PVC Insulated Flat Cable 300 /500V & 450/750V
- Ref Price:
-
- Loading Port:
- China main port
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 1500 m
- Supply Capability:
- 150000 m/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
1. Product Description：
1. Wire - Copper core PVC insulated PVC sheathed flat cable is made in compliance with the national standard and have passed the CCC--China Compulsory Certification, which contains the recondition of national security certificate--CCEE. Imports of Safety and Quality Licensing System--CCIB. China Certification Electromagnetic Compatibility--EMC
2. Range of application: A.C rated voltage 300/500V
3. The permissible continuous operating temperature of wire shall not exceed 70 centigrade and the installation temperature of wire shall not be lower than -15 degree
2. Product Characteristic：
1. Main colors: sheath--white/black/grey; 2cores--red and black; 3cores--red, yellow and blue.
2. Minimum bending radius: Up to 10mm², 3 x overall diameter;10mm² to 25mm², 4 x overall diameter
3. The cable can be of flame retardance, fire resistance and other property
4. Remark: We are able to produce 2C, 2C+E, 3C & 3C+E by AS/NZS
3. Product Specification：
Type | H05VVH2-U, H07VVH2-R, H05VVH2-F, H05VVH4-U, H07VVH4-R, H05VVH4-F, BS6004 624*Y | |
Voltage Rate | 300/500V, 450/750V | |
Cores | 2C, 3C, 2C+E, 3C+E | |
Range of Nominal cross section: | 0.75 mm2 ~ 16 mm2 | |
Application | These cables are used for general purpose, as building wire for power, lighting and control wire to electrical appliances, suitable for use in conduit and for fixed, protected installation. | |
Standard | IEC60227, BS6004, GB/T5023, JB/T8734 | |
Constructions | Conductor: Class 1/2 annealed bare copper solid or strands Insulation: PVC Sheath: PVC Core color: White, Grey or others on request | |
Max. Operating Temperature | 70℃, can be90℃ and 110℃ as per requirement | |
4. Reference Picture：
- Q: i soldered in one of those ribbon cables on to my hp's laptop power button cause the old ribbon was failing. anyways i am having some issues with this new cable1 the laptop will power on by itself if i insert the ribbon into the motherboard connector2 the only way to power off the laptop is to remove the cable from the mother board connector and that means opening up the whole laptop3 like i said it will power on by itself so that means that i cant turn it on/off with the power buttonevery thing is soldered correctly i dont understand also i am not sure but does the cable have to be like the old one cause the new one i soldered in looks the same? could it be that it needs that one particular cable replaced again? please help me i am sad
- Time to hang up our computer repair skills and take it to a shop...
- Q: Okay after installing Deus Ex on a brand new PS3 slim I pressed the start button and when the screen went black the console hanged, I couldn't even press the PS button, at the suggestion of a friend I yanked the power cable. Now it works fine but I'm wary of putting Deus Ex back in, I doubt that its regioning since there's no such thing. Any ideas and troubleshooting solutions?BTW what are the consequences to yanking the power cable.
- If pulling the power cord was the *only* way to turn it off, that's ok, you just don't want to do it frequently. As for the game itself, the only thing I can think of is to make sure other games work. If so, then something about the game itself is causing the fault, but not sure what. If anything, I would say contact Sony for assistance in that regard.
- Q: I have a Technics SL-D20 Turntable recently purchased from a garage sale that lacks a power cable. The turntable has a 2 prong adapter, but it is not one that has a square and semi-circular portion, but rather seems to accept an elliptical two pronged cable. It is listed on the back as Power Source AC120V 50 or 60hZ 6wThank you
- Man that could be tough. It sounds like a belt drive turntable, I'm sure of the name of the part, but it's basically there to move the belt; it isn't metal so it isolates the belt, thus reducing vibration and transmission of motor noise. That's what I think it is anyway. I'll bet if you go on some audiophile web sites, you can find a parts listing for that model, and get a name and part number. Technics were very popular, I've got a belt drive one myself that I haven't hooked up in 10 years.
- Q: My girlfriend recently damaged (beyond repair) her hp touchsmart tm2 notebook pc Power Cable. I was wondering if laptop power cables are pretty generic, or is there a specific one that i need to order?
- I busted my Compaq laptop power cord a few months back and I was able to find another at Walmart to replace it - it set me back $75 which sucked but it was a fairly easy replacement. I imagine you'll find the same to be true with your HP. Good luck.
- Q: when you install a power cable you usually route it through the door seal and under the carpet. If there are existing speaker wires that go to your rear speakers, will the power cable create an interference?
- No, just run it through the middle of your car, not through the sides. My runs right under the cup holder area under the seats and right to the back. You cant even see it lol, my pros did a great job putting it in
- Q: Do you need to use both the 6 pin PCI-E power cable and the 8 pin PCI-E power cable on a video card? Why are they used? To give power to the video card if needed? Seems like the motherboard gives the card power as well?
- if the graphics card has an 6-pin power connector and an 8-pin connector then u need to use the 6-pin and the 8-pin power cable from your power supply.most power supplies (especially those that supply 500 watts of power to your cpu and all the peripherals) in the market right now have at least one connector for each type (6-pin and 8-pin).usually the most high-end power supplies now (like the Ultra X4 series) have more than 1 for each type.right now the most high-end power supplies from my perspective is the 1600W power supply from the Ultra X4 series.it has 3 6-pin power connectors and 3 for the 8-pin power connector. and ya the 6- and 8-pin power connector is the bridge for the power supply to transport power to the component. nope.the motherboard is a selfish guy.it doesnt give power to the graphics card unless the graphics card doesn't take a lot of wattage to work then the motherboard will donate power to the graphics card.
- Q: Single single 10kV power cable with copper shield can wear steel pipe? What will be the impact?
- Do not have to be so troublesome, such a phenomenon even encountered, is the basement of the air defense, similar to the landlord said the phenomenon can be taken as follows: . first with linen live wire and casing blank. . filled with asbestos cement and compaction, the surface concave sleeve 3-4 cm. . with plugging the king (5 yuan / bag) add water and mix well, smear the surface to smooth. . the work is completed, do not hurt the core and the practice proved no leakage within two years.
- Q: I have a HP Printer and have lost my power cable, now I am having trouble identifying the type of lead that goes in the hole (see pic link)I am in the UK
- Cada día tengo algo para imprimir o fotocopiar y por esto decidí que ya está la hora de comprar una impresora, después de todas mis buenas experiencias en OKorder estaba segura que, y de esta vez, voy a encontrar lo que busco, la impresora multifuncional que me he comprado cumple todas mis expectativos, ella me he hecho mi vida mucho más fácil.
- Q: What can I use for a power cable? Need a new one and I am not sure what to get. Could you send a link to one please?
- Looks OK for the price.
- Q: I found a box of power cables that I could use to hook up my PC and I know some of them were for old CRT monitors. Is it safe to use any of them? I'm not sure which one actually came with the monitor.
- From what I can tell, all of the monitor power cables are exactly the same. I don't see any reason why they wouldn't work or why it would be unsafe. As long as it fits easily into the LCD and plugs into your power supply then it should be just fine. (P.S. I've used old power cables on newer models before when I lost a cable once)
Send your message to us
PVC Insulated Flat Cable 300 /500V & 450/750V
- Ref Price:
-
- Loading Port:
- China main port
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 1500 m
- Supply Capability:
- 150000 m/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
