Extra-clean XLPE Compound for 35KV and Below Power Cable

Ref Price:

Loading Port:: Shanghai

Payment Terms:: TT OR LC

Min Order Qty:: -

Supply Capability:: 1000000kgs kg/month

Inquire Now

Add to My Favorites

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

You Might Also Like

Shield Cable HS-47

WIRING DUCT 94-V-2

Cable Tray Z275

Cable Conductor HS127

Shielding Copper Foil for cable making

Solar PV Cable(photovoltaic cable)

ACCC Conductor -Low Price and Good Quality

ACCC Helsinki

Main Properties & Typical Values

Test Items	Unit	Test Method	Standard	Typical value
Tensile strength	MPa	GB/T1040.3	≥13.5	25.9
Elongation at break	%	GB/T1040.3	≥350	537
Heat ageing properties (Test temperature 135℃, 168hr) Maximum tensile strength change Maximum elongation at break change	% %	GB/T8815	±20 ±20	10 0
Heat elongation （200±3)℃x15minx0.2MPa) Maximum elongation change under load Maximum permanent elongation change after cooled	% %	GB/T2951	≤80 ≤5	46 0
Impact brittle temp. (-76℃) Impact brittle	Failure no.	GB/T5470	≤15/30	pass
Dielectric Strength	MV/m	GB/T1408.1	≥25	39
Dielectric loss factor 50Hz, 20℃	--	GB/T1409	≤5×10^-4	2×10^-4
Dielectric constant 50Hz, 20℃	--	GB/T1409	≤2.35	2.10
Volume resistance (20℃)	Ω·m	GB/T1410	≥1×10¹⁴	2.4×10¹⁴
Gel content	%	JB/T10437	≥80	86
Moisture content	μg/g	Q/GHPX6	≤200	100

Note: All typical values were tested by press moulding sample under the condition of 180±2 ℃,15min, and pressure over 15Mpa, then cooling to room temperature

Referring to the JB/T10437-2004 standard, the company standard specified that in every 1kg sample of grade 4205EC-35, the impurities with diameter 0.175 ~ 0.250mm must not be more than 5 pieces, the impurities with diameter more than 0.250mm must be zero.

We have strict control over the raw material of product grade 4205EC-35, which has been produced under purified environment. The typical value of product impurity content is:

Particle diameter (mm) No. of particle

0.175-0.25 2

>0.25 0

Q: Four lines only reached a phase line, at the other end all charged, I use the digital pen! In addition, I often check the cable when the cable current through the dot digital pen voltage symbols sometimes have time to disappear, in other bare wires when the test keys are normal! What is this going on! Ask the heroes to give the younger brother a complete point of the answer! More: Bookstore tool book should have "communication project budget", I do is what you say, the budget is divided into estimates and budget, is two steps. So that is not very clear. But what is needed is the preliminary design of the project. The budget is needed for design and drawings. Internal management of this piece, the main thing is that you need to do what the project department, and are generally very complicated

Q: What brand of cable is good, what are the top ten brands of wires?: If you are talking about the three-core wire, black - ground brown - line of blue - zero line. If it is 3 plugs, your wire is only 2 lines. Then the yellow received L, black received N. The above is the ground wire.

Q: Apple phone display cable or accessories not certified how to do: Reply 3 # shops always have the door, and the door must be adjacent to the outdoor channel. Outdoor channel is public space! So the shop should be able to find the wiring channel. You have not encountered the situation, the map stickers out to see it?

Q: Ipad not charge how the matter. Said the cable or accessories have not been certified, and may not be able to cooperate with this ipad reliable work....: According to the "Power Engineering Cable Design Code" GB-. 5.3.3 only asked for the depth of the cable buried directly: drop the blue skin to the ground depth, not less than 0.7 meters; when located in the roadway or farmland Under the appropriate should be deepened, and should not be less than 1.0 meters. 5.4.3 protected pipe buried in the ground, should meet the requirements under the depth of the pressure and environmental corrosion resistance. Through the uneven settlement of the backfill section and other places to increase the force, it is appropriate to use steel. Another direct burial should be selected armor type.

Q: Decoration when the purchase of water pipes, wires and other items included in the account: A lot of ways ah! You look at the back of the set-top box, a total of three kinds of interfaces, namely, HDMI digital signal (while transmitting audio and video signals), red and yellow and yellow chicken complex habit of glycosylation moxibustion slim faint handle (red is the right channel, white Is the left channel, the yellow is the video), the color difference signal (red, green and blue, only transmission video), S terminal (single hole four pin, only transmission video). You just put the video to the TV, the audio to the amplifier on the line. . if your amplifier does not have HDMI interface, then put the set-top box HDMI connected to the TV, the set-top box red and white two terminals, connected to the amplifier red and white input terminal, and adjust the amplifier to the appropriate channel The . if your amplifier has HDMI interface, then through the HDMI series on the line, the first amplifier or the first TV will do. . TV set after a lot of them, there is a group of AVOUT output interface, this group of red and white terminals connected to the power amplifier is also OK.

Q: Apple 6 Charging Why always show this cable has not yet been certified: Set-top box with the AV cable connection: yellow - video, red and white - audio, corresponding to the TV's AV input interface can be connected (do not receive the TV component interface). As for the emergence of partial pink, the possible reasons are: . poor contact. You will re-connect the three-color AV cable to the set-top box, on the TV, to ensure good contact. . cable quality. Three-color AV cable may not be the quality, if you can replace a group of try, or use the DVD and other equipment connected with the TV to test the AV line with or without problems. . TV AV input failure. You can use other video source equipment connected to the TV test, such as: DVD, VCD machines and so on. . set-top box failure. May be set-top box AV output port problems, if there are multiple sets of AV output, you can try other port okay, not the case may be the quality of set-top box, call customer service it.

Q: Wire and cable model ZD what does it mean: Wire pipe water problem: In fact, this problem is very serious, then this line should be scrapped or replaced, if you continue to reluctantly use not only to bring you the safety of trouble and the insulation of the wire dropped sharply! Because there is water it will lead to internal leakage can also make the wire heat caused by wire burning and trivial trivial accident, so be sure to take the necessary replacement! Supplement: the wire out of all, with the wire to grab the absorbent gauze and the like back to the twitching, many times for the gauze to dry the water, hair dryer toward the tube to heat the tube to dry and then re-layout of the new line.

Q: Why does the bird stand on the wire without anything, but if people touch it,: Is not the home of the bus box? Generally put a cat, a router, a power outlet, two transformers, the other is the network cable and telephone, the key space to be enough

Q: This cable or accessory has not been certified and may not be able to work with this iphone reliably: The installation process is a certain requirement, high and low voltage cable bridge should be installed separately as usual, a wall laying vertical pipeline (slot) or installation equipment, the power distribution between the depth of D1 = 1200 ~ 1500mm; weak Between the deep distance from the D2 = 1100 ~ 1400mm more reasonable. The length L1 and L2 between the power distribution and the weak can be determined according to how much electrical equipment and pipelines (slots) are installed in the room. "Civil building electrical design specifications" proposed "shaft size in addition to meet the wiring spacing and terminal box, distribution box layout must be the size, but also in the box before the left not less than 0.8m operation, maintenance distance" requirements. In the weak equipment, the operation and maintenance distance is not specified in the provisions of the Code for Electrical Design of Civil Buildings, but it should not be less than 0.8m. Cable to wear steel pipe wiring, should be reserved in the floor steel pipe, wiring should be completed after the plug fire fire blocking material. Cable bridge installation should be horizontal, the maximum sag should not be greater than 10 mm; proposed separate installation

Q: If you want to sell wire and cable, then what to do in advance to detect? The The The The The: Wire diameter, conductor resistance, insulation diameter, the thickness of the thinnest insulation,

Send your message to us

*Email

*TEL

*Quantity

*Unit