Ductile cast iron manhole cover B125

Inquire Now

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

Manhole covers
1) Dimensions standard: EN124
2) Material: grey iron, ductile iron
3) Size:many kinds as shown in our cata

Manhole covers:

1) Dimensions standard: EN124

2) Material: grey iron, ductile iron

3) Size:many kinds as shown in our catalogue

4)package: plywood cases, plywood pallets

Q: What is the ejection angle of the die casting (Tan Gang)?: Because after the wax, wax parts will have a slight contraction, which is good for demoulding. Many moulds don't do the ejection angle

Q: Domestic large steel castings factory which is better, recommend!: At least spend money on research and development, then the quality should be all right.

Q: How to get rid of casting sand inside casting parts?: Are you saying that in the sand casting cavity? We use the manual blast, he is like a pipe will be automatic shot out of the grit, into the casting cavity, to remove the internal cavity in the purpose of casting sand!

Q: What is the difference between forging parts and casting parts?: No, it's called die castingDifference: the die casting parts are simple in structure and large in batch sizeCasting: the use of a wide range of structures without restrictions

Q: Selection of hydraulic press is the casting parts and steel plate welding, how to choose?: Casting parts in one shape, the overall processing in this regard than steel plate welding better. The same price is much more expensive than steel. Large hydraulic presses seldom have casting parts.

Q: How do you mark it on the drawing? Do you need to discuss it with the manufacturer?Because the casting allowance is the standard, then, after all, is the theoretical value, the actual level depends on the manufacturer, so is it necessary to ask the manufacturer?: The general foundry casting technology division will mark put shrinkage and the allowance of the map in your chart (usually with the red pen) for the production of wood or other material wood workers die drawings.

Q: Cause of choking of casting parts: The reason is not in the coated sand, see coating gas evolution, the best use of zircon powder coating (low gas evolution), there is a mold according to a vent needle, this depends on your way is flat or vertical pouring pouring pouring, if vertical pouring, venting pin on the die, and the big piece how could the plane, pouring water flat, a breath, a taboo ah!

Q: Where is the precision casting factory?: The National Precision Casting Factory is generally distributed in Shandong, Ji'nan, Jiangsu, Wuxi, Changzhou, Zhejiang, Guangdong, Panyu, Dongguan.The above are only the main distribution, many of Shandong are made supercharger, and Guangdong to jewelry industry based.

Q: Can the casting part be phosphating with the phosphating solution of the pickling board?: Phosphating. But it's not necessary. Because casting parts have strong corrosion resistance.

Q: ZGMn13 casting parts processing, with what knife head good?: The ZGMn13 itself is not have processing, if only the processing point, sharpening, ordinary can, if the processing area is relatively large, ZGMn13 external impact load is bigger, its surface wear resistance is high; the two is with the gradual wear of surface hardening, the hardening layer is continuously formed new if you have suggestions, processing, plasma cutting or flame cutting try

Send your message to us

*Email

*TEL

*Quantity

*Unit