Single Core and multi-core PVC Insulated and PVC Sheath Cable 450 /750 V BS6004 6181Y
- Ref Price:
-
- Loading Port:
- Shanghai
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 1000 m
- Supply Capability:
- 3000 m/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Single Core and multi-core PVC Insulated and PVC Sheath Cable 450 /750 V Production Introduction for Single Core and multi-core PVC Insulated and PVC Sheath Cable:
Voltage Rate: 300/500V, 450/750V
Cores: 1~5 cores
Range of Nominal cross section: Single core: 0.75 mm2 ~ 630 mm2
Multicore core: 0.75 mm2 ~ 120 mm2
Conductor: Class 1/2 Plain annealed copper wires, solid or stranded
Constructions: Insulation: PVC
Sheath: PVC
Core color: Brown, Grey, Black, Blue, Green/Yellow or others on request
Max. Operating Temperature: 70℃, can be 90℃,105℃as per requirement
Packing: 100 meter/roll for small size, wooden drum for big size, or as per requirement
Application for Single Core and multi-core PVC Insulated and PVC Sheath Cable:
These cables are used for general purpose, as building wire for power, lighting and control wire to electrical appliances, suitable for use in conduit and for fixed, protected installation.
Production Standard for Single Core and multi-core PVC Insulated and PVC Sheath Cable:
I EC 60227, GB/T5023, VDE0281, BS6004
The Feature for Single Core and multi-core PVC Insulated and PVC Sheath Cable:
The cable can be of flame retardance, fire resistance and other property
Packing photo for Single Core and multi-core PVC Insulated and PVC Sheath Cable:
FAQ For Single Core and multi-core PVC Insulated and PVC Sheath Cable:
Q1:What is the Production Capacity for your factory?
About 50 kilometer every day
Q2: What is the Minimum Order Quantity For Single Core PVC Insulated Cable 450 /750 V?
MOQ: 10000 meters for small size, 5000 meters for middle size, 1000 meters for big size
Q3:What is the delivery time for these cables?
10~15 working days
Q4: What standards is the product complying with?
We can produce thousands of electric wires and power cables complying with different standards, such as: GB, JB , IEC, BS, AS/NZS, VDE, UL ETC.
- Q:Basically bought a new graphics card (480 gtx) and im going to install into my computer but i wish to also install a phyx card as well. This seems simple enought but i only have 2 6pin power cables in my pc atm and im am unsure how to install another 2 6pins. Current PSU is a antec 1000w
- You okorder /
- Q:So I've been working on my computer aand looking to invest in a primary Hard Disk (instead of X2 250GB hard drives). I noticed the drive i have has Fantasy power outlets and newer models have SATA Power so I'm kind of confused on the Hard Drive i should get. I'm looking at hard drives 500GB-1TB
- Fantasy power outlets don't sound standard. SATA is consistent on both PCs and Macintosh computers.
- Q:a usb cable has 5 volts and 2.5 watts. so can it still power if it has 5 volts and 1.5 watts
- Uh...YES! The voltage matches and the current will be regulated by the resistance of the device being powered. It will work fine.
- Q:I live in Chicago, and I want to know if somebody can help me. The next house on mine have electrical power cable, telefon and cable from my back yard and pas my propriety aprox 60 tf, the last two stay on my garage, its legal ?Know haw i can do to move the cable? some codes or regulation, samething? Thanks, Best regards.
- If you suspect someone is in violation of the electrical code for the city of chicago call the City offices and ask for the electrical inspector ..ask them to take a look..Better safe than sorry...From the E..
- Q:I am doing a test if the power supply.Can you have the computer on and plugged in with PSU out in the open, leave on the carpet ?Can you have the power cable plugged into the psu first and then try to plug in the psu cable into the mother board. Would this electrocute you? if you accidentally knocked over liquid onto the power supply while the computer is running and you touched the motherboard at the same time while you are perfectly grounded. Can this electrocute you? unpluging the psu connector while the computer is on?
- If you have already pulled the fan off, do so again (without reaching into the power supply. Take a good look at the shaft of the fan. I'll wager there either is, or was, a set screw in that shaft. Most likely you'll need a hex wrench to get that locked back into place. This would also explain the lack of air flow when it is working without making a racket. Good luck. Best regards, Jim
- Q:My amp was working this morning. On my way home, the power cable came out somehow. I put it back in and it wasn't powering on. The amp fuses were blown, I replaced them. Then I went to hook the battery terminal back and the fuse in my power cable blew instantly. I replaced it and tried again and it blew again. Also the fuses in the amp are fine now. I did the same process when I installed my amp the first time and it was fine so I don't know why it's doing this now. The amp is a Boston Acoustics 800w RMS amp and an 80a fuse. Any ideas?
- you got a short to ground, make sure ANY part of the Positive (hot) wire is not touching the chassis
- Q:what the size of power cable 3 core for motor 18.5 Kw with star dalta starter?
- It is entirely dependent on the voltage supplied to the motor. At 230 V (wye connection to motor), rated current is 80 A. At 460 V (wye), rated current is 40 A. At 600 V (wye), rated current is 31 A. Different cable sizes required for each rating (for minimum cross-section) ... however, cable sized for 80 A will certainly do the job for the higher voltage ratings, assuming it is insulated for the appropriate voltage.
- Q:computer MB does not contain a power supply connector for the SATA power cable leading to the SATA HD, is this the norm? the cable connector is 5 prong female, there is no 5 prong male connector on the MB or the PSU. any suggestions?
- The power for your hard drive actually comes from your PSU, in the form of a 4-pin molex connector. As for the SATA...if it is a SATA hard drive, you'll want a SATA motherboard. Almost all modern motherboards have these connections. If yours doesn't, I'd imagine it's just old...or really cheap.
- Q:I have a hard drive that has an enclosure is there any way to take an internal 3.5hard drive and convert it to an only usb cable portable hard drive with no power cord?
- No. Not a 3.5 hard drive. You can do it with a 2.5 laptop drive because the drive mechanics and electronics require less power. A 3.5 drive requires too much power for USB to provide. Though... In the near future, you will see USB ports that are capable of supplying more power than the standard .5 amps that USB currently provides. So after they come out, you might see it being a possibility then.
- Q:ive recently opned my external harddrive case so that i could put dat harddrive in my pc ... i was able to take out the ide cable but i cnt take out the power cable... plz help me.. how can i take out the power cable?
- Thats nothing new..Molex connectors often stick do not try to pull it out by the wires! grab it by the sides of the connector and wiggle it back and forth (side to side) it will come out eventually!
1. Manufacturer Overview |
|
|---|---|
| Location | |
| Year Established | |
| Annual Output Value | |
| Main Markets | |
| Company Certifications | |
2. Manufacturer Certificates |
|
|---|---|
| a) Certification Name | |
| Range | |
| Reference | |
| Validity Period | |
3. Manufacturer Capability |
|
|---|---|
| a)Trade Capacity | |
| Nearest Port | |
| Export Percentage | |
| No.of Employees in Trade Department | |
| Language Spoken: | |
| b)Factory Information | |
| Factory Size: | |
| No. of Production Lines | |
| Contract Manufacturing | |
| Product Price Range | |
Send your message to us
Single Core and multi-core PVC Insulated and PVC Sheath Cable 450 /750 V BS6004 6181Y
- Ref Price:
-
- Loading Port:
- Shanghai
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 1000 m
- Supply Capability:
- 3000 m/month
OKorder Service Pledge
OKorder Financial Service
Similar products
New products
Hot products
Hot Searches
Related keywords
