Double Side Aluminium Foil Scrim Kraft Lamination Sheet - Roofing Insulation Products Redding CA
- Loading Port:
- China Main Port
- Payment Terms:
- TT OR LC
- Min Order Qty:
- -
- Supply Capability:
- -
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
1 Description:
DFC1001 double sided reflective laminate aluminum foil serves as thermal insulation and sharking membrane underneath roof and wall cladding. Combined with bulk insulation, form very effective thermal barrier and excellent vapor barrier for air conditioning ducting and preformed bulk insulation section for hot and chilled water pipes.
2. Application & Benefit:
Double-sided insulation is more effective and durable compared to the single-sided insulation, suit to insulate radiation caused by equipment like transformer signal station, it also be used for roof, wall and building insulation and also could be applied as facing onto rock wool, glass wool, plain slab, ceiling board, ducting air conditioning, or pipe section.
6. DFM1001Aluminum Foil and Mylar Film Laminated to Kraft Paper Reinforced by Scrim 高档铝箔夹筋
Structure like Sandwich it is multi-layered materials, fiberglass scrim for reinforce tensile strength. High quality kraft paper for mechanical strength. All layers is formed and laminated with Polyethylene or fire retardant adhesive.
Model No. | Construction | Weight |
DC1001 | Foil / Scrim / Adhesive / Foil | 97g |
DFC1001 | Foil / Scrim / Adhesive / Kraft / Adhesive / Foil | 117g |
DM1001 | Film / Scrim / Adhesive / Film | 50g |
DFM101 | Foil / Scrim / Adhesive / Kraft / Adhesive / Film | 117g |
FG703 | Film / Scrim / Adhesive / Kraft / Adhesive / Film | 126g |
Model No. in above table looks strange because of history please do not mind.
- Q:p/t deck on a commercial rubber roof do we need closed cell insulation under deck to protect rubber?
- You don't need it to protect the rubberoid roof however considering the relatively low cost of the closed cell foam it would be cheap insurance to add it. A more pressing concern would be the drainage details.
- Q:What's better- to lay out roof insulation in an old house or to get it blown in?
- anybody can do either.nothing to it.i prefer blown, because it isnt near as itchy.you can rent the blower from home stores, but it takes 2 people to run.
- Q:I am building a porch roof over an existing patio. The rafters are fabricated I-beams. I plan on putting aluminum soffit under the I-beams. On top of the roof I would like to put down a metal roof. I already put down 3/4" OSB and a rain/ice barrier. Do I need insulation and/or ventilation on top of the rain and ice barrier, or can I get away without it?
- You don't need insulation for this application. If you haven't purchased the metal yet I would recommend looking for a standing seam roof system that the panel does not come in contact with the substrate and does not use exposed fasteners. If in the future you did decide to enclose the porch and add heat you could insulate the ceiling and leave an air space under the decking that could be ventilated from the eave to the ridge. A cold roof assembly with proper ventilation will dramatically reduce the potential of the metal panels sweating.
- Q:So I'm renovating an old farmhouse with a metal roof and there is no insulation in the attic. I was up in the attic checking for leaks since we just got some freezing rain and it is currently melting I thought now was the perfect time to check. I found no leaks but I did notice the roof was sweating with noticeable beads of water in many places and many of the 2x4's that act as the frame were damp, although none were rotted (I found that odd as the house is approx. 140 years old and those are the original 2x4's. I could tell that the attic does have vents so I guess it dries out before rotting or mold occurs.. but makes me wonder if I put down some roll-in faced R-30 Owens Corning Insulation and then add a plywood floor over top if everything will be fine.. or not so fine..
- Is the attic floor completely uninsulated now? You need a single layer of vapor barrier between the living space and the attic space. This is often done with faced insulation rolls. A vapor barrier between the living space ceiling and your new insulation may be enough all by itself to prevent the condensation from forming. If there's existing insulation, you'll have to pull some up to check for a vapor barrier. If there's already a vapor barrier, you can add unfaced insulation. Never put in two vapor barriers with insulation between them.
- Q:what action should a plumber take?????
- struggling to understand your question! are you talking about a storage tank? what is the problem with the insulation? if it is in the way move it but insulation under a tank is not a problem the tank will need to be insulated any way!
- Q:I have a vented metal roof. WV winters
- Check into heat tape tied to pipe, with insulation wrapped around that. turns on when freezing temperatures. insulation by itself, will not stop it from freezing if left for long periods without water moving through it. .
- Q:were can i buy material to insulate pans and instructions to install it? I have seen many roofs with this done ,but , the lowe,s and home depots don't have .
- you do now not desire insulation for this application. in case you have now not offered the metallic yet i might advise searching for a status seam roof equipment that the panel would not are available touch with the substrate and would not use uncovered fasteners. If contained sooner or later you probably did be certain to surround the porch and upload warmth you ought to insulate the ceiling and depart an air area below the decking that ought to be ventilated from the eave to the ridge. a chilly roof assembly with proper air flow will dramatically cut back the flexibility of the metallic panels sweating.
- Q:Are black concrete roof tiles for my house uncomfortably hot even with roof under sheeting and insulation?
- If you sit on them, they will be uncomfortable on a hot sunny day. If you mean in the house, the "under sheeting" or radiant barrier should deflect much of the heat from the roof, and keep your house easy to cool.
- Q:i have about 200 sq ft of odd shaped polystyrene foam (rigid) insulation between 3" and 5" thick. it's leftover from installing a flat roof on a commercial building. creative ideas anyone? grind it and use it as attic insulation in a home?thanks.
- I'm a bit confused here Andy. If the flat roof needs replacing, when it is removed what is revealed is going to be exactly what you would see if you removed the ceilings. So why consider removing the ceilings if they are ok? When the flat roof is replaced put the insulation in then. Whilst rockwool would have been the material to use there is now roofing insulation board that is much more efficient, 50mm board gives equivalent insulation of something like 150mm rockwool. If the flatroof isn't fitted with suitable vents to keep it ventilated fit them when the roof is done too. The only reason I can see for replacing the ceiling plasterboard is if it hasn't got a vapor barrier ie foil backed board.
- Q:We had a water leak in our pipes in our foundation and had to re-route our pipes along our roof. We have tried some really basic insulation for piping, but it usually deteriorates very quickly due to sun light and wind. What are some ways we can insulate our pipes effectively without having to re-insulate every month? This has to be something fairly simple and inexpensive. We aren't looking for perfect insulation, just something that will keep the water warm in the winter and cool in the summer.
- Contact a local remodeling contractor and install the new piping system properly. Even a system under a foundation can be repaired, but it is not cheap to do it.
1. Manufacturer Overview |
|
---|---|
Location | |
Year Established | |
Annual Output Value | |
Main Markets | |
Company Certifications |
2. Manufacturer Certificates |
|
---|---|
a) Certification Name | |
Range | |
Reference | |
Validity Period |
3. Manufacturer Capability |
|
---|---|
a)Trade Capacity | |
Nearest Port | |
Export Percentage | |
No.of Employees in Trade Department | |
Language Spoken: | |
b)Factory Information | |
Factory Size: | |
No. of Production Lines | |
Contract Manufacturing | |
Product Price Range |
Send your message to us
Double Side Aluminium Foil Scrim Kraft Lamination Sheet - Roofing Insulation Products Redding CA
- Loading Port:
- China Main Port
- Payment Terms:
- TT OR LC
- Min Order Qty:
- -
- Supply Capability:
- -
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords