Aluminum Rod 6101-T65

Hot Products

FAQ

Why aluminum wire immersed in copper sulfate solution, static?
Because the activity of aluminum is greater than copper, it can displace copper from the salt solutionChemical equation: 2Al+3CuSO4=Al2 (SO4) 3+3Cu
How to make the product more bright when drawing the aluminum wire for the special light agent of aluminum wire drawing?
Through this mechanical device, we can strictly control the chemical composition in the alloy.
Home wire, can not use aluminum thread?,
Open line is absolutely ok! Dark or copper wire is recommended! You mentioned above, these appliances are very small power, four square aluminum enough, but the aluminum must pay attention to the connector must be connected, otherwise it will contact bad, causing accidents!
Why is it that the steel structure of the bridge is black after spraying aluminum? What hazards do you have after blackening?
After the spraying of aluminium is finished, sealing paint shall be used immediately to protect against oxidation.
Computer power cord outside of a layer of aluminum wire used to do what?
It is coated with copper braid, shielding, anti-interference, and this kind of things that the power cord quality is good
Can aluminum wire and copper wire be used instead of tin wire and welded by electric iron?
The weldment should be heated to a suitable temperature --- heat source. It should be emphasized that not only the solder should be heated to molten, but also the weldment should be heated to the temperature where the solder can be melted. The end of the wire is coated with a layer of flux and plated with solder. Be careful not to let the tin immerse in the insulation of the wire. It is better to leave the 1~3mm interval before the insulation so that the tin is not plated. This tin plated wire is very beneficial to the tube, and it is also convenient to check whether the wires are broken or not.
Is the resistance of metal wire plastic increased when it is plastically deformed?
When the steel is cold working, the plastic deformation will increase the dislocation and the resistance will increase slightly. Aluminum wire and copper wire processing at room temperature is also hot processing, will not increase the resistance, for reference purposes only
What material (iron plate? Aluminium plate? Aluminium plate? Plastic board? Stainless steel plate? Can prevent the radiation of routers and light cats?
Grounding does not take into account time and reliability, any metal is OK, but in home it is necessary to protect the radiation of routers and light cats