Texas Solar Panels - Solar Monocrystalline (175w-195w)
- Loading Port:
- Shanghai
- Payment Terms:
- TT
- Min Order Qty:
- 1 pcs pc
- Supply Capability:
- 100000/month pc/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Solar Monocrystalline (185W-195W)
Introduction of Solar Monocrystalline (185W-195W)
A solar panel is a set of solar photovoltaic modules electrically connected and mounted on a supporting structure. A photovoltaic module is a packaged, connected assembly of solar cells. The solar module can be used as a component of a larger photovoltaic system to generate and supply electricity in commercial and residential applications.
CNBM Solar photovoltaic (PV) Panel is designed for large electrical power requirements. It is the optimal choice for both on-grid and off-grid power systems. CNBM Solar panel offers high performance of power per square foot of solar array. Monocrystalline silicon(c-Si): often made using the Czochralski process. Single-crystal wafer cells tend to be expensive, and because they are cut from cylindrical ingots, do not completely cover a square solar cell module without a substantial waste of refined silicon. Hence most c-Si panels have uncovered gaps at the four corners of the cells.
Characteristics of Solar Monocrystalline (185W-195W)
I. Solar Cell : High efficiency crystalline solar cell. Even if under the weak light, the solar module can produce maximum power output.
II. Tempered glass (toughened glass): Anti-reflecting coating and high transmission rate glass increase the power output and mechanical strength of solar module.
III. EVA and TPT: Using high quality EVA and TPT to prevent destroying and water.
IV. AI frame: Without screw, corner connection. 6 holes on the frame can be installed easily.
V. Junction box: Multi function junction box with water proof.
VI. Long lifetime: ≥25 years; Less power decrease.
VII. Good performance of preventing from atrocious weather such as wind and hails.
VIII. Resisting moisture and etching effectively, not effected by geology.
IX. The certificate issued by international authority: UL, TUV, IEC, VDE, CE.
Standard Test Conditions of Solar Monocrystalline (185W-195W)
The opto-electrical specifications shown below are stabilized values being measured at Standard Test Conditions, Irradiance: 1000W/m2, Spectrum: AM1.5 at 25°C, The info below is subject to manufacturing tolerances. Where appropriate minutes of measurement are available and are used for the dimensioning of the installation.
Advantages of Monocrystalline Silicon Solar Panel
• CNBM Solar performance guarantees for 25 years
• 12 years guarantee for workmanship
• Timeliness of delivery
• Quality Products certified (TÜV, UL, CE, VDE, ISO)
CNBM International Corporation's products including Monocrystalline Solar Panel, Polycrystalline Solar Panel have received and enjoyed famous reputation in many countries and regions in the world .As a solar panel manufacturer in China, we strive to provide our customers with excellent service, superior products and unmatched value.
Technical Data
Characteristics of Solar Monocrystalline (185W-195W)
Max Power Voltage Vmp (V) | 36.27V | 36.5V | 36.75V |
Max Power Current Imp (A) | 5.1A | 5.2A | 5.31A |
Open Circuit Voltage Voc (V) | 45V | 45.2V | 45.4V |
Short Circuit Current Isc (A) | 5.5A | 5.6A | 5.7A |
Max Power Pm (W) | 185W | 190W | 195W |
Temperature Coefficient of Cells
NOCT | 47℃±2℃ |
Temperature Coefficients of Isc (%/℃) | 0.0981 |
Temperature Coefficients of Voc (%/℃) | -0.5186 |
Temperature Coefficients of Pmp (%/℃) | -0.4601 |
Mechanical Data of Solar Monocrystalline (185W-195W)
Dimension | 1580×808×40mm |
Weight | 15.5kg |
Tolerance | 0~+5W |
The dimension of the modules can be changed according to the demand of clients
Limits of Solar Monocrystalline (185W-195W)
Operating Temperature | –40 °C to +85°C |
Storage Temperature | –40 °C to +85°C |
Max System Voltage | 1000VDC(IEC)/600VDC(UL) |
Guarantee of Solar Monocrystalline (185W-195W)
Products Guarantee | 12 yrs free from defects in materials and workmanship |
Performance Guarantee | No less than 90% within 10yrs and no less than 80% within 20yrs |
Certificates | IEC, ISO, TUV, CE |
The Pakage of Solar Monocrystalline (185W-195W)
The Production Line of Solar Monocrystalline (185W-195W)
- Q: Can solar panels be used to power a factory?
- Yes, solar panels can be used to power a factory. By installing a sufficient number of solar panels on the factory's premises, the factory can generate enough renewable energy to meet its power requirements. This can help reduce reliance on traditional power sources and contribute to a more sustainable and eco-friendly operation.
- Q: How do solar panels affect the electricity bill?
- Solar panels can significantly reduce or even eliminate electricity bills by generating renewable energy from the sun, thereby reducing the reliance on grid-supplied electricity. When solar panels produce more energy than is consumed, excess energy can be fed back into the grid, resulting in credits or reducing future bills through net metering programs.
- Q: Can I install my 2v solar panel straight to battery to charge the battery on my 989 ford ranger?
- You would need a inverter which transfer AC to DC. then you can connect it to your battery. You also have to check is your battery able to take energy coming from inverter. This might be little but tricky. Check the energy output and battery Voltage before testing.
- Q: I have a small marine solar panel on my boat It came with the boat. I want to make sure it is working before I connect it. With a volt meter It is only reading .2 volts dc. I would think it should be 2-5 volts?
- It has to be facing the sun for full power U check at the battery and it should increase as the sun hits directly on it. U can't check it at the panel after the diode.
- Q: Mono-crystalline or poly-crystalline solar panel?
- All solar photovoltaics drop in efficiencies with higher temperatures but it isn't the 45+ C you have to worry about but rather the heat from the sunlight striking the panels. There are hybrid systems which passes water in pipes attached to the back of the solar panels to cool the panels and preheat the water for solar thermal collectors. The difference between mono-crystalline and poly-crystalline are that mono-crystalline are more efficient and more costly to make.
- Q: I have a cabin in the woods and need more light. I do have enough sun but I was wondering how or where do I get a solar panel to lead to a power outlet? In a perfect world I would like to get a solar panel with a connecting wire to an outlet or something so I could power a small TV. I know its hard enough but can I get that pre-made? Or even lastly should I look at wind power consider I would like this to be under $500? Thank you for putting up with this bundle of questions.
- A typical solar panel will deliver 50 watts of power in the form of 24 volts DC. You need 20 volts AC. So here is what it takes: Since you will need at least 200 watts to do a small TV, you need four solar panels, and a solar controller. Then you need a 24 volt solar type battery to load the output of the panels. Next you need an inverter. This is a device that changes 24 volts DC into 20 volts AC, which you can wire to a standard outlet for the TV set. Solar panels cost around $6 per watt of power. 200 X $6 = $200 Solar Controller will cost around $50 The battery will cost around $00 The inverter will cost around $200 You could get by with less than 200 watts of solar panels if you just let it charge the battery all day and only use the TV for an hour or two in the evening with the TV running on the inverter which is powered by the battery. The link is for a similar system ready to go. Wind is not a viable option.
- Q: How do solar panels affect the insurance premiums of a home?
- Solar panels can potentially affect the insurance premiums of a home in a positive way. While the upfront cost of installing solar panels may increase the overall value of the property, insurance companies often view solar panels as a risk-reducing feature. This is because they can decrease the home's reliance on traditional energy sources and potentially lower the risk of fire or electrical damage. As a result, homeowners may be eligible for certain insurance discounts or reduced premiums, depending on the insurance provider and policy.
- Q: My Grandfather just purchased a cheap solar panel kit for his ranch that could not muster enough power to run his mini fridge.He has two 6 volt batteries running positive to negative and would like to add more batteries. Probably 2volt. How would he go about hooking up the other batteries and what kind of wire or coil should he use.Also, I saw on youtube a guy recommending a lead-acid battery from walmart for under $20. I was just going to go to ecology and just pick up some used batteries but I may be wrong.Any help for a first timer might help me and my gramps out will be appreciated.Thank you
- If he is going to be running off batteries at night, he would be better off with traction batteries. Traction batteries are true deep cycle and can better withstand deep discharge. Golf cart batteries at Sam's Club (the other half of Walmart) are traction batteries. If your grandfather needs safe refrigeration, a mini fridge won't do it. A 0 fridge takes too much power to run off solar panels and most won't hold their cold very well if unplugged for long. I run a fridge off grid with hybrid deep cycle marine starting batteries. It's an Engel 40. The price has gone up over $00 since I bought mine. It's a real fridge with a compressor and freon 34a. But it runs on 2v dc or 0vac and only uses 36 watts running because of a special compressor design. It will freeze food if you turn the dial down to 2 out of 5. It can also deep freeze. I use mine to keep eggs, milk, cheese and fruit juice. Your grandfather would need 400 amp-hours name plate rating of batteries at 2v to run the Engel, and probably 00 real watts of panels to recharge his battery bank. The Harbor Freight 45 watt panel set only puts out 30 watts on a clear cool day. That won't do it.
- Q: i am very much interested in making a solar panel, my problem is where i can acquire the main components in order to build it, i am staying here in abu dhabi UAE i'm always searching on the internet for shops that can provide me a DIY kit but i did not find one, i need somebody who knows where i can get these things, please let me know.
- Build okorder
- Q: hey so im doing this project for my technology class and i was wondering what different colours solar panels can be. also is it possible to have kentic power as a back up power if batteries dont work? thx in advance
- Panels can come in a selection of colors, and trimmed in a variety of frames. Most are dark, black, blue or reddish in hue. Concentrators may appear white from a distance. Kinetic back up is possible in the form of a flywheel. Not very common but it is out there. Another form of kinetic backup that is used by some power companies is hydro. When the sun is out and the system is producing more than is used, the excess can be used to pump water uphill to a holding tank. Then when there is a demand, the water is allowed to flow back down turning a turbine to generate electricity.
Send your message to us
Texas Solar Panels - Solar Monocrystalline (175w-195w)
- Loading Port:
- Shanghai
- Payment Terms:
- TT
- Min Order Qty:
- 1 pcs pc
- Supply Capability:
- 100000/month pc/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords