Signal Cable for railway signal and digital signal transmission
- Ref Price:
-
- Loading Port:
- Shanghai
- Payment Terms:
- TT or LC
- Min Order Qty:
- 100 m
- Supply Capability:
- 100000 m/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Product Introduction:
It is fit for railway signal and digital signal transmission in area of high speed heavy loading electrization or non-electrization railway with rated voltage of A.C 750V and D.C 1100V,and for special fixed laying serial cable of some automatic control device.
Characristics:The DC resistance of the fifth-class tinned flexible cord conductor shall be in accordance with the requirements stipulated in GB/T 3956.2、Burning test: it shall meet the single vertical burning test stipulated in JB/T18380.1; the uncarbonized part shall not be less than 50mm in length.3、Oil-immersed test: after being immersed in the oil solution at 100℃ for 24h, its tensile strength variation shall not be more than 40%, and the variation of its elongation at break shall not be more than 40%
Specification
Type | Designation | Number of core | Standard |
PTYA23 | Copper core PE insulated integrated sheath steel tape armoured PE sheath railway signal cable | 4、6、8、9、12、14、16、19、21、24、28、30、33、37、42、44、48、52、56、61 | TB/T2476 |
PTYL23 | Copper core PE insulated Al sheath steel tape armoured PE outer sheath railway signal cable | ||
SPTYWA23 | Copper core foamed PO insulated integrated sheath steel tape armoured PE sheath railway digital signal cable | TB/T3100 | |
SPTYWL23 | Copper core foamed PO insulated Al sheath steel tape armoured PE outer sheath railway digital signal cable | ||
SPTYWPA23 | Copper core foamed PO insulated integrated sheath steel tape armoured PE outer sheath inner shielding railway digital signal cable | 8B、12A、12B、14A、14B、16A、16B、19A、19B、21A、21B、24A、24B、28A、28B、30A、30B、33A、37A、42A、44A、48A | |
SPTYWPL23 | Copper core foamed PO insulated Al sheath steel tape armoured PE outer sheath inner shielding railway digital signal cable |
Structural figure
Type, specification and Designation
Type | Designation | Number of core | Standard |
PTYA23 | Copper core PE insulated integrated sheath steel tape armoured PE sheath railway signal cable | 4、6、8、9、12、14、16、19、21、24、28、30、33、37、42、44、48、52、56、61 | TB/T2476 |
PTYL23 | Copper core PE insulated Al sheath steel tape armoured PE outer sheath railway signal cable | ||
SPTYWA23 | Copper core foamed PO insulated integrated sheath steel tape armoured PE sheath railway digital signal cable | TB/T3100 | |
SPTYWL23 | Copper core foamed PO insulated Al sheath steel tape armoured PE outer sheath railway digital signal cable | ||
SPTYWPA23 | Copper core foamed PO insulated integrated sheath steel tape armoured PE outer sheath inner shielding railway digital signal cable | 8B、12A、12B、14A、14B、16A、16B、19A、19B、21A、21B、24A、24B、28A、28B、30A、30B、33A、37A、42A、44A、48A | |
SPTYWPL23 | Copper core foamed PO insulated Al sheath steel tape armoured PE outer sheath inner shielding railway digital signal cable |
Technical parameter
1、PTYA23 and PTYL23 Electrical parameter
No | Item | Unit | Value | Conversion formula |
1 | D.C Resistance at 20℃ D.C Resistance of each conductor conductor balance of quad pairs |
Ω/km % |
≤23.5 ≤1.5 |
L/1000 — |
2 | Resistance | MΩ·km | ≥3000 | 1000/L |
3 | nF/km Working capacitance Star quad pairs working capacitance twin pair working capacitance Capacitance between each insulated core and others connected to earth | nF/km |
≤50
≤70 ≤100 | L/1000 |
4 | Capacitance coupling K1 Average value Maxium value | pF/500m |
≤100 ≤330 |
L/500 |
5 | Capacitance imbalance to the earth ea1、ea2 Average value ea1、ea2 Maxium value ea1、ea2 ea1、ea2 means the maxium value for the for core cable | pF/500m |
≤300 ≤1294 | L/500 |
6 | Insulation voltage test 50Hz 2min Between the core Between core and other earth | V |
1000 1800 | — |
- Q:Hey guys, I noticed that with heavy use of the power cord to my laptop, a part of the rubber surrounding the cord is open near the insertion part and you can see the wires. I'm just curious how dangerous it is. I don't have another power cord for my laptop, so do any of you have a recommendation for what I can do?
- The outer layer of laptop power cables below the rubber is the insulating layer. Little risk there. If you want, you can purchase electrical tape from HomeDepot or local electronics store{(probably), and wrap it around the rip.
- Q:Hello guyzz, recently i have bought new card powercolor radeon hd 6770 1gb gddr5 .i installed it but it required a 6 pin power cable forbut i checked in my all pc.i cant fine any 6 pin power cable.so without any cable its not working wat i do plzzz help.
- This is something you should check before you buy the video card. The card may have come with an adapter that plugs into a couple of your ide molex power connectors, and has the 6 pin connector you need on the other side. That might do it for you. Unless you don't have ide power connectors either. Or you can buy a new power supply. If your current power supply isn't big enough to support the new card you may end up buying a new power supply anyway.
- Q:is it possible to run a 2-wire AC power cable (2x2.5mm2 or thicker) from the telephone junction box to the inside of the house instead of using an ordinary thin phone cable? will that affect the voice quality or maybe an ADSL setup? the distance is approximately 50 meters.thanks a lot.
- Two conductors are two conductors, unless there are high-frequency issues. In this case it appears that if you are replacing parallel (not twisted) wires with another set of at least equal thickness, you should be okay. Since ADSL is used on parallel wires, without twisting them, the frequencies conducted should not present problems.
- Q:most double power cable 2900pros need around 550W.
- If okorder / if you havent i would recommend a HD3850 or 3870 as they have similar peformace with about half the power draw
- Q:I have my Clearwire modem but have lost the power cable. Does anyone know what I would look for in a replacement power cable.
- check the Clearwire URL .. Support tab
- Q:So I'm currently living in a dorm room, and my tv is hooked up to the campus cable system. A couple of minutes ago, the power went off and turned back on right away, and I was watching tv during this. Now the power is working but the cable is not, all the channels are nothing but static.I've tried resetting my tv, but I'm wondering what else I could do. Other tvs hooked up to cable in my dorm aren't working either, so is there something wrong with the entire cable system?
- Yes, there has to be a problem in the cable system.
- Q:i have a 2001 corolla with a new amplifier. when they wanted to test the amp after all wiring was done, they somehow wired the amps power cable to my negative connection on the battery. i turned on the electrics on the car and they all work. then i tried starting it, and how the engine wont start and the lights dim when im turning the key. what happened? and how can i fix this major screw up???
- You probably drained the battery down some how or have a bad connections at the battery. try charging the battery. I don't think you could have messed anything up too bad on the car.
- Q:98 dodge intrepid, wanna run power cable through the firewall without drilling a hole.
- run it under the car
- Q:printer is powered on. cables are securely connected. printer has ink and paper. printer installed as network printer on all client computers. other users are able to print to the printer. but printer not working on the other computer
- Check if the other computer has the printer as default. Go to printers and faxes and check from there.
- Q:can i use this to power a pcie x16 card in a pcie x1 slot
- That depends on what you mean by 'power'. You can use it to connect a PCIe x16 card to a PCIe x1 slot but it'll only have one PCIe lane connected, meaning that the interface will only have 1/16th of the bandwidth. That's fine for something like using a graphics card to mine Litecoin but not for gaming. As for powering it, if the card uses a lot of power so has external power connectors like a graphics card then you still need to connect those, if it normally runs without an extra power cable then it'll be fine. You'll notice that most of the reviews there are from people who were building Bitcoin/Litecoin mining rigs. When doing that the graphics cards are working flat out but there's not a lot of data being sent through the interface so a x1 interface is fine, when gaming the interface has to carry a lot more information so this would really slow it down. It would be fine for just providing a way to plug in a cheap graphics card to provide a second display for normal 2D use though but its 3D performance would suffer.
1. Manufacturer Overview |
|
|---|---|
| Location | |
| Year Established | |
| Annual Output Value | |
| Main Markets | |
| Company Certifications | |
2. Manufacturer Certificates |
|
|---|---|
| a) Certification Name | |
| Range | |
| Reference | |
| Validity Period | |
3. Manufacturer Capability |
|
|---|---|
| a)Trade Capacity | |
| Nearest Port | |
| Export Percentage | |
| No.of Employees in Trade Department | |
| Language Spoken: | |
| b)Factory Information | |
| Factory Size: | |
| No. of Production Lines | |
| Contract Manufacturing | |
| Product Price Range | |
Send your message to us
Signal Cable for railway signal and digital signal transmission
- Ref Price:
-
- Loading Port:
- Shanghai
- Payment Terms:
- TT or LC
- Min Order Qty:
- 100 m
- Supply Capability:
- 100000 m/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords
