High quality Flame-retardant Control Cable with a good price
- Ref Price:
-
- Loading Port:
- Qingdao
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 10000 m
- Supply Capability:
- 100000 m/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Flame-retardant Control Cable
Introduction
Flame-retardant control cable has a very good property for resistant causticity of chemical solvent. It is used as a connecting wire of electrical equipment and instrument, transmitting wire of automatic control system for rock oil, chemical, electric power and metallurgical etc.
Features
Rated AC Voltage: U/U0 450V/750V.
Max Working Temp: 200℃ for F46 insulation and 260℃ for PEA insulation.
The Lowest Environment Temp: Fixed deploying is -40℃ and Non-Fixed deploying is -15℃.
Mounting and Deploying Temp: ≮0℃.
Permitted Minium Bending Radius: not smaller than 12 times diameter for copper tape shield or steel wire winding and 6 times outer diameter for other cable.
Application
This product is used in AC rated voltage 450 / 750V and below connecting line of instrument and Electric appliance in power distribution device ,applicable to the places where requires high flame retardant.
Introduction of our company
Our company is a professional China Wire and Cable Manufacturers, mainly supply Aerial bundled cable,House Electric Wire, Insulated Overhead Cable,Aluminium Conductor Steel Reinforced, PVC Control Cables,XLPE Power Cables,BV Electric Wires,Nylon Sheathed Cable,Buried Cable,High Voltage Cable,House Electric Wire,Single Core Flexible Copper Cable,Civil Wire And Cable etc. series of wire and cable products, sincerely welcome everyone to visit.
- Q: What is the essential difference between cable model YJV and KVV?
- General under the bridge can be put into a hand into the line on the line.
- Q: WDZA-KYJ23-450 / 750V What is the difference between the two models .WDZ-YJ (F) E-0.6 / 1.0KV What is the difference between the two models.
- Well away from home 90 meters flat road do not have to consider, slope to estimate the height
- Q: i have a tv but can't watch cable because i don't have a outlet to watch cable how can i watch cable
- if your TV does not have cable socket (RF), then u need to buy a RF to AV converter. which is commonly used in old TV were remote control is not used, this set up box has fully remote control with RF input and RF output with AV output also now connect the AV out from set up box to your TV AV in change the channel in set up box will change channel see ur need one.
- Q: I just hung my tv on the wall and replaced the video and audio cables with an hdmi cable. Now the cable remote no longer controls the TV volume and I have to use the original TV remote to control volume. I have checked all the settings and I cannot figure it out. Does anyone have a solution here other than calling the cable company and getting the run around?
- The cable remote likely controlled the analog audio out on the box. It has no such control over digital out, which HDMI is. You need to re-program the remote to control the TV, including volume.
- Q: I tried setting it up like a monitor for my computer and after I plugging in the cables neither the remote nor the panel controls worked. I tried unplugging it and thought it would work but now I can't even turn it on. What can I do? Please help I really don't have the money to purchase a new one.
- There is one more thing to check. Since you omitted the brand of tv and the model, I don't know if there is a master power switch hiding on the bottom of the panel. I moved one and bumped the switch after I had fixed it. I had to tear it apart again only to find this switch. It was an Akai.
- Q: I would like to keep my car original but most likely isn't going to happen due to what the previous owners did.They put a newer trans in year 90+. Don't really know how to determine exactly what year its from. But all I know is the transmission I have now controls the gauges electrically instead of by a cable.So do they make aftermarket gauge clusters that are powered by electric or could I just by a aftermarket speedo and pop out my cable driven one. Then hook it up? In theory it sounds like it would work, just wanted to see if anyone had any experience with this.Its an 88 Camaro by the way if it matters.
- you can buy after market speedo that will work or switch the speedo drive in the trans tailshaft over to cable instead. Not cheap either way
- Q: I am using these cables to control intelligent lighting systems and would like to know how many feet of cord you have to go through and carry the signal before you start to experience any kind of signal fading or loss. I am using 3 pin XLR cables. I am controlling two ACCU spot 250's and a Pilot 150 Intelligent light.
- In general, you would want to use a single cable for the entire run if possible. Every time you add an additional cable, you are lowering the reliability of the system (but not by too much if they are good quality cables). Lighting control signals are very forgiving and you should be able to run that signal for several hundred feet over XLR cables with no problems. Like I said though, you should eventually replace the multiple cables with one long cable for better reliability when you can afford it.
- Q: am i to understand my cable company cannot filter my web sites???
- they cant
- Q: I replaced the traditional audio and video cables with an HDMI cable. The problem is that I can no longer control the volume using the cable remote, so I have to use the TV remote. Is there any way that I can control the volume using only the cable remote instead of having to use two remotes? If it helps, my TV is a Panasonic Viera and the cable box is a Motorola DCT3416. Thanks!
- you probably need to program your cable remote to your tv. the cable company usually give u a pamphlet of the codes and they usually program it for you but i would call them and see if u could get a code or get somebody out to your house
- Q: I have a plasma TV and have HD cables and HD box hooked up to it, but the problem is its so quite when watching cable. I have to turn the sound up to 75% just for it to be audiable. This doesnt happen with the other things hooked up to the TV ie: my game systems and DVD player. They blow me away with the sound just at 25 % so whats the deal. Is Timewarner horrible, or is it something with my TV?
- i think its your tv LCD rules ew plasmalol hmm i had that problem before but the cable guy did it for me before he left because i couldnt hear no sound and rush to go get him befiore he left im not sure what he did buy he did something withthe remote
Send your message to us
High quality Flame-retardant Control Cable with a good price
- Ref Price:
-
- Loading Port:
- Qingdao
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 10000 m
- Supply Capability:
- 100000 m/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
