Yufei Electric Single-girder Gantry Crane
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
General
Electrical Single-girder Gantry Crane is used together with CD MD Model electrical hoists.
It is a track travelling small and medium-sized crane.
Its proper lifting weight is 5 to 10 tons, proper span is 12 to 30 meters, its proper working temperature is
-25°C to 40°C
It has two controlling methods, namely ground controlling and room controlling.
Feature
1)Power source is three-phase alternating current,rated frequency is 50Hz, rated Voltage is 380V.
2)The altitude height of site is ought to be less than 2000M.
3)Flammable,explosive and corrosive gas are forbidden in the work environment.
4)The crane is forbidden to lift fuse and blend deleterious article and flammable explosive article.
Technical characteristics
This crane has hard surface gear reducer and steel rope and three-in-one transmission mechanism.
Protective functions are as the following:
1)Acoustic-optic alarm, hook automatic stop protector, circuit protector and over current and
phase lose protection and intelligent limit.
2)The electric devices adjust speed without contactor spark module and fulfill frequency convert function to
reach mini-speed and double speeds, which make travelling and lifting very steady.
3)The operating board (handle) adopts 12V safe voltage.
4)The electronic controlling can be used more than 2 million times when the voltage is +5~-10% of 380V.
Choosing principle of single gantry crane
According to the working system and using field. Which system you will choose, field should go first.
Calculating the times per hour of starting and pulling-on recycle,you should make the practical time per day
and continuous time
When select or appraise, you should be sure such items as field, all the limiting size, ambient temperature,
speed, time(h), intermission or continuous, the time of starting and pulling-on per hour, etc.
The above mentioned is just for reference. Reasonable selection, design and match can increase the working efficiency greatly.
Layout
table parameter
Lifting capacity | t | 5 | 10 | |||||||||
Span | m | 18 | 22 | 26 | 30 | 35 | 18 | 22 | 26 | 30 | 35 | |
Lifting height | m | 10 | 11 | 10/10.5 | 11/11.5 | |||||||
Work system |
| A5 | ||||||||||
Speed | Main lifting | m/min | 9.0 | |||||||||
Aux lifting |
| 9.0 | ||||||||||
Trolley traveling | 35 | |||||||||||
Crane traveling | 30 | |||||||||||
Total power | KW | 22.8 | 25.8 | 36.8 | 39.8 | |||||||
Max wheel load | KN | 160 | 166 | 185 | 231 | 233 | 225 | 256 | 239 | 286 | 298 | |
Recommended rail | Kg/m | 43 kg/m | ||||||||||
Power supply | 380V, 50Hz, 3P( we can design cranes according to client’s local power source) |
Workshop picture
- Q: i need at least a 20 ton winch that is ran by 12v vechial powerthanks
- I haven't heard of anything that large to be used for an automotive purposeThe only thing I can think of is maybe a wrecker's crane liftEither that, or it's application would be for something in the marine field i.e.) bargesI doubt you could even find anything larger than a 10 ton setupEven if you did, it would more than likely be a hydraulic mechanismGood Luck!
- Q: Hi! My brother just got a small remote-controlled helicopter for christmas.We were wondering if we could make a small crane to attach to it so the helicopter can pick up things.Also, would we have to some how wire the remote so we could control the crane without like quot;touchingquot; the helicopter?Thanks
- Its actually illegal to take a shark with a firearmalso i think it maybe illegal to have a firearm on a vessel without a permit
- Q: After they build a train how does it get on the tracks.is it built there?
- Rolling stock is built then placed upon the trucksThey are not attachedThe weight of the car keeps it on the wheelsLocomotives are usually built upside down, doing the work that will be under the loco firstAfter all is done below the frame, it is turned over and the other elements of the locomotive are addedRe-railing derailed equipment is a different storyIf a car has dropped at set of wheels, if minor and remaining close to the rails, blocking material, consisting primarily of wood blocks and chains, can be placed to walk the derailed wheels back on the railThere are also two types (the Budda and the butterfly) of large steel devices called frogs that may be necessary to walk a heavier car on, or even walk a locomotive truck back onIf a car's truck has been turned, yet still near the rail, as the car is pulled on, a slewing cable is attached to turn the truck as it moves, with the other end tied of to a tractor or some other kind of heavy equipment to align the wheels to the rail so the truck will throw onWhen cars are semi-scattered, a hi-rail, 200 ton crane is employed when heavy lifting is neededThough there are still some steam derricks left, their use is infrequentI have seen these new wonders suck an SD-45 right out of the mud, one end at a timeWhen there is a major pile up with cars scattered all over the place, they bring in the big Cats and they just shove the stuff out of the way to get the line openThese cars are usually cut up for scrap on the spot.
- Q: The pork in Obamacare and the Porkulus bill was out of control, I can only imagine how much pork is in the new quot;jobsquot; act.
- Butter the bottom and sides of your cake pan and then line the bottom with a circle of parchment paperButter the parchment and then shake a small amount (2 tablespoons) around the pan until the bottom and sides are coatedShake out and dump the excess flour from the panYou will probably be able to unmold the cake using the above techniqueYou are correct in that the only difference between a standard cake pan and a springform pan is in the ease of unmolding your cake.
- Q: What’s the heaviest item you have ever teamed lifted?
- NoWouldnt recommend itMaybe wax paper
- Q: Hello, what is the meaning of this?1- Bridge cranes.2- Birdge cranse motor.3- Bridge cranes (parts of main items).
- These are the parts for a piece of equipmentA bridge crane is to lift parts of the bridge for bridge repair
- Q: Is it possible to make an arc welder with a car battery, jumper cables, and electrodes? I would think it's pretty much the same conceptI've never welded before, but the thought just popped in my mind and I thought I would ask it.
- Any Energy Star rated product would be a good choiceTo receive the Energy Star rating the product must meet high standards and be at lest 30% more efficent then the norm.
- Q: im not allowed outside because im quite sick and its really cold were i live, inside activities would be the best!
- valence shell last electron shell and if you look in the reference tables.the last shell (3rd one) has 3 electrons
- Q: All i can remember is there was a guy with a red collar at the beginning with a bunch of teens or adults (i can't remember) anyways they go into a elevator and it takes them somewhere and the last person to survive wins a million dollars or moreI know its rated Rplease help.
- Less sodium buy far.
Send your message to us
Yufei Electric Single-girder Gantry Crane
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords