Broken Cast Iron

Hot Products

FAQ

Does the tap belong to a stop valve or a gate valve?
Most faucets are stop valves,Part of the faucet is plug valve,Hot water nozzles are almost all plug valves.
What are the main types of gate valves?
According to the thread position of the valve stem, can be divided into two kinds of open rod gate valve and dark rod gate valve.
Z41T one 10 gate valve and Z44T one, 10 gate valve difference
Z41T one, 10 is single gate, Z44T one, 10 is double gateAccording to the provisions of the JB/T 308-2004 valve type programming method:Z== gate valve4== connection: flange type1== structure: Rigid single gate4== structure: Rigid double gateT== sealing surface material: copper alloy10== pressure rating: 1.0MPa
Soft sealed gate valve and hard sealing gate valve which good?
If the caliber, material and pressure levels are the same, the current market price is still soft sealed gate valve, about 20-30%.
Gate valve type Z40Y, Z40H letters - what does that mean?
According to the provisions of the JB/T 308-2004 valve type programming method:Z== gate valve4== connection: flange0== structure: wedge type elastic RAMY== sealing surface material: hard alloyH== sealing surface material: Cr13 stainless steel
What does gate valve do?
Valve in the pipeline can only be fully open and fully closed off, can not be adjusted and the throttle. Gate valve is a valve used in a wide range, generally more than 50mm caliber DN block device is selected it, sometimes cut off very small aperture devices are used to gate valve, gate valve is used as cut-off media, when in full flow through the whole, when the media is running a minimal pressure loss. Gate valves are normally used in situations where they do not need to be frequently opened and closed, and the gate is fully open or fully closed. Not used as an adjustment or throttling. For high speed moving medium, the gate can cause the vibration of the gate under the condition of partial opening, and the vibration may damage the sealing surface of the gate and the valve seat, while throttling will cause the gate to suffer the erosion of medium.
The legend of gate valve and stop valve
The working principle is different. The stop valve is an upward stem type, and the handwheel rotates and rises with the stem. Valve is hand wheel rotation, stem upward movement. Flow is not the same, the gate valve requires full open, the cut-off valve is not the same. The gate valve has no inlet and outlet direction requirements, and the cut-off valve has the required inlet and outlet!Gate valve and stop valve are shut-off valve, is the most common two valves.From the exterior, the gate valve is shorter than the cut-off valve, especially the bar valve needs a higher height space. Valve sealing surface has a certain degree of self sealing capacity, its spool depends on the media pressure tight contact with the valve seat sealing surface, to achieve tight leakage. Wedge gate valve spool angle is generally 3~6 degrees, when forced to shut down excessive or temperature changes of the valve core is easy to die. Therefore, high temperature and high pressure wedge gate valve, in the structure have taken certain measures to prevent spool stuck. The valve in the opening and closing valve and valve seat sealing surface contact and mutual friction is always so easy to wear sealing surface, especially in close off the valve, the valve before and after the great pressure, sealing surface wear is more serious.
Analysis of the advantages of elastic seat sealing gate valve?
When the elastic seat sealing gate valve is closed, the sealing surface can be sealed only by the medium pressure, that is, the sealing surface of the flashboard is pressed to the valve seat of the other side only by the medium pressure to ensure the sealing of the sealing surface, which is self sealing.