300/500v High Computer Cable Control System
- Ref Price:
-
- Loading Port:
- Shanghai
- Payment Terms:
- TT or LC
- Min Order Qty:
- 100 m
- Supply Capability:
- 100000 m/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
300/500v High Computer Cable Control System
Appendix: Cable Properties
1. The cable is characterized by anti-acid and anti-alkali, anti-oil, and anti-aging, etc; Shielded type is anti-interference.
2. Low smoke and low halogen wire and cable has low fuming amount, releasing little hydrogen chloride, so on fire, it cause little corrosion, danger and damage to equipment, people and environment.
3. Cross-linked polyethylene insulating cable has large current capacity; and it is light and handy in structure. It is not restricted by drop. Cable short time over loading working temperature should not exceed 130℃; Total short circuit temperature not exceed 250℃; Lasting for no more than five seconds.
4. fire-resistant cable can work for over 90 minutes under 750℃-900℃; the fireproof properties test accords with GB12666.6 standards.
Cable Properties Index Specification
Low smoke and low halogen Properties Index:
1. hydrogen chloride gas release amount ≤125mg/g
2. smoke density ≤300
3. Fire-Resistant Properties and burning test Grade B Qualification
Cross-linked polyethylene Properties Index:
1. Environmental stress cracking ≥500hr
2. medium tangent angle ≤0.003
3. degree of cross linking ≥75%
Fire-resistant cable Properties Index:
1. It can work for over 90 minutes under 750℃-900℃;
2. Burning Test Grade B Qualification
Shielded cable Properties Index:
1. Little medium consumption, anti-interference, strong transmission signal
2. Heat resistant, radiation resistant, antiseptic, waterproof and airtight.
Pictures
- Q: I was just wondering because I need a new power supply for my computer. It is an Acer Aspire AM3910-U4012. Is the power cable that connects to the motherboard the only power cable I need to replace or will I need to replace all the cables in my computer for it to work properly?
- It will come with All New Cables
- Q: will my PSone power cable work on my ps2?
- If you mean on the fat PS2 then it will. The PlayStations work with each others cables, so the PS2's cables will work on the PS1 (That's how I have mine set up) and vice versa.
- Q: I just traded with someone and got a PS3. It came with just the power cord. When I plug it in the red light comes on but it just beeps twice and that's it. Is it because I don't have an AV cable or it is broken?
- haha man i feel sorry for you. What you have is a YLOD case(yellow light of dead) it can be many things wrong with it but in your case its the cpu slowly loseing i am geussing he didnt tell you that it has YLOD u will have to watch many youtube vids to fix it or just go to a hardware man or a local computer specialtest he will do it for 20 bucks
- Q: Hi. I have a Marina Power Filter (Slimline S15) and the power cable that is connected to it appears to need to be submerged in the water. That doesn't seem safe at all but the instructions (although poorly written) seem to point to that being the case,Advice please.
- yes, it's completely submersible and safe for the filter and part of the cord to be in the aquarium.... note: as another poster has pointed out, that's a crappy filter. If you ever get a real aquarium, buy better equipment.
- Q: everything was working great! and then i blew the main fuse! i replaced it everything was fine after that but then out of nowhere i only have power in half of the power cable connected to the amp!! What can i do??
- Not sure what power in half the power cable means. Are you saying (for example) you have a 6 foot power cable coming off the battery to the amp and only 3 feet has power and the other 3 feet doesn't? I would isolate the power wire from start to finish. I would bypass the power wire by running an external wire from the battery terminal to the amp. Basically, disconnect the old power wire from the battery (or source of power) and amp. Then run a temporary wire from the battery to the amp. If everything works then something is wrong with the original power wire.
- Q: What is the difference between wires and cables? Please provide a brief introduction
- The middle do not have to deal with, but also buried directly, deep 70cm, sand cover brick. It is difficult to repair, but economical and economical land.
- Q: I installed a new Power supply after my old one stopped working. I bought a Thermaltake TR2 500W. I connected everything that needed to be connected but it would not turn on. Then i disconnected the 4pin cable that goes to the motherboard, and it turned on. But my monitor didn't detect anything so it just went into quot;sleep modequot;. So every time i connect the 4 pin PCI-E connection to the motherboard it just doesn't turn on. Please help
- You might have a DOA power supply or motherboard. It might just have problems with the connections. Sounds like the problem is the motherboard if 2 power supplies dont work on it. I would consider getting a new motherboard.
- Q: the power cable is in 2 parts, one from the xbox to a box, from the box to the wallthat box has an led light. when the xbox is on, it should turn green, when the xbox is off it should turn orange. my led light is turning red instead of orange and green.its not red ring of death, or 4 red rings, i know this because my xbox wont even power up because the box in the power cable will not send power to my xbox. im so confused...plz help
- I can't answer your question coz I've got the same problem too! can somebody please answer his question?
- Q: A power cable of copper is stretched straight between two fixed towers. If the temperature decreases, the cable tends to contract; the amount of contraction for a free copper cable is 0.0017% per degree celsius. Show that the stretched cable will snap if its temperature decreases by 128°C.Ignore the weight of the cable and assume Hooke's law is obeyed until the cable breaks. Young's modulus for copper is 11.0 x 10^10 N/m^2 and the ultimate tensile strength of copper is 2.4 x 10^8 N/m^2.
- Change in length=(coefficient of expansion)(original length)(change T)= (.0017)(chose your favoret length, I chose 100)( -128 because T is decreeing)=-21.76 Strain = (change in length)/(original length)= 21.76/100= .2176Pa (for simplicity's sake I dropped the negative, rember the wire is in tension) Stress = (youngs modulus)(strain)= (11?10^10)(.2176)= 2.3936?10^10 Pa The UTS (2.4?10^8)<(2.39?10^10) so there is definitely necking and because of the difference most likely there was failure long ago.
- Q: I'm putting in my new power supply and gotta take out the old. But there isnt any clips to slide the cables out. I don't want to pull to hard and damage anything. How do you get it out. Do you pull hard? Help me.
- Yes sometimes you gotta pull or gently wiggle these power cords off. I have trouble with some systems and i dont know what it is but I will gently take a pair of pliers and pull it off if i can't wiggle them out. Be careful not to squeeze, i just use it for grip because i have fat fingers....Good luck.
Send your message to us
300/500v High Computer Cable Control System
- Ref Price:
-
- Loading Port:
- Shanghai
- Payment Terms:
- TT or LC
- Min Order Qty:
- 100 m
- Supply Capability:
- 100000 m/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords
