Auto Lighting System DC 12V 0.13A 0.2W Red CM-DAY-037
- Loading Port:
- Shenzhen
- Payment Terms:
- TT
- Min Order Qty:
- 100pcs pc
- Supply Capability:
- 20000 Pcs Per Month pc/month
OKorder Service Pledge
Quality Product, Order Online Tracking, Timely Delivery
OKorder Financial Service
Credit Rating, Credit Services, Credit Purchasing
You Might Also Like
Auto Lighting System DC 12V 0.13A 0.2W/ LED 6000K~7000K 26-48LM SMD 5050 White CM-DAY-0361. Unique and beautiful design
2. Imported high power LED lighting source. attractive fashion style
3. Easy installation, anti-collision, OEM Fitment
4. Stable excellent Performance,waterproof, anti-aging, against antioptica, energy saving, anti-interference, heat-endurance
5. Easy installation, comes with install guidance.
2. Imported high power LED lighting source. attractive fashion style
3. Easy installation, anti-collision, OEM Fitment
4. Stable excellent Performance,waterproof, anti-aging, against antioptica, energy saving, anti-interference, heat-endurance
5. Easy installation, comes with install guidance.
- Q: it does the same in 4 wheel auto. when I hit the button to go back to 2 wheel I can hear something clicking & the 2 wheel lights up as should
- When you push the button and it flashes then goes back to where it was,it means that it won't complete the shift. Most times,you can hear the motor move meaning the system is trying to make the shift. Most times its the Encoder Motor Sensor that needs replaced. I'm pretty sure year 2000 up to 2003 you could replace the sensor only. The sensor is not telling the Transfer Case Control Module(TCCM) that it is to the position requested,so it goes back to the last known position. Just unbolt the Encoder Motor from the Transfer Case,the sensor is under the plastic spacer where the shaft sticks out.
- Q: The trailer light cord has 4 wires, and my colorado truck has a separte wire for both brake and running, so can I just connect the tail wire from the trailer plug to both of them?
- make beneficial that the working lights have a sturdy floor. attempt each and each gentle with a 12volt stick gentle tester and notice in case you have capability coming to each and each gentle. additionally examine continuity on the brown twine to make beneficial that's not broken some the place. Do you have a 4 lead twine set or six. If six leads: Blue is for backup lights, and crimson is for electric brakes on trailer. examine source from the place the capability is plugged into trailer harness and notice whether it is warm interior the plug. if so, floor fault some place.
- Q: I have a problem with a 1985 Chevy G30 van with the hydroboost system.The brakes are locking up from time to time and also are grabby at times. I know that the front brakes are locking up but I am not sure yet about the rears. If I let it set for a while the pressure bleeds of and they may be OK for a week or more. I have bled the front brakes to remove any dirt. Opening the bleeders does not to seem to instantly release the brakes either. The brake pedal does not seem to be sticking and the actuating rod length has never been changed.I have been told the master cylinder will not cause this. What about the hydro booster or proportioning valve? The brake system warning light DOES NOT come on when this happens.I am desperate here as this is the truck I use to make my living as a contractor.If anyone has experienced this please contact me.
- Its prolly low on fluid.
- Q: General car headlamps (far and near) and the ground angle, strength, exposure distance is how much, list the data of several cars to the points
- General headlamps recommended irradiation distance of 50 to 60 meters, far from 100 to 120 meters, 20 meters at the width of about 2 lanes wide, if the central overlap of the larger models can be re-adjustable width of about half a lane width , The attention is not too high because it is too high will be exposed to the other owners of the eyes caused by driving on the danger, the actual distance you have enough to step on the brake, so the car is not adjusted to the angle should be based on the manufacturers in order to facilitate production The angle of the production line and vehicle inspection required. Please adjust to pay attention to their own and the owner of the safety of the owner is more important.
- Q: KHA car light bulb which country is what factory production
- It seems to be Korea.
- Q: My 2006 Mazda 3 check engine light is on, but not blinking. The dealership said that it‘s not serious if the engine is not blinking and that it is ok to drive. Can anyone else out there confirm this is true? Has anyone else had this problem with a Mazda 3? They say it can be a loose gas cap. And that if i drive for 100 miles it should turn off.
- Play it safe, go to auto zone and have the codes scanned for free. If they say it is an EVAP code then the dealer is right and the lite will go out due to a loose gas cap. The 100 miles is to reset the OBD2 system good luck
- Q: The Brake Light was blinking and ABS was solid so I changed my front brake pads rotors and sensors. I noticed the front driver side sensor was cut so I had to rewire the sensor by hand.After replacing these my brake light is blinking and ABS is solid. When I first start the car it beeps 3 times.When I try to run a VAG-COM on the ABS and Brakes I get a error. Although I do get this messageAddress 02: Auto TransController: 4B0 927 156 GComponent: AG5 01V 2.8l5V USA 8509Coding: 00000Shop #: WSC 000001 Fault Found:00526 - Brake Light Switch-F27-00 - Implausible SignalCould a faulty brake light switch cause both the ABS and Brake light to appear?Any other suggestions on this?
- I would have It Changed. Old system was probably R-22 Freon. as you say new 1 is R410a it Runs at Higher Pressures.
- Q: What is the leveler light mean on my Mazda mpv 1997?
- is anyone able to tell what is the right answer for this question?
- Q: yo im thinking of getting Avast nowhowever, i still have a running Mcafee system running.the security index displays security and antivirus on low because i cant update it until the admin returns in a month or so.so I was wonding will Avast conflict with McAfee when it runs?
- Any antivirus will conflict with another antivirus and will cause neither to work properly. If you are going to install a different solution then you MUST completely uninstall the other and reboot before installing the other. Why you would want to go from a reliable vendor that you've paid for to a freeware solution is beyond me but it's up to you. However, if you are not the admin, then clearly it is NOT up to you and you have no business even considering removing or installing anything on that computer. Good Luck
- Q: My brake and battery lights came on yesterday afternoon. At first they were only on if I was accelerating but went off when I braked, now they stay on all the time. Also I have a really stong fluid smell but cant find a leak anywhere. It‘s smells like antifreeze but I checked all my hoses and there are no leaks on any of them. Last time this happened my car died two days later and needed a new starter. The starter was replaced in May and was brand new not used. Any ideas? Its a 91 Geo
- If the strong antifreeze coolant smell is when your in the car and you've started using the heater this year, you could have a leaking heater core under your dash. If so, eventually you may see steam in the car and an oily substance on the inside of the windshield. Drive to a local auto parts store to get your battery and charging system checked for free. Check your brake reservoir yourself to see if the fluid level is up to the full mark. But you need to get the brake light checked out immediately as noted in the first answer.
Already has more than 20 day line lamp, mainly including the following series, cheap beautiful C series, high performance-to-price ratio D series, high-end beautiful H series, the colorful eagle eye lamp E series.Mainly includes 120 cm the length of the day light, 160 cm, 190 cm, 220 cm, with high-power lamp bead, small power lamp bead, SMD lamp beads, straw hat light bead line sections, such as light, to provide customers the most comprehensive neat day lights series.
1. Manufacturer Overview
Location | YIWU,China |
Year Established | 2009 |
Annual Output Value | |
Main Markets | Mid East;Western Europe |
Company Certifications |
2. Manufacturer Certificates
a) Certification Name | |
Range | |
Reference | |
Validity Period |
3. Manufacturer Capability
a) Trade Capacity | |
Nearest Port | SHANGHAI |
Export Percentage | |
No.of Employees in Trade Department | 20 People |
Language Spoken: | Chinese |
b) Factory Information | |
Factory Size: | Above 2,000 square meters |
No. of Production Lines | About 5 |
Contract Manufacturing | OEM Service Offered;Design Service Offered |
Product Price Range | Cheap |
Send your message to us
Auto Lighting System DC 12V 0.13A 0.2W Red CM-DAY-037
- Loading Port:
- Shenzhen
- Payment Terms:
- TT
- Min Order Qty:
- 100pcs pc
- Supply Capability:
- 20000 Pcs Per Month pc/month
OKorder Service Pledge
Quality Product, Order Online Tracking, Timely Delivery
OKorder Financial Service
Credit Rating, Credit Services, Credit Purchasing
Similar products
Hot products
Hot Searches