Ambient Solar Panels - Monocrystalline Solar Module ZDNY 220-235 W
- Loading Port:
- Shanghai
- Payment Terms:
- TT or LC
- Min Order Qty:
- 100 pc
- Supply Capability:
- 30000 pc/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Solar Monocrystalline Series (220W—235W)
l : High efficiency crystalline solar cell. Even if under the weak light, the solar module can produce maximum power output.
II Tempered glass (toughened glass): Anti-reflecting coating and high transmission rate glass increase the power output and mechanical strength of solar module.
III EVA and TPT: Using high quality EVA and TPT to prevent destroying and water.
IV AI frame: Without screw, rner connection. 6 holes on the frame can be installed easily.
V Junction box: Multi function junction box with water proof.
VI Long lifetime: ≥25 years; Less power decrease.
VII Good performance of preventing from atrocious weather such as wind and hails.
VIII Resisting moisture and etching effectively, not effected by geology.
Standard Test Conditions of Solar Monocrystalline Series :
The opto-electrical specifications shown below are stabilized values being measured at Standard Test Conditions,
Irradiance: 1000W/m2, Spectrum: AM1.5 at 25°C,
The info below is subject to manufacturing tolerances.
Where appropriate minutes of measurement are available and are used for the dimensioning of the installation.
Advantages of Monocrystalline Silicon Solar Panel
• CNBM Solar performance guarantees for 25 years
• 12 years guarantee for workmanship
• Timeliness of delivery
Specification of Solar Monocrystalline Series
- Optimal permutation on solar cells to keep enough heat diffusion, decreases hot spot effect.
- High quality and anti-ageing EVA, weather resistance backside raw materials assure reliable solar panels.
- Passed 5400Pa mechanical loads testing by UL, can withstand bad and high mechanical load working environment.
- With good sealed performance, moisture resistant, aging resistance, high/low temperature resistant, the inner terminals of our junction box owns good electrical performance transmission. Bypass diodes used can avoide hot spot effect and damages to panels. Output cables and mating connectors are safe and reliable for installation application. Adopt weather resistance, sealed, good sticky silica gel when assembling.
- Strict quality inspection on each procedure and 100% electrical performance test to meet power requirements.
- 0~+3% power tolerance.
- classification for all the panels in order to improve the integral performance of system and solar panel life span.
- TUV、UL、MCS、CE、ROHS、Golden Sun certified
- Underwriting of 25years output power warranty by The People's Insurance Company of China.
FAQ of Solar Monocrystalline Series (220W—235W)
We have organized several common questions for our clients,may help you sincerely:
①What price for each watt?
It depends on the quantity, delivery date and payment terms,
②What is your size for each module? Can you tell me the Parameter of your module?
We have different series of panels in different output, both c-Si and a-Si. Please take the specification sheet for your reference.
③Can you provide the peripheral products of the solar panels, such as the battery, controller, and inverter? If so, can you tell me how do they match each other?
Yes, we can, we have two companies for solar region, one is CNBM International, the other is CNBM engineering Co.
We can provide you not only the solar module but also the off grid solar system, we can also provide you service with on grid plant.
④What is your warranty system?
Our product performance guarantees for 25 years
• 12 years guarantee for workmanship
• Timeliness of delivery
• Quality Products certified (TÜV, UL, CE, ISO)
- Q:if i have a 0 Watt solar panel what does that mean. does that mean it will charge a battery 0 watts per hour? Lets say i hook this up to a car battery and use the car battery to run computer stuff. How much will this charge the battery?
- It will be less than a trickle charger on the battery. It is about .85 amps at 2 volts dc.
- Q:i want to build a stationary model of a solar panel and i dont know if it is going to be too simple or not i also want ideas to make it betterplease criticism is allowedmy idea was to make a case, just like a real solar panel, and take plexiglass to make it. i want to add some models of photovoltaic cells that look like they are in a solar panel . i want to add the fake shoulderings as well . i want to make the case openable by hinges.i would like some of your thoughts and ideas to help me .thx
- For a mock up model you might try a fabric store or shelf paper with a pattern that mimics solar cells. Or just find a good pic on the net and print out several copies to glue on.
- Q:Can solar panels be used for powering a concert venue or entertainment center?
- Yes, solar panels can be used to power a concert venue or entertainment center. By installing a sufficient number of solar panels, a venue can generate clean and renewable energy that can be used to power various electrical systems, including lighting, sound equipment, and air conditioning. This not only helps reduce dependence on fossil fuels but also lowers energy costs in the long run. However, the feasibility and effectiveness of using solar panels for this purpose would depend on factors such as the size of the venue, its energy requirements, and available sunlight in the area.
- Q:There is a charge controller that has what i believe to be only port for a solar/ wind turbine control panel and i don't know if it has more than port for panels. So would i be abed to link 2 panels to port or do you think the controller has more than portBTW it is for marine use.
- in case you positioned 'photograph voltaic international information' right into a seek engine, you will discover that there are a number of information that are being heavily contested. choosing up the reality from between hype is the activity. photograph voltaic panels generally have a rated optimal output of approximately one hundred ten watts consistent with squaremetre. yet relatively delivery to grids of kWh might element to a huge determination closer to fourteen watts / squareM. on a 24 hour foundation. Grid administration is for that reason careful approximately yield claims whilst history factors to in basic terms a million/8 of rated optimal output. there may be some irrelevant expectancies, whilst a photograph voltaic roof is first powering the construction, and in basic terms advertising extra to the grid.
- Q:Do solar panels require a specific orientation or angle for optimal performance?
- Yes, solar panels typically require a specific orientation and angle for optimal performance. The ideal orientation is facing south in the northern hemisphere and north in the southern hemisphere, to maximize sunlight exposure throughout the day. The optimal tilt angle depends on the latitude of the location, with a general rule of thumb being the angle should be roughly equal to the latitude. However, modern solar panels are designed to be flexible and can still generate electricity even when not perfectly aligned or angled.
- Q:what kind of rays are used in solar panels?
- Electrons----- okorder /
- Q:i am trying to get it to work on solar power They are outdoors and we dont feel like running a few hundred feet of power cables. Thanks and best answer will get 0 points.
- Only okorder /... Each battery will will need to be enclosed in a box from the weather to preserve it as well as the charge controllers. All this work can be done with success, but will be costly if that's what you want, and want it done right. You have no short cuts around this unless you want to damage your cameras? I still say it would be much easier to run conduit under ground for your power supply to each camera, and it would cost less money and time.
- Q:Pls is it ok to connect a 0watt and 20watt solar panel together into a charge controller port, can i just tie the wires together and run into the controller?? Will damage anything...Thanks guys
- Homemade okorder /
- Q:I want to buy a solar panel kit to run my central AC unit. it is a 3 ton unit. Can I do this? The electric rates in the Chicago area are skyrocketing and I can't keep paying 350 dollar electric bills during the spring and summer months
- Solar in Chicago is not much help, you would need at least 3kwh for whatever size unit you have, (3 tons is meaningless in this context!) You would not get enough sun even in the summer to operate for more thn 6 hours a day. For Chicago you probably need a wind generator, or go for a heat pump.
- Q:Can solar panels be installed on a swimming pool?
- Yes, solar panels can be installed on a swimming pool. In fact, many pool owners choose to install solar panels to heat their pools and reduce energy costs. The panels absorb sunlight and convert it into energy to heat the water, extending the swimming season and making the pool more comfortable for users.
1. Manufacturer Overview |
|
---|---|
Location | |
Year Established | |
Annual Output Value | |
Main Markets | |
Company Certifications |
2. Manufacturer Certificates |
|
---|---|
a) Certification Name | |
Range | |
Reference | |
Validity Period |
3. Manufacturer Capability |
|
---|---|
a)Trade Capacity | |
Nearest Port | |
Export Percentage | |
No.of Employees in Trade Department | |
Language Spoken: | |
b)Factory Information | |
Factory Size: | |
No. of Production Lines | |
Contract Manufacturing | |
Product Price Range |
Send your message to us
Ambient Solar Panels - Monocrystalline Solar Module ZDNY 220-235 W
- Loading Port:
- Shanghai
- Payment Terms:
- TT or LC
- Min Order Qty:
- 100 pc
- Supply Capability:
- 30000 pc/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords