• Residual Current Circuit Breaker With Over Current Protection System 1
  • Residual Current Circuit Breaker With Over Current Protection System 2
Residual Current Circuit Breaker With Over Current Protection

Residual Current Circuit Breaker With Over Current Protection

Ref Price:
get latest price
Loading Port:
Wenzhou
Payment Terms:
TT OR LC
Min Order Qty:
-
Supply Capability:
10000pcs pc/month

Add to My Favorites

Follow us:


OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing
Application
DZ47L C45L RCBO is used for the protection against electrical leakage in the circuit of 50Hz or 60Hz, rated voltage 1 phase 230V and 3 phase 400V, rated current up to 63A. When somebody gets an electric shock or the residual current of the circuit exceeds the fixed value, the RCBO can cut off the power within the time of 0.1s automatically to protect the personal safety and preventing the equipment from the fault resulted by the residual current. With this function, the RCBO can protect the circuit against overload and short circuit or can be used for the unfrequent switchover of the circuit under normal conditions. It conforms to IEC61009 standard.
Normal Operation and Mounting Requirement
◆Circumstance temperature -5~+40, average temperature not exceeding 35.
◆Altitude above sea level less than 2000m.
◆Humidity not exceeding 50% at 40 and not exceeding 90% at 25.
◆Installation class II or III.
◆Pollution class II.
◆Installation method DIN Rail mounting type.
◆The external magnetism shall not be more than 5 times of terrestrial one.
◆Product shall be installed vertically at the place where there shall be no severe impact and vibration. The product is switched on when the handle is at upper position.


Q: What circuit symbols are used for circuit breakers
mass I + I + I <phase = nine = 0. Mass or I + I + I <phase + = nine = 0. So the brothers must install the ground wire ah
Q: Household leakage circuit breakers, circuit problems
The The 2. There are two holes at the top (one write N and the other without writing), and the bottom has two holes (one write N and the other). Above
Q: What is the common circuit switch called switch
Manual and electric operation are, with the development of microelectronics technology, the current part of the intelligent circuit breaker with a regional
Q: Which is the circuit switch, that is the circuit breaker
sub-capacity and so are greater than Molded Case circuit breaker. This is a fundamental difference,
Q: How to choose a circuit breaker for home and small office circuits
Leakage accessory handle. Leakage causes not removed before the small circuit breaker handle and leakage accessory handle can not be reset.
Q: Do you have a circuit breaker in the circuit?
It is recommended that you use a fuse or circuit breaker, depending on the actual situation.
Q: Why the first break circuit breaker, after the isolation switch off it?
Power failure, the circuit there is current, because the circuit breaker has the ability to arc, the first pull circuit breaker, there will be no problem,
Q: Switch switch, disconnector, circuit breaker difference? What are the possible functions of each?
You said the knife can be understood as a kind of isolation switch, it is only as a circuit break point, no lines, load protection function
Q: Is the isolator switchable with a circuit breaker?
Disconnector: similar to the knife switch, no to prevent overcurrent, short circuit function, no arc device;
Q: Is there a circuit breaker in the circuit
Such as the circuit breaker at work, when a failure occurs, it is the power of all disconnected.

Send your message to us

This is not what you are looking for? Post Buying Request

Similar products

Hot products


Hot Searches

Related keywords