Plastic Tubes - PVC Pressure Pipe (ASTM Sch 40 & 80) ASTM, AS, BS, ISO, GB, Varios Color
- Loading Port:
- Tianjin
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 1000 kg
- Supply Capability:
- 10000 kg/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
1.Specifications
pvc pipe for water drainage
1)Specification of pvc pipe:40mm-400mm
2)Thickness of pvc pipe:1.2mm-7.0mm
3)ISO certified.
2.Properties of pvc pipes:
1) Material: pvc pipe unplasticized polyvinyl chloride
2) Standard: GB, ISO9001, ISO14001
3) Color: white pvc pipe, grey pvc pipe , etc.
4) Specific Gravity, g/cm3, 20(C): 1.35 - 1.55
5) Vicat Softening Temperature, (C) >=79
6) Longitudinal Reversion, %, 150(C) <=5
7) Dichloromethane Resistance Test: No attack
8) Falling Weight Impact Test, TIR, %, 0(C) <=10
9) Tensile Yield Strength, Mpa >=40
10) Fitness of Water Tightness Test: No Leakage
11) Fitness of Air Tightness Test: No Leakage
3.Features of pvc pipes :
1) Light weight, easy to load and unload: PVC pipe is very light, convenient to handle loading unloading, and installing.
2) Good chemicals and drugs resistance: PVC pipe has its excellent resistance to the erosion caused by acids and alkalines, a great help to the chemical industries.
3) Small resistance to fluidity: The smooth surface reduces resistance to the fluids. Its roughness coefficient is only 0.009, much less than other pipes, Under same discharges, smaller cabibre of the pipe can be uesd.
4) Strong mechanical strength: Good resistance to water pressure, outside impact and pressure, is satisfied under any conditions.
5) Good electrical insulation: excellent insulation nature against electricity. the pvc pipe can be served as conduits and pipes in construction cable and wire.
6) Water quality unaffected: The solution tests on the PVC pipe show no affect on water quality when the water flows through is. It is considered the best piping material for running water works.
7) Simple installation: Very easy to connect, thus much time and laborcost may be saved.
4.Application of pvc pipes:
1) Structure Engineering, home water supply and drainage
2) Water drainage/supply system
3) for Agriculture Irrigation, aquaculture
5.Specifications of the pvc pipe:
Outer Diameter (mm) | Wall thickness(mm) | ||||||||
2.5MPA | 2.0MPA | 1.6MPA | 1.25MPA | 1.0MPA | 0.8MPA | 0.63MPA | |||
φ20 | 20*2.3 | 20*2.0 | |||||||
φ25 | 25*2.8 | 25*2.3 | 25*2.0 | ||||||
Φ32 | 32*3.6 | 32*2.9 | 32*2.4 | 32*2.0 | |||||
Φ40 | 40*4.5 | 40*3.7 | 40*3.0 | 40*2.4 | 40*2.0 | ||||
Φ50 | 50*5.6 | 50*4.6 | 50*3.7 | 50*3.0 | 50*2.4 | 50*2.0 | |||
Φ63 | 63*7.1 | 63*5.8 | 63*4.7 | 63*3.8 | 63*3.0 | 63*2.5 | 63*2.0 | ||
Φ75 | 75*8.4 | 75*6.9 | 75*5.6 | 75*4.5 | 75*3.6 | 75*2.9 | 75*2.3 | ||
Φ90 | 90*10.1 | 90*8.2 | 90*6.7 | 90*5.4 | 90*4.3 | 90*3.5 | 90*2.8 | ||
Φ110 | 110*10.0 | 110*8.1 | 110*6.6 | 110*5.3 | 110*4.2 | 110*3.4 | 110*2.7 | ||
Φ125 | 125*11.4 | 125*9.2 | 125*7.4 | 125*6.0 | 125*4.8 | 125*3.9 | 125*3.1 | ||
Φ140 | 140*12.7 | 140*10.3 | 140*8.3 | 140*6.7 | 140*5.4 | 140*4.3 | 140*3.5 | ||
Φ160 | 160*14.6 | 160*11.8 | 160*9.5 | 160*7.7 | 160*6.2 | 160*4.9 | 160*4.0 | ||
Φ180 | 180*16.4 | 180*13.3 | 180*10.7 | 180*8.6 | 180*6.9 | 180*5.5 | 180*4.4 | ||
Φ200 | 200*18.2 | 200*14.7 | 200*11.9 | 200*9.6 | 200*7.7 | 200*6.2 | 200*4.9 | ||
Φ250 | 250*11.9 | 250*9.6 | 250*7.7 | 250*6.2 | |||||
Φ315 | 315*15.0 | 315*12.1 | 315*9.7 | 315*7.7 | |||||
Φ400 | 400*19.6 | 400*15.3 | 400*12.3 | 400*9.8 | |||||
6.FAQ
Q:What is you MOQ?
A:As customer’s request.
Q:What is the production ability? or delivery time?
A:Our production ability support 40HQ order finish in one week.
Q:What is the regular shipping port?
A:Tianjin or Shanghai.
Q:What is your payment?
A:TT or CC.
Q:Can we have sample?
A:Sample free, freight cost you.
Q:For urgently doubts,who online?
A:Sales and marketing Manager 24hours online service.
- Q: How to remove dirt on the inner wall of plastic pipe?
- In the first bowl upside down water, tap water can, do not need too much, and probably can usually wash water, then pour 84 disinfectant, and then put for a while, with a rubber glove hand cloth wipe dirt in the basin, can easily fix.
- Q: Can plastic tubes be used for vacuum applications?
- Yes, plastic tubes can be used for vacuum applications.
- Q: My 98 Stratus 2.4L 4 cyl is dripping clear clean water on the passenger side and has accumulated water in the blower motor area. How can I clean out the drain? Where is the drain?
- Based on your question, I would say you probably have water gathering on your passanger floor board. If it is the drain that is clogged, NO water will drip. So first, run the car with the ac on and see if the water pools under the car. You can usually trace the drain by following the flow of water. If I had to guess, I would say it is on the fire wall to the right about in the middle of were the passangers feet would sit (on the inside, drain plug on outside). If it is clogged, use a wet-dry vac and suck out the intrusion. You will know if it was clogged as the water will flow freely after some suction. If there is no clog, you may have a bad heater coil. Not too bad to replace, but should be done by a pro. Good luck!!
- Q: This tube is found when u remove the silver engine cover.I need to buy this tube cos its broken. It looks like an exhaust oil channel (not sure). it was noted to be broken/cot during a recent service and I was told only citroen dealers can have it in stock.Car runs fine but I occasionally smell oil while driving.
- It sounds like some kind of breather pipe to me, probably the best thing to do is to roll into your local Citroen dealer and ask someone in parts to look at it and they should be able to get you one then.
- Q: I'm would like to buy this in store and not online. Please let me know of where you think this item might be available for purchase.Thanks
- try united states plastic corp.
- Q: One charged plastic ball is vertically above another in a test tube. The balls are in equilibrium a distance d apart. If the charge on each ball is doubled, the distance between the balls in the test tube would become:a. 4db. 2dc. 8d
- Equilibrium is established when the electric force between the balls = weight of upper ball .. this force is constant at any spacing. F = k.q1.q2 / d? .. .. For constant F .. q1.q2 ∝ d? .. .. d ∝ √(q1.q2) When q1 and q2 double .. (q1.q2) increases by a factor of 4 .. and d by a factor √4 = 2 Ans .. ?(b).2d
- Q: Are plastic tubes resistant to static electricity?
- No, plastic tubes are not generally resistant to static electricity.
- Q: Can heating water pipes be made of ordinary plastic pipes?
- General is generally PERT, the price comparison, the best is PEXC, the price is more expensive, but can produce C tube manufacturers are relatively strong. Anyway, all of them should be loaded with muddy water and ordinary ones, but they should be made by Dachang
- Q: What are the advantages of using plastic tubes in the cosmetic packaging industry?
- There are several advantages of using plastic tubes in the cosmetic packaging industry. Firstly, plastic tubes are lightweight, which makes them easy to transport and reduces shipping costs. Secondly, plastic tubes are flexible and can be easily squeezed, allowing for controlled dispensing of cosmetic products. Thirdly, plastic tubes provide excellent barrier properties, protecting the contents from external factors such as moisture, light, and air, which helps to extend the shelf life of the product. Additionally, plastic tubes are customizable, making it easy to create unique and attractive packaging designs that can enhance the product's appeal to consumers. Lastly, plastic tubes are cost-effective and can be produced in large quantities, making them a cost-efficient option for cosmetic manufacturers.
- Q: Are plastic tubes suitable for personal care product packaging?
- Yes, plastic tubes are suitable for personal care product packaging. They are lightweight, durable, and offer excellent barrier properties to protect the product from external factors such as light, moisture, and air. Additionally, plastic tubes are versatile and can be easily customized in terms of shape, size, and color, making them ideal for various personal care products like creams, lotions, gels, and toothpaste.
Send your message to us
Plastic Tubes - PVC Pressure Pipe (ASTM Sch 40 & 80) ASTM, AS, BS, ISO, GB, Varios Color
- Loading Port:
- Tianjin
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 1000 kg
- Supply Capability:
- 10000 kg/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords