Auto Lighting System DC 12V 0.28A 0.06W with Blue CM-DAY-080
- Ref Price:
-
$6.42
/ pc
- Loading Port:
- Shenzhen
- Payment Terms:
- TT
- Min Order Qty:
- 100pcs pc
- Supply Capability:
- 20000 Pcs Per Month pc/month
OKorder Service Pledge
Quality Product, Order Online Tracking, Timely Delivery
OKorder Financial Service
Credit Rating, Credit Services, Credit Purchasing
You Might Also Like
Auto Lighting System DC 12V 0.28A 0.06W/ LED 6000K~7000K 168-196LM 5mm Chip Blue CM-DAY-080 1. Unique and beautiful design
2. Imported high power LED lighting source. attractive fashion style
3. Easy installation, anti-collision, OEM Fitment
4. Stable excellent Performance,waterproof, anti-aging, against antioptica, energy saving, anti-interference, heat-endurance
5. Easy installation, comes with install guidance.
2. Imported high power LED lighting source. attractive fashion style
3. Easy installation, anti-collision, OEM Fitment
4. Stable excellent Performance,waterproof, anti-aging, against antioptica, energy saving, anti-interference, heat-endurance
5. Easy installation, comes with install guidance.
- Q: ADDITIONAL PROBLEMS:My Low Coolant occassionally comes on.anddd my Air Conditioning/Heater only works on the highest setting. ANY SOLUTIONS?!?!? THANKS!!!!
- take the car and have auto zone scan the computer,its free, chances are its just sensor that's bad for the air abs system in it, as for the low coolant light those have sensor that goes bad that will cause that light to come on,and for the heater problem you may have a bad blower motor resistor on it bad that will make the heater motor only run on a certain speed,most of these are minor problems though and should be able to be corrected with not to much cost involved,good luck.
- Q: detected. can someone please tell me what that could be and how much would it be to fix.
- Could be a leaking fuel cap, could be anywhere on the evap lines or connections. It could be 10$ for a cap or a few hundred for any evap system components. Have a mechanic diagnose the system and get you a price.
- Q: They don‘t completely go out, but dim for a second then get bright again. Happens about once every 90seconds. Checked alternator - tested good one store bad at another. Can‘t see any obvious bad connects , contacts or grounds. ‘98 Ford Taurus. Suggestions?
- loose belt most likely or bad belt might be dirty cables but not as likely as belt being bad id go to auto zone or any shop just ask them to check charging system again or just say my lights are blinking i think my belt is loose or bad
- Q: my oil light, brake light ,high beam light ,abs light,brake light, shift light,check engine light, are stuck on when i start the car they never go off ? any clues whats wrong?
- When you ask a question like this one please have enough common sense from now on to give the make,model and year of car.Im going to go out on a limb and say your computer control is fryed.Since i dont have any more information thats just a guess.The reason i say computer is because all those light arent supposed to come on just because youre starting the car.So it leads me to believe the central control for your lights is bad.good luck
- Q: Why is the car headlamps often fire line
- The FireWire is powered by a 12V or 24V lead-acid battery on the car, regardless of whether the car key is always powered. The headlamps are pre-boot safety assist, especially at night, so before the key is inserted Or start the car can also open the headlamps before the lighting, so then the direct fire line can be directly switch control, not subject to key constraints.
- Q: I take my pixs on manual or aperture priority and usually can get the light that I want, but not the sharpness. I am shooting on Fine and i always try to keep my ISO low if I can, I also remember to white balence for each new environment. Is there something else that i should be doing because I am so disappointed with my shots even though I love the composition.
- there should be a bar going across either by the main breaker or at the bottom of the panel, you remove that bar - it's called the bonding jumper. the netural goes on the right side and the ground goes on the left side. you also need to install the bonding screw that came with the load center - you put it on the ground side. seeing how this is a main panel the netural and ground can both go toghther. just dont remove the bonding jumper. if it was a subpanel than you would need to seperate the two. that screw in the meter does not need to be removed from the looks of the picture that screw bonds the netural to the meter base. OK the ground from the ground rod goes under that terminal in the meter base, the ufer ground goes to the ground in the panel, the netural and ground should be hooked together with a bonding jumper somewhere
- Q: Car lights division of the two lights system of four lights how to point, there are cars of the lights.
- Two lights: This structure uses a light bulb containing two separate light sources, through a mirror projection of low beam and high beam. Each headlamp can be issued near the light and high beam, usually used in the middle and low cars. Far and near light can not be bright at the same time. Or only when using the light horn, the distance light can be bright at the same time
- Q: I have, from the day of installation, my check engine light has been on . Today I had the interlock removed and not 30 minuted later my car started stuttering. I live 30 plus miles that the car had to be driven 35mph in a 65mph speed limit the entire time. When exiting off the highway the power steering went scaring my 74 year old mother. We made to Advance Auto were they checked the car and determined that the transmission solenoid was bad. After researching I see where the transmission contol unit has something to do with retarding igniton timing. Now, I am no mechanic, but I have believe this is how they are connecting the interlock/ I realize that DWI is the reason for having this system in the first place, but, does getting DWI mean you have to accept someone damaging your vehicle, costing big money to fix, and time without the vehicle, not mention the fact the whole incident could have caused a wreck, because of the vehicle malfunction.
- Its very possible but its only wired to the vehicle’s ignition system from the ones that I have seen and the installers from what I read are certified but at the same time they may have either connected the unit to the wrong power source or disconnected something and you need to have a professional auto repair shop look into this and if they find that it was installed incorrectly have them document this so that you can go back to the company and request a full reimbursement
- Q: They auto shutoff once cars started, even in darkness;No handle to alter auto-lights in car;Tried unhooking battery to reset electronics, no luck.06 Volkswagen Passat 2.0t
- ZZ is right. I would add that the windshield may have been replaced with the wrong windshield, blocking the rain/light sensor on the rear view mirror. Without a properly operating light sensor, Auto Headlight operations are not going to happen. If the headlights won't come on with the Headlight switch in the On position, I would look at the switch, the car battery, or the charging system.
- Q: Car headlamp bulb feet and feet difference
- As long as the formal lamp factory, are commonly used models have, such as the domestic very famous headlamp factory "nine plus one" is H1, H4, H7, H11, etc. complete.
Already has more than 20 day line lamp, mainly including the following series, cheap beautiful C series, high performance-to-price ratio D series, high-end beautiful H series, the colorful eagle eye lamp E series.Mainly includes 120 cm the length of the day light, 160 cm, 190 cm, 220 cm, with high-power lamp bead, small power lamp bead, SMD lamp beads, straw hat light bead line sections, such as light, to provide customers the most comprehensive neat day lights series.
1. Manufacturer Overview
| Location | YIWU,China |
| Year Established | 2009 |
| Annual Output Value | |
| Main Markets | Mid East；Western Europe |
| Company Certifications |
2. Manufacturer Certificates
| a) Certification Name | |
| Range | |
| Reference | |
| Validity Period |
3. Manufacturer Capability
| a) Trade Capacity | |
| Nearest Port | SHANGHAI |
| Export Percentage | |
| No.of Employees in Trade Department | 20 People |
| Language Spoken: | Chinese |
| b) Factory Information | |
| Factory Size: | Above 2,000 square meters |
| No. of Production Lines | About 5 |
| Contract Manufacturing | OEM Service Offered；Design Service Offered |
| Product Price Range | Cheap |
Send your message to us
Auto Lighting System DC 12V 0.28A 0.06W with Blue CM-DAY-080
- Ref Price:
-
$6.42
/ pc
- Loading Port:
- Shenzhen
- Payment Terms:
- TT
- Min Order Qty:
- 100pcs pc
- Supply Capability:
- 20000 Pcs Per Month pc/month
OKorder Service Pledge
Quality Product, Order Online Tracking, Timely Delivery
OKorder Financial Service
Credit Rating, Credit Services, Credit Purchasing
Similar products
Hot products
Hot Searches
