Plastic Tubes - Colorful PVC Suction Hose for Water Pump

Inquire Now

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

You Might Also Like

Colorful PVC Suction Hose

Applications:

1) Used for: drawing and conveying water,oil,air,powder.

2) Used in: factory,agriculture,engineering,foodstuffs and sanitation lines.

3) It is the ideal alternative of rubber hose and metal pipe.

Characteristics:

1) This hose is light,with small bending radius.

2) It has good adaptability to hard weather conditions and minus pressure.

Q: Can plastic tubes be customized with color?: Yes, plastic tubes can be customized with color.

Q: how we can design a simple total head tube ??: Your supposition isn't splendid for a standard venturi. If the venturi is pushed (enable's say it relatively is a steam jet) then the rationalization fluid components ability that will boost the entire head on the region you point out.

Q: Can plastic tubes be used for HVAC lines?: Yes, plastic tubes can be used for HVAC lines. Plastic tubing such as polyvinyl chloride (PVC) or high-density polyethylene (HDPE) can be suitable alternatives to traditional metal pipes for HVAC systems. Plastic tubes are lightweight, resistant to corrosion, and can be easily installed, making them a cost-effective choice for HVAC applications. However, it is important to ensure that the specific plastic material used is compatible with the HVAC system requirements and meets the necessary industry standards.

Q: How can the pipe support for water supply and drainage be calculated?: The support of a drain pipe is contained in a pipe and is usually not counted

Q: What are the common sizes of plastic tubes used for cables?: The common sizes of plastic tubes used for cables vary depending on the specific application and industry. However, some commonly used sizes include 1/4 inch, 3/8 inch, 1/2 inch, and 3/4 inch diameters.

Q: the tubes are bout 1cm ID with only about a 1mm thickness. I don't think threading them will be possible, and the seal between that has to be water tight.: I would go for a coupler on the outside of the tube, which should be stronger and won't restrict the flow. Get some 12mm ID tube from a model shop or plastic supplier. Roughen the inside of the coupler and the outside of the ends of the tube with sandpaper, apply plenty of epoxy, assemble and leave to set. You might want to improvise some kind of jig to hold the 2 tubes in-line while it sets.

Q: is it ok to use a plastic tubing for my ice maker how about the fittings (plastic)?: That's what I have on mine. The fittings will have some brass usually

Q: i connected a plastic tube about 7 or 8 inchs long onto a butane can im wondering if when i push down on the can and put a match near it can the fire go back into the can and make the can explode and if so how can i stop that from happening and y would it happened: The fire in this case is a reaction between butane from the can and oxygen from the air. If either one is missing, there can be no fire. The fire cannot propagate back up the tube, since the tube will be filled with pure butane, meaning there will be no oxygen in the tube.

Q: what do you call the plastic tubes used for pet water bottles, and where can you find them?: rubber tubes? you can find them at any pet supply store.

Q: Will they disintegrate or damage over time? Or are they safe like that for a while?: If you must store them for a long time get a tube that is acid free and that will hold out moisture. A plastic type tube. If you keep it dry and at normal room temperature, storing it in a tube is fine long term. Maybe even years. Do not roll tightly.

Send your message to us

*Email

*TEL

*Quantity

*Unit