Unique Design Temperature Control Colour Changing Led Bath Faucets Brass Basin Mixer
- Loading Port:
- Shenzhen
- Payment Terms:
- TT
- Min Order Qty:
- 200Pcs PCS
- Supply Capability:
- 1000Pcs Per Month PCS/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Product Description:brass body with Zinc alloy handle,Ceramic cartridge,Chromium plated:0.25um, Nickel plated:8um,with two 60CM flex hoses & fastening piece, battery,voltage supply:4*1.5V AA batteries , LED color changes with water temperature
Carton Size:60.5*44*45.5cm
About Product:1.Built-in LED light.
2. LED Power Source: a)4*1.5V AA batteries voltage supply, low power consumption; b)"by water flow, described as "hydropower" in the Specification.
3.LED color: Red, Green, Blue.
4. All necessary installation accessories included.
5.Built-In durable ceramic valves ensure no water leakage.
6.Laboratory tested for up to 600,000 life cycles at 90 degrees.
7.Laboratory tested to withstand high water pressure of 1.7MPA.
8. 2 years warranty.
- Q:What are the models of faucet specifications? How to identify the faucet is good or bad?
- The standard washbasin's mouthpiece is the M24 specification. The faucet of the dish is M22, and the connector is not the same. Non-standard products on the free.
- Q:He won't drink from a bowl of still water or a small fountain with running water, even when the water is fresh. He only drinks water from a running faucet, or from knocking over a cup of water and drinking it from the ground. My concern is whether he is getting enough water, because I only turn on the faucet a couple of times each day for him.
- same with my dog i am getting worried
- Q:The position of the leading hole in the basin
- Look at what kind of pots and faucets you buy. The principle of opening the faucet dripping dripping in the basin, the water can not be sprayed to the largest basin. But also with the smooth.
- Q:What is the size of the platform basin?
- The center of the faucet hole can fit the faucet above the wall of 5.5CM. Basin to choose the width of 40 or so, because your total width is 55CM, minus the faucet 9CM, if there are storage shelves of the door but also minus 4-5CM, the remaining width is running out. I suggest you put the pot into the basin basin, just pull the two on the table under the 5CM or so small hole (a hole into a hole) can be installed
- Q:We found an older (maybe 10-15 years) cast iron sink that is 48 inches long with two large basins and a small one in a junk trailer. It has 6 faucet holes drilled like this 0 0 0 on the back and we were wondering what all the holes 0 0 0 were for.
- sounds like Jen has it going on
- Q:Wash basin basin faucet how to do, the handle joints leak
- It is basically the faucet inside the seal is broken, it is recommended for a new faucet!
- Q:Three hole wash basin installed a single hole wash hands, the other two holes exposed how to do?
- In recent years, home improvement, popular relatively beautiful single-hole faucet. Three hole basin fitted with a single hole faucet, the other two holes revealed, neither beautiful, but also to the pool under the water.
- Q:Hot and cold faucet how to take water pipes
- Single handle basin faucet should pay attention to the diameter of the outlet, and now most of the market belongs to the hard tube water, so should pay attention to the height of the sink, from the basin down 35 points is the most appropriate. Installation, be sure to choose a special angle valve, and the angle valve and the wall must be hot and cold water pipe fixed. When it is found that there is a distance between the angle valve and the faucet on the faucet, it is necessary to purchase a dedicated extension tube to connect. Remember, do not use other water pipes to connect, because if the water pressure, it is easy to fall off, leaking, causing losses. If the inlet pipe is too long to exceed the outlet pipe, according to the need to cut off the part of the angle is not appropriate, then according to the need to moderate to the desired position. Remember: do not bend hard to 90 degrees or greater than 90 degrees. When installing the basin to the water, please do not forget to buy a small interface (leading short). Do not forget to rinse the pipes buried in the wall before installing.
- Q:Home water heater through 6 points of hot water, only three points out of hot water, the other out of warm water. And the location of the hot water and warm water are used together to warm the wall, do a circulating hot water. Whether I am hot water or return water to the hot water is always only a point of hot water, but one of the points of the location of the change
- This problem is really the first time encountered. Usually the pipeline is too long, you need to take a long time to solve the water, because the cold water in the pipeline to go out of the reasons. As for your question, since you have found a hot water and warm water at intervals, then you let the plumber turn the basin faucet and the shower into the water pipe down is not the problem solved. If resolved, then it is your hot water separator problem, because you divided the six exports, may be a water separator or you use 3-channel change, then it is a problem. hope this helps!
- Q:of diameter 60cm with water at a rate of 2 L/min. Find the rate at which the water is rising in the basin when it is HALF full. [Use the following facts: 1 L is 1000 cm3. V = pi (rh^2 -1/3 h^3]I need help with this asap. Thank you!!
- Equation of the hemispherical surface x? + y? + z? = R?, (-R z 0) The volume of water in the basin with the height h: . . . (-R+h) V = ∫ π(x? + y?) dz . . . -R . . . (h-R) V = π ∫ (R? + z?) dz . . . -R V = πR?[(h - R) - (-R)] + (π/3)[(h - R)? - (-R)?] V = πR?h + (π/3)(h? - 3h?R + 3hR? - R? + R?) V = πR?h + (π/3)(h? - 3h?R + 3hR?) dV/dh = πR? + (π/3)(3h? - 6hR + 3R?) dV/dh = πR? + π(h? - 2Rh + R?) dV/dh = π(h? - 2Rh + 2R?) dV/dh = (dV/dt)/(dh/dt) dh/dt = (dV/dt)/(dV/dh) dh/dt = (dV/dt)/π(h? - 2Rh + 2R?) There is an ambiguity when you say HALF full. It can be interpreted as the water was filled up to half its maximum height (R) or filled up to half the volume of the basin (2πR?/3) I will take the case in which the water was filled up to half its maximum height: h = R/2 dh/dt = (dV/dt)/π(R?/4 - 2R*R/2 + 2R?) dh/dt = (dV/dt)/π(R?/4 - R? + 2R?) dh/dt = 4(dV/dt)/5πR? Plugging in dV/dt = 2000 cm?/min R = 30 cm dh/dt = 4*2000/4500π dh/dt = 16/9π cm/min. dh/dt ≈ 0.57 cm/min.
1. Manufacturer Overview |
|
---|---|
Location | Kaiping,Guangdong |
Year Established | 2004 |
Annual Output Value | Above RMB5 Million |
Main Markets | Europe and the United States, Australia |
Company Certifications |
2. Manufacturer Certificates |
|
---|---|
a) Certification Name | |
Range | |
Reference | |
Validity Period |
3. Manufacturer Capability |
|
---|---|
a)Trade Capacity | |
Nearest Port | Guangzhou |
Export Percentage | |
No.of Employees in Trade Department | 4 People |
Language Spoken: | English;Chinese; |
b)Factory Information | |
Factory Size: | Above 3000 square meters |
No. of Production Lines | 2 |
Contract Manufacturing | OEM Service Offered;Design Service Offered |
Product Price Range | Average |
Send your message to us
Unique Design Temperature Control Colour Changing Led Bath Faucets Brass Basin Mixer
- Loading Port:
- Shenzhen
- Payment Terms:
- TT
- Min Order Qty:
- 200Pcs PCS
- Supply Capability:
- 1000Pcs Per Month PCS/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords