Power Cables for Mining Salt Lake
- Loading Port:
- China Main Port
- Payment Terms:
- TT or LC
- Min Order Qty:
- 100 Meters m
- Supply Capability:
- 6000 Meters per Month m/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
1 these products produced according to standard NDV and IEC2
2 Performances
Finished products can endure voltage test of 5min under AC 50HE20kv.
The Max. operating temperature of the cable conductor is 105°C.
The Min. permissible environment temperature of the cable is -55°C.
The surface of cable conductor shall be tinned; the AC resistance of conductor meets the requirement of GB/T3956-1997.
Under the temperature of 20°C, the insulation resistance shall be nor less than 300MΩ.Kma
the bending radius of the cable shall be not less than 4 times of the cable outer diameter.
With good mechanical properties: the finished products shall pass the flexing test and water treatment voltage test after the flexing test.
The cables shall have properties of acid and basicity proof, cold proof, water resistance, antiradiation, heat resistance, oil resistance, flame retardance.
- Q: Whats the Power Pass mean on a coax cable splitter?
- It means it can pass DC current, such as used for satellite LNBs and amplified antennas
- Q: I just bought a Sandisk MP3 player e200 series. It come with a USB connector which according to the product manual, its also used for power charging.Unfortunatly, it doesn't work with my laptop. I've tried to used the USB cable to charge but no power transmit to the mp3 at all. I guess my USP port in my laptop has too low capacity.I would like to buy a separate power cable for my MP3 but I am not sure if it is available. I can not find information in the Sandisk website either.Anyone knows that is there a seperate cable power for this model and where can I buy it?
- Sansa released a base station not to long ago that I love. The advantage to it is that it can not only charge the player, but it can also allow you to connect the player to a stereo system. It even has a remote control with it for the player. I got mine on OKorder just search sansa base station. This option is great for just charging and player it in the house. The advantage to the wall charger is that it is more portable. If you are looking for something to travel with that will probably be what you will want.
- Q: Recently I bought a EVGA Geforce 8800 GTS. When it came in, the card fits in my case but has 2 cables to plug in. I only have 1 cable to plug them in connected to my power supply. Should i only plug in 1, or is it nessesary? Is there an extra one I just dont know about? Please answer!
- You need to get a power cable splitter that goes from two to one. It should have come with the card, if not any local computer store should have one.
- Q: There is currently a power cable going into the back of my primary sata hard drive but i want to put another hard drive in but there is not another power cable
- I would try going to a nearby hardware store or electronics store that deals with computers and explain your situation to them. They can probably figure something out.
- Q: I got a PNY geforce 9800 gt 1gb graphics card from bestbuy and once I got it I noticed it didnt come with a power supply cable which most of the 9800s require. Anyone know why it didnt come with the power supply cable.
- Follow okorder
- Q: I've just bought myself a new motherboard for my 9800 GT but it isn't picking it up and allowing me to install it's drivers. I have noticed an extra plug on the back of the card and wondered if it maybe needed an extra power plug to it? If not, what else could be the problem?
- everything should of came in the box, if it was connected correctly it would read the new card. once its running, you'll be satisfied.
- Q: What is the role of white mesh in power cables?
- This is not the end of the family with a good audio and video lines are thousands of dollars I do not know what kind of advice you want to go to the local workers Duan Gengmang Gama moths tied to the supermarket stall can find!
- Q: My setup is an alpine MRX-M100 powering 2 alpine type R 12's on 4 ohm, and also an old eclipse PA 5422 speaker amp. The main thing is I have 4 gauge running from my battery to my amps, but I have this sort of distribution block that turns the 4 gauge wire into 2 8 gauge wires. I know that this probably isn't the best for the MRX-M100, but it's all I had or what I could afford at the time. The main thing I wanted to ask was is this bad for the amp, and what would it be like if I had 0 gauge coming off the battery so then it would be 4 gauge going to the amps? Would it be louder? Could I turn it up higher? because right now if I turn up the volume past a certain point the subs will just stop playing. If I just shut off my head unit and turn it back on they start up again. Your thoughts and recommendations would be appreciated!
- then (big three upgrade)watch a video on this.its some wiring upgrades under the hood.if your sub woofer is cutting out like you said its not getting enough power.any charging system upgrades you can do will help.remember this the alternator is the heart of your charging system if you have a chance to swap this out at least buy one that puts out at least double the amps that your factory alternator is putting out.this will not harm your car and will do wonders for your sound system.
- Q: What does the watt rating mean on amp power cables?
- in a lot of cases - not much. The name brands usually mention only total RMS power rating, and those are fairly trustworthy. But the off brands often use peak power ratings. That can mean many things from wiring kit to wiring kit, and lots of other things when you compare one amp to another. So if you're looking at an off brand wiring kit I would advise looking past the power rating and see what size fuse is included with it. That's the best way to know the actual current the wire can handle, and you can figure that for every 100A you're good for about 1000w rms.
- Q: One day, all of a sudden my amp stopped working. I inspected the battery terminal and noticed their was corrosion on both terminals, cleaned it off, and I inspected the fuse in my positive wire for my amp and noticed the fuse was blown, replaced it and the amp would still not power on, I reinspected the fuse again and it had already blown, I replaced it once more and it did the same thing.
- some were in your system the power wire running the amp is hitting ,ground and blowing the fuse,or your amp is crapped out.are the fuses in the amplifier blowing too.i would hook up another power to to amplifier out in the open and see if your having the same problem.if you do its the amplifier if its all good re run another power wire.with a distribution block and go bigger with the wire size,and you can down size the wire from the distribution block to the amplifier.hope this helps.
1. Manufacturer Overview
Location | Hunan,China |
Year Established | 2004 |
Annual Output Value | Above US$100 Million |
Main Markets | Africa 1.26% Mid East 0.14% Domestic Market 98.60% |
Company Certifications | ISO 9001:2008;ISO 14001:2004;GB/T 28001-2001 |
2. Manufacturer Certificates
a) Certification Name | |
Range | |
Reference | |
Validity Period |
3. Manufacturer Capability
a) Trade Capacity | |
Nearest Port | |
Export Percentage | |
No.of Employees in Trade Department | 6-10 People |
Language Spoken: | English, Chinese |
b) Factory Information | |
Factory Size: | 50,000-100,000 square meters |
No. of Production Lines | Above 10 |
Contract Manufacturing | |
Product Price Range |
Send your message to us
Power Cables for Mining Salt Lake
- Loading Port:
- China Main Port
- Payment Terms:
- TT or LC
- Min Order Qty:
- 100 Meters m
- Supply Capability:
- 6000 Meters per Month m/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches