel truck.does anyone know if there is a converter kit to use the truck as a generator for my house?
- Yes it can but using a truck engine for such a purpose is a bit expensive. There is a kit made out there for such a task, had just read a little bit about it the other day, but dont remember where I saw it. You would actually be better served by investing in a proper stand alone generator. Good luck.
- Q: If I am living alone in a studio. Any help appreciated :)
- less then a hundred dollars
- Q: What are the advantages of diesel generator sets
- Advantages: 1 small noise; 2 low temperature conditions, easy to start quickly.
Send your message to us
Product list of China Engine type Generator FX300
- Loading Port:
- Shanghai
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 1 set
- Supply Capability:
- 1000 set/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords