Product/ rubber insulating wire and cable
- Ref Price:
-
- Loading Port:
- Shanghai
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 100 m
- Supply Capability:
- 100000 m/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
The highest working temperature can't exceed 70 ℃ , does not exceed 160 ℃ while holding up in 5 seconds, The cable is not limited by the drop when being laid, environmental temperature is not lower than 0 ℃ when laying. Minimum crooked radius of the cable while laying: It is in single core cables 20( D + d), mm, multicore cable( D + d), because mm,( d respectively from cable and actual external diameter of conductor in D of 15, If the leading body is not a round, then d =1.13 √S.S take as the leading factor body marked and claims the section, unit mm2)
Lay and require insulating and regularly with the performance of the electric wire:
（1） Allow working temperature for a long time:
BV-90, RV-90 type are at the time of using normally, high temperature the most of conductor is 90 ℃. Use as right to use of the cable environment can prevent from hot to mould and flow and permit and reduce insulating situation of resistance, The PVC mixture that can be used in 90 ℃ in succession , base on the premise of always shorten working timing, Its working temperature can be improved to 105 ℃. Other types should not exceed 70 ℃
(2)The temperature of laying of the electric wire is not lower than O ℃ , allow the crooked radius: The person who smallers than 25mm should not be smaller than 4D for the external diameter of the electric wire( D), the external diameter of the electric wire( D) is not smaller than 6D for 25mm and the above person.
Type of the products: HYA- copper and core ethylene hydrocarbon are insulating, LAP protects a layer of urban communication cable HYAC- copper and core polyethylene hydrocarbon synthetically insulatingly, LAP synthesizes the sheath, bearing type urban communication cable HYAC- copper and core polyethylene hydrocarbon are insulating by oneself, LAP synthesizes the sheath, bearing type urban communication cable HYA53- copper and core polyethylene hydrocarbon are insulating by oneself, The urban communication cable HYAT53- copper and core polyethylene hydrocarbon of sheath of vertical bag of steel band of wrinkle are insulating, Packing type urban communication cable of sheath of vertical bag of steel band of wrinkle
- Q: My power supply has one cable with 3 sata connectors on it. Can I connect my disc drive and hard drive on the one cable? My PSU also has a cable with 3 four pin molex connectors on it and my case has 3 fans. Can I connect all my fans to that one cable with all the molex connectors on it?
- Yes to both questions. It doesn't matter whether you're connecting only harddrives to that cable or only diskdrives (aside from the fact that these are usually located a little apart from each other.) You can combine both and they will work. As for fans... If they have the molex connectors rather than standard 3-pin fan connectors, you can connect them for sure. Depending on what power supply you have, you'll probably have anywhere from 18-30amp on your 12v molex rail. Harddrives will take under 2amp, and depending on what fans you have, they'll use anywhere 0.5-3amp, so even if you have 3 extremely powerful fans drawing 3amp each (3 x 3amp = 9amp), you can safely connect 6 of such monster fans to that 12v molex rail. To be honest, I haven't met too many of such fans - most standard 120mm fans, even with leds, will use no more than 1.5amp. 80mm fans non-led fans will use about 0.3-0.5 amp. If you have a very powerful psu with 30amp on 12v rail and hundred of 80mm fans, in theory you can run all of them. In practice, I'd like to see that :)
- Q: Does the nvidia GT 520 require any power supply cables to be attached to it or do only the mid/higher end cards like HD 6870 require psu cables to be attached?Thanks
- for low end cards, you dont need an additional 6 pin or 8 pin power cable for it. It is only for mid range and high range cards that need additional cable for it. For GT 520, you don't need it.
- Q: The circle thing on the end of the amp power cable wont fit onto my battery, so idk what to do, should i strip the wire and connect it to my battery like that or should i cut the circle thing (i really dont know what the hell its called) to the point where it will fit around my battery
- I'm not quite sure how your trying to attach it to the battery, but you should be able to take the ring and slide it over the the little bolt that is on your terminal. After that just tighten the nut over it. If this isn't working you may want to invest in a aftermarket terminal. They're pretty cheap and depending on the one you get you should be able to hook it up with the ring on the end or strip it and connect it using whatever method the instructions say.
- Q: Hi, Im building a computer and my Power supply dosent have enough Cables/wires for all the slots. We do have enough to fill one motherboard power slot and we also have enough to fill about a hal of one. Can my computer run with just half of one of the slots? Also, my computer's Graphics card, a Gigabyte GV-N560UD-1GI nVidia GeForce 560 Ti, has two power slots, and the wires that it comes with have 2 4 pin peripheral power cables brnching off of it. My power supply only has enough to fill 1 of the cables. My dad says it will be fine but i dunno. Please awnser quickly! Any awnsers will be much a preiciated
- for the GTX560 Ti Here is what your APEVIA ATX-TL450W 450 Watts has: Those are for your motherboard: 1 x Main connector (20Pin / 24 Pin) 1 x 12V(4Pin) Those are for SATA and Molex HDD, DVD 3 x peripheral (aka Molex 4 pin) 1 x SATA Plus 1 x Floppy which no one uses anymore Your only solution would be to buy a newer, better power supply, which is what I recommend. Or, as a compromise (not recommended, as your power is not big enough for all components). Use 2 Molex to PCI-e cable adapters to power your graphics card. Use 1 Molex to SATA to power your DVD drive Use the only SATA to power your hard drive. Good luck.
- Q: My cable broke, and I need a new one.This type of 4-pin connection to the PSU: I need multiple SATA connectors, if possible a really long cable. :3 I've been looking everywhere but can't seem to find it, I'm probably just not searching for the right terms.Thanks!
- thats not a sata cable, thats a motherboard 4 pin power connection, you cant replace it, you need to buy a new PSU. Edit_ just google 4 pin motherboard power cable Edit_ i think i know what you mean now. you have a moduler PSU, were you can take off the cables? and put them on if you want more? just google Modular Sata power cable, or something like that. you'll probably have to ask the manufacturer for these if it is though, because there hard to find. the only other thing that you could use (and that i could think of) is a Molex to sata (molex is the square 4 pin one)
- Q: Where can i find the power cable for this specific TV brand ? GO-VIDEO-2050..?
- Most TVs use two different types of power cable with either a normal female end or a two-prong narrow female end. Go to Best Buy and most likely you can find what you need.
- Q: Hi All, i have a star sound 1200w 4way amp which i want to use just for my sub for the meanwhile as im waiting on a monoblock, please tell me if i can install the amp without the fuse that connects straight on the power cable?? and what is the main reasons for that fuse? thanks in advance
- You could connect it without the fuse but if something shorts out your going to fry the wiring. That's fuse is there for a reason, I wouldn't recommend not using it.
- Q: power cables of 630 mm buried (cable trench) what could be the reason for fire?
- a power surge can definitely cause a cable fire. but i believe insulation failure tops that, in buried cables in particular. and insulation failure is prompted more often with cables that come in direct contact with the earth, rather than those that may be run through piping, deterioting the insulation even faster. of course if the cable is damaged by digging, that could start a fire as well.
- Q: Now i get a message saying I have low system voltage. Is this gonna impair performance? Are there adapters for this?This is for a DESKTOP. Dell XPS.
- What? What are you saying? What processor uses a 10 pin power connector? You did 'say' CPU! (Central Processing Unit) Or do you mean the 20 pin ATX Motherboard connector? (AMD's use no power to processor connector. Intel Pentium 4 and UP, use a four pin power connector, from the power supply to the motherboard. (Mobo) Edit: Low System Voltage will start with causing weird things to happen. Then the computer motherboard power headers,(Connectors), will burn up. I suggest you turn this computer off, un-plug it, and email me.
- Q: remove just this cable or use different hd and it works fine, is the hd broken or is it a power consumption by the hd issue? tryed a different psu and its the same problem, unfortunately not got another pc handy to check the hd on. Thanks In advance?
- change the hdd interface bus u may get solution otherwise replace it. .in
Send your message to us
Product/ rubber insulating wire and cable
- Ref Price:
-
- Loading Port:
- Shanghai
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 100 m
- Supply Capability:
- 100000 m/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
