Grey Cast Iron Structure

Hot Products

FAQ

Casting parts by shot blasting, spray painting, baking after the formation of very small rust spots, how to solve ah?
The first process is very important. Shot blasting must be thorough. The solution is to wipe the surface of the paint with a release. Re shot
How can the casting be free of trachoma?
3, the gate is not facing sand core, flush sand core, will cause trachoma.
What method of casting does not rust? I think the sample is like oil
The surface of a general casting is easy to rust. In order to prolong the rusting period, antirust paint or antirust oil is usually sprayed. What you said should be anti rust oil.
Casting blank in the cooling process to release a large amount of heat energy, what can be recycled?
Casting, do not need to provide a rough casting foundry drawings, according to your chart will put foot margin in the processing needs of the surface, the rest of the size can be found according to the mechanical design manual and manual casting. General Casting Factory Casting Division will be in your chart marked on shrinkage and processing margin figure (usually with red and green pen) to the patternmaker production of wood or other material mould diagram.
Which master knows how the casting tolerances for malleable iron, gray iron and ductile iron should be chosen? Hurry up, thank youCan you provide a tolerance scale for castings, please?
The tolerance of a specific size can be obtained from the tolerance grade and nominal size of the casting.
Why do cheap cars like stamping parts instead of casting parts?
We usually say that the stamping is usually refers to the cold stamping parts, for example, a piece of iron, wants to turn it into a fast food dish, it must design a set of mold, mold is working face plate shape, the pressure plate mold, it becomes you want the dishes, this is the cold stamping die stamping is the direct use of metal materials.Automobile stamping parts are mainly classified according to process, and can be divided into two major parts: separation process and forming process.
The difference between sheet metal and casting parts
Casting parts are made by casting (followed by a variety of processing), the shape can be simple, can also be very complex, usually large parts, as a base, bed, work table, and so on, good seismic performance.
the parts of the threaded hole is casting, casting the hole directly, and then tapping or casting, and then punch 10When the casting is ready, punch it again before tapping it Is the hole casting good or is it punched and tapped on the drilling machine after casting?
Single for this problem, the direct casting out of course good. But many times because of the limitations of the process, so we choose the post-processing hole