Unique Design Temperature Control Colour Changing Led Bath Faucets Brass Body With Zinc Alloy Handle
- Loading Port:
- Shenzhen
- Payment Terms:
- TT
- Min Order Qty:
- 200Pcs PCS
- Supply Capability:
- 1000Pcs Per Month PCS/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Product Description:brass body with Zinc alloy handle,Ceramic cartridge,Chromium plated:0.25um, Nickel plated:8um,with two 60CM flex hoses & fastening piece, battery,voltage supply:4*1.5V AA batteries, LED color changes with water temperature
Carton Size:60.5*44*45.5cm
Carton Inch Size:23.82"*17.33"*17.92"
About Product:1.Built-in LED light.
2. LED Power Source: a)4*1.5V AA batteries voltage supply, low power consumption; b)"by water flow, described as "hydropower" in the Specification.
3.LED color: Red, Green, Blue.
4. All necessary installation accessories included.
5.Built-In durable ceramic valves ensure no water leakage.
6.Laboratory tested for up to 600,000 life cycles at 90 degrees.
7.Laboratory tested to withstand high water pressure of 1.7MPA.
8. 2 years warranty.
- Q:How to disassemble the basin upright faucet
- Even with the washbasin demolished, or bad change for the lead
- Q:I removed the faucet assembly from the bathroom sink/basin to replace it with a new one and it's completely yellowed underneath. It's not as bad as it was after I tried to clean it with the rubbing compound I would use on my car but still not gone.I have to get it all cleaned away because the new one is not the same shape at the base as the old one.Anyone here had experience with this and know the best stuff to use?
- Chances are its from the pipe dope or plumbers putty that was used. Treat it like a greasy stain and use some baking soda, some cleaner like Greased Lightening or Blue Wolf. You can also try putting some hydrogen peroxide on it over night and covered with a rag or some plastic if its not granite or marble. Should clean up fine then. Good luck!
- Q:I had new sink with faucet installed and think the faucet is too small since it is not over the drain. Kindly advise...
- as long as the water goes into the basin, what is the difference?
- Q:How to replace the basin hot and cold faucet hose
- And then connect the hot and cold water pipes, then wrench with a wrench, the water open, in the basin below the toilet paper or napkin to see if the water leakage, to determine the water leakage and then fixed a good head.
- Q:how do i remove the faucet from the delta 1400 series faucet?
- After turning off the water and disconnecting the water lines there are two PVC or metal nuts underneath (under the sink) the hot and cold water valves that once removed will free the faucet from the sink.
- Q:American Standard 3-hole double basin basin faucet how to install
- Outlet: the length of 121 mm "C" type outlet, handle: the word ceramic handle, faucet body: cast copper body, spool: ceramic spool, bubbler: √, water components: metal pull drainage group, Mounting components: fasteners, screws, plugs, gaskets
- Q:Basin faucet size how much more appropriate?
- It is best to buy matching
- Q:Wash basin when the faucet is very heavy, how is it going
- If it is a new dress should sink points, with a long time will be good, if used for a period of Shen, that the leading fast out of the problem
- Q:Floor of the tub leading a change to the shower is not the water from the edge of the basin basin faucet out of the big is how the situation ah
- Another friend is talking about the pull switch (traditional switch), if not the kind of picture is similar to the two or third gear
- Q:I purchased a new faucet with sprayer. Currently I have a faucet but no sprayer.next to where the sprayer should go, there is a overflow for my dishwasher. Do I need to drill another hole or do I need to do something with the overflow ?
- You will need to drill another hole. The overflow you mentioned is called an Air-gap. It prevents the dishwasher drain from pulling a vacuum on the sink drain. They were required in some areas but now are being omitted from some codes.
1. Manufacturer Overview |
|
---|---|
Location | Kaiping,Guangdong |
Year Established | 2004 |
Annual Output Value | Above RMB5 Million |
Main Markets | Europe and the United States, Australia |
Company Certifications |
2. Manufacturer Certificates |
|
---|---|
a) Certification Name | |
Range | |
Reference | |
Validity Period |
3. Manufacturer Capability |
|
---|---|
a)Trade Capacity | |
Nearest Port | Guangzhou |
Export Percentage | |
No.of Employees in Trade Department | 4 People |
Language Spoken: | English;Chinese; |
b)Factory Information | |
Factory Size: | Above 3000 square meters |
No. of Production Lines | 2 |
Contract Manufacturing | OEM Service Offered;Design Service Offered |
Product Price Range | Average |
Send your message to us
Unique Design Temperature Control Colour Changing Led Bath Faucets Brass Body With Zinc Alloy Handle
- Loading Port:
- Shenzhen
- Payment Terms:
- TT
- Min Order Qty:
- 200Pcs PCS
- Supply Capability:
- 1000Pcs Per Month PCS/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords