Sell Solar Panels Online - Monocrystalline Solar Panels 45W for Solar Systems
- Ref Price:
-
- Loading Port:
- Shanghai
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 10000 watt
- Supply Capability:
- 50000000 watt/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Product Description
Solar Monocrystalline Series Panels
Introduction of Monocrystalline Solar Panels
CNBM Solar photovoltaic (PV) Panel is designed for large electrical power requirements. It is the optimal choice for both on-grid and off-grid power systems. CNBM Solar panel offers high performance of power per square foot of solar array. Monocrystalline silicon(c-Si): often made using the Czochralski process. Single-crystal wafer cells tend to be expensive, and because they are cut from cylindrical ingots, do not completely cover a square solar cell module without a substantial waste of refined silicon. Hence most c-Si panels have uncovered gaps at the four corners of the cells.
Characteristics of Monocrystalline Solar Panels
I Solar Cell : High efficiency crystalline solar cell. Even if under the weak light, the solar module can produce maximum power output.
II Tempered glass (toughened glass): Anti-reflecting coating and high transmission rate glass increase the power output and mechanical strength of solar module.
III EVA and TPT: Using high quality EVA and TPT to prevent destroying and water.
IV AI frame: Without screw, corner connection. 6 holes on the frame can be installed easily.
V Junction box: Multi function junction box with water proof.
VI Long lifetime: ≥25 years; Less power decrease
VII Good performance of preventing from atrocious weather such as wind and hails.
VIII Resisting moisture and etching effectively, not effected by geology.
Standard Test Conditions of Monocrystalline Solar Panels
The opto-electrical specifications shown below are stabilized values being measured at Standard Test Conditions, Irradiance: 1000W/m2, Spectrum: AM1.5 at 25°C, The info below is subject to manufacturing tolerances. Where appropriate minutes of measurement are available and are used for the dimensioning of the installation.
Advantages of Monocrystalline Solar Panels
1.High reliability with guaranteed -3% to +5% power output tolerance, ensuring return on investment
2. High conversion efficiency based on leading innovative photovoltaic technologies
3. Withstands high wind-pressure and snow load, and extreme temperature variations
4. Attractive appearance Unique frame design, high mechanical strength, and easy Installation
Characteristics of Monocrystalline Solar Panels
Max Power Voltage Vmp (V) | 17.4V | 17.8 V |
Max Power Current Imp (A) | 2.59A | 2.81A |
Open Circuit Voltage Voc (V) | 22.4V | 22.6V |
Short Circuit Current Isc (A) | 2.75A | 2.99A |
Max Power Pm (W) | 45W | 50W |
Temperature Coefficient of Cells
NOCT | 47℃±2℃ |
Temperature Coefficients of Isc (%/℃) | 0.06 |
Temperature Coefficients of Voc (%/℃) | -0.33 |
Temperature Coefficients of Pmp (%/℃) | -0.45 |
Mechanical Data Solar Monocrystalline Series
Power | 20W/25W |
Dimension | 630×550×30mm |
Weight | 4.5 kg |
Tolerance | ±3% |
The dimension of the modules can be changed according to the demand of clients Limits.
Operating Temperature | –45 °C to +80°C |
Storage Temperature | –45 °C to +80°C |
Max System Voltage | 700V |
Guarantee Solar Monocrystalline Series Panels
Products Guarantee | 10 years free from defects in materials and workmanship |
Performance Guarantee | No less than 90% within 10yrs and no less than 80% within 25yrs |
Certificates | IEC, ISO, TUV, CE |
Dimension of Solar Monocrystalline Series Panels
FAQ
We have organized several common questions for our clients，may help you sincerely：
1. What’s price per watt?
A: It’s depends on the quantity, delivery date and payment terms of the order. We can talk further about the detail price issue. Our products is high quality with lower price level.
2. Can you tell me the parameter of your solar panels?
We have different series of cells with different power output, both from c-si to a-si. Please take our specification sheet for your reference.
3. How do you pack your products?
We have rich experience on how to pack the panels to make sure the safety on shipment when it arrives at the destination.
4. What is your warranty system?
Our product performance guarantees for 25 years
• 12 years guarantee for workmanship
• Timeliness of delivery
• Quality Products certified (TÜV, UL, CE, ISO)
5. How do you pack your products?
We have rich experience on how to pack the panels to make sure the safety on shipment when it arrives at the destination.
- Q: Can solar panels be used for powering a manufacturing facility?
- Yes, solar panels can be used to power a manufacturing facility. Solar panels convert sunlight into electricity, which can be utilized to run various equipment and processes within a manufacturing facility. By installing a sufficient number of solar panels, a manufacturing facility can significantly reduce its reliance on traditional grid electricity and lower its carbon footprint. However, the feasibility and effectiveness of solar panels for powering a manufacturing facility would depend on factors such as the facility's energy requirements, available sunlight, and the size of the solar panel system installed.
- Q: I have a rental property and use a 230-Volt 6-Amp Pool Pump.I would like to use a solar panel to run it when the house is empty, using mains power when guests are here.The building is in the Caribbean so plenty of sun!!I wanted to run it quot;directand not use batteries. Is this possible??What size panel would I need? A DC invertor too??Thanks!!
- You can buy a solar pool pump with all the equipment you'll need.
- Q: Can solar panels be damaged by birds or other animals?
- Yes, solar panels can be damaged by birds or other animals. Birds may build nests or perch on the panels, causing blockage of sunlight and reducing their efficiency. Additionally, animals like squirrels or raccoons may chew on the wires or cables, leading to electrical damage. To prevent such issues, various measures like installing bird deterrents or using protective mesh can be taken.
- Q: I am moving to Hawaii and the house we are living in has independent electricity. (solar panels and gas powered generators.)
- specific. fairly, here is what you % (i'm holding this ordinary on objective): The panels themselves -- how large a close-by relies upon on effortless potential intake and how plenty potential you will get on effortless. That, in turn , relies upon on climate. you would be wanting extra in Seattle than Tuscon, as an occasion. i could wager something in the neighborhod of 0 sq. ft. relies upon additionally on haow many units (printers, etc.) you have. you would be wanting a potential storage device. Lithium components the perfect poser density (of off-the-shelf stuff) yet an effortless motor vehicle battery works properly and is sturdy. And, of course, a administration device to administration the potential technology/storage/use so each little thing works collectively with out that stressful scent that tells you you in undemanding terms cooked some hundred greenbacks properly worth of equuipment! :)
- Q: About how much would it cost to purchase and install solar panels for the average American house so that the house can be off the power grid and use the same amount of electricity as it normally does?
- I had a survey of my home and it was estimated at $30K with a 30% rebate from the government. It would take about 5 years to pay back the cost. I elected to go solar water heating instead. 2 panels with piping installed to an 80 gallon electric water heater with an internal heat exchanger. One small photo voltaic panel to run the pump. There is ethylene glycol inside the pipe and it circulates and heats the water. Works excellent. I live in Nor-Cal and we get a lot of sun. I need to comment on another statement that photo voltaic cells cost more energy to produce they generate. Maybe once but not true any longer. {Solar cells and energy payback In the 990s, when silicon cells were twice as thick, efficiencies 30% lower than today and lifetimes shorter, it may well have cost more energy to make a cell than it could generate in a lifetime. The energy payback time of a modern photovoltaic module is anywhere from to 20 years (usually under five)[9] depending on the type and where it is used (see net energy gain). This means solar cells can be net energy producers, meaning they generate more energy over their lifetime than the energy expended in producing them}
- Q: Can someone tell me if I can run a air conditioner off solar panel?I have a ET-P65420 20Wp solar panel. What do I need to make it work? I am told I will need a Enphase Energy Microinverter M20. Is that true? I am looking to run a 5000 to 8000btu air conditioner to a max of 0000btu air conditioner. I need to cool a 0x30 space. One time I read, I need total watts of panel to match total watts of air conditioner. Then I read, that I do not and can run more watts then what the panel is depending on the inverter and batteries.Can someone tell me what and how to make this work please? More panes or inverter and batteries?
- You can expect such an air conditioner to use something like 500 - 800 watts of power. The ET-P65420 20Wp solar panel produces at most 20 watts so you will need at least three of them. Since solar cells make DC (Direct Current) electricity, and air conditioners use Alternating Current (AC) electricity, you do need an inverter. The M20 is a 220 volt inverter, and I suspect you are looking at a window air conditioner that will probably use 0 volt power. And the M20 only puts out a maximum of 240 watts so you need one for each of the 3 or more solar panels you will have to use. So the first thing to do is shop for air conditioners, getting the most energy efficient model you can find, paying close attention to the voltage and wattage ratings in the owner's manual or on the UL label on the back. Say it is a 500 watt, 0V unit. You will need three solar panels and three 0 volt model inverters. Also note that the 20 watt rating of the solar panels if when the panel is facing DIRECTLY at the Sun. If you just lay them on the roof, then even if the roof is sloped at a good angle (30 degrees) and facing south, it will only produce the maximum power around noon. 4 hours before noon, unless to go up there and tip them up to face the morning Sun they will probably produce only about half that amount of power. So right there you either need a motorized mount to automatically follow the Sun or twice as many panels. However, if you are going to connect the solar panel(s) into the house power, so that it(they) merely supplement the power company power, then you can use any amount of panels, and the power company will supply whatever extra power you need. That requires a licensed electrician to do. Or if you want to just power the air conditioner directly from the solar panels without any interconnection to the house power, then you need to know a lot more about electricity that you appear to know.
- Q: I want to plug my solar system battery bank into my transfer switch on my cabin when not using a generator. The transfer switch will handle 220 volt from my generator. How do I get a 220 volt inverter that runs 60 hz or do all of them run 50 hz.I see plenty of 20 volt 60 hz. I'm at the point of needing to order one and I'm not sure.
- Stand Alone solar panel inverters function to change direct current (DC) from a battery to Alternating Current (AC). Stand alone inverters, which range from around 00 watts to as much as 8000 watts, are used to power a vast variety of personal or small business projects. Lower watt stand-alone inverters are often used to power laptop computers, whereas high-watt stand-alone inverters could be used to help power an entire household. In order to calculate what class of inverter you need for use with your solar panel, you will first have to determine the maximum sum of all of the Alternating Current loads in your project (or home). How to calculate the wattage you need from your stand-alone solar panel inverter
- Q: Can solar panels be used to power a shopping mall?
- Yes, solar panels can be used to power a shopping mall. By installing a sufficient number of solar panels on the mall's rooftop or in nearby areas, it is possible to generate enough electricity to meet a significant portion of the mall's power requirements. This can help reduce the mall's reliance on traditional grid electricity and promote the use of clean, renewable energy sources.
- Q: Can solar panels be installed on streetlights?
- Yes, solar panels can be installed on streetlights. They provide a sustainable and cost-effective solution by harnessing the sun's energy to power streetlights, reducing the dependence on traditional electricity sources and lowering overall energy costs. Additionally, this renewable energy option helps to reduce carbon emissions and promote environmental sustainability.
- Q: Is it good? ( solar energy)
- I think solar panels benefit people a lot,it is worth buyingsolar power can be converted into heat energy and electricity which be used into daily human life,more convenient and safe，Also,solar power will not discharge any polluted gas,it can protect our earth.As for the negative,the price of solar power is a little higher at first pay,but you will not pay any fees any more.
Send your message to us
Sell Solar Panels Online - Monocrystalline Solar Panels 45W for Solar Systems
- Ref Price:
-
- Loading Port:
- Shanghai
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 10000 watt
- Supply Capability:
- 50000000 watt/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords
