Solar Monocrystalline (210W-225W)

Introduction of Solar Monocrystalline (210W-225W)

Solar modules use light energy (photons) from the sun to generate electricity through the photovoltaic effect. The majority of modules use wafer-based crystalline silicon cells or thin-film cells based on cadmium telluride or silicon. The structural (load carrying) member of a module can either be the top layer or the back layer. Cells must also be protected from mechanical damage and moisture. Most solar modules are rigid, but semi-flexible ones are available, based on thin-film cells. These early solar modules were first used in space in 1958.

CNBM Solar photovoltaic (PV) Panel is designed for large electrical power requirements. It is the optimal choice for both on-grid and off-grid power systems. CNBM Solar panel offers high performance of power per square foot of solar array. Monocrystalline silicon(c-Si): often made using the Czochralski process. Single-crystal wafer cells tend to be expensive, and because they are cut from cylindrical ingots, do not completely cover a square solar cell module without a substantial waste of refined silicon. Hence most c-Si panels have uncovered gaps at the four corners of the cells.

Characteristics of Solar Monocrystalline (210W-225W)

I. Solar Cell : High efficiency crystalline solar cell. Even if under the weak light, the solar module can produce maximum power output.

II. Tempered glass (toughened glass): Anti-reflecting coating and high transmission rate glass increase the power output and mechanical strength of solar module.

III. EVA and TPT: Using high quality EVA and TPT to prevent destroying and water.

IV. AI frame: Without screw, corner connection. 6 holes on the frame can be installed easily.

V. Junction box: Multi function junction box with water proof.

VI. Long lifetime: ≥25 years; Less power decrease.

VII. Good performance of preventing from atrocious weather such as wind and hails.

VIII. Resisting moisture and etching effectively, not effected by geology.

IX. The certificate issued by international authority: UL, TUV, IEC, VDE, CE.

Standard Test Conditions of Solar Monocrystalline (210W-225W)

The opto-electrical specifications shown below are stabilized values being measured at Standard Test Conditions, Irradiance: 1000W/m2, Spectrum: AM1.5 at 25°C, The info below is subject to manufacturing tolerances. Where appropriate minutes of measurement are available and are used for the dimensioning of the installation.

Advantages of Solar Monocrystalline (210W-225W)

• CNBM Solar performance guarantees for 25 years

• 10 years guarantee for workmanship

• Timeliness of delivery

• Quality Products certified (TÜV, UL, CE, VDE, ISO)

CNBM International Corporation's products including Monocrystalline Solar Panel, Polycrystalline Solar Panel have received and enjoyed famous reputation in many countries and regions in the world .As a solar panel manufacturer in China, we strive to provide our customers with excellent service, superior products and unmatched value.