Horizontal Single Phase SVC AC Voltage Regulator 5KVA
- Loading Port:
- China Main Port
- Payment Terms:
- TT or LC
- Min Order Qty:
- 1 Piece pc
- Supply Capability:
- 2000 Pieces per Month pc/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Power | 0.5kVA-10kVA(Horizontal) | 5kVA-60kVA(Vertical) |
Single phase input voltage | 70V-130V and 160V-250V | 160V-250V |
Single phase output voltage | 220V and 110V | 220V |
Accuracy of voltage stabilization | 220V±3% 110±6% | |
50Hz/60Hz | ||
1s(When input voltage has a charge of 10%) | ||
No additional waveform distortion | ||
>90% | ||
0.8 | ||
Tenperature:-5--+40 Humidity:<90% | ||
1500V/1min | ||
≥2MΩ | ||
1.5kVA-60kVA | ||
Phase voltage 160V-250V;Wire viltage 277V-430V | ||
Phase voltage 220V;Wire viltage 380V | ||
2-5% | ||
50Hz/60Hz | ||
1s(When input voltage has a charge of 10%) | ||
No additional waveform distortion | ||
>90% | ||
0.8 | ||
Tenperature:-5--+40 Humidity:<90% | ||
1500V/1min | ||
≥2MΩ |
- Q: What transformer can be used in a safety voltage lighting transformer?
- 220V/36V or 24V isolation transformer. Double winding, high and low voltage coils, not connected.
- Q: Why should lighting transformers be used in factories and mines?
- In some factories and mines (such as power plants), in order to supply power reliability, the power system is grounded in a three-phase, ungrounded, or neutral manner. In this way, the transformer must be connected to a neutral grounding type with a special transformer to supply power to the lighting.
- Q: 1000 square meters low voltage.36 volts lighting power supply with multiple transformers and wires
- First of all, make sure your power is too large, but you are not recommended to do so, the cost is too high, the pressure drop is too large, you can raise the voltage to 220V or higher, and then transfer to avoid power losses. If the direct transmission, the power is slightly larger, the line will be very rough, the cost will be very high
- Q: The difference between lighting transformers and control transformers
- A control transformer is a low voltage appliance, usually used as a power supply or part of a lighting for the control of electrical equipment such as machine tools. There are usually two different voltage outputs,
- Q: Is the substation separate from the power and illumination transformer?
- The power and lighting power supply in the substation need not be separated. In a large capacity power plant, the lighting can be electrically powered to ensure that the generator is stopped. The lighting source is often separated from the lighting transformer and powered by other power supplies.
- Q: 3 24V100W lights, I need to use a large capacity transformer (220V change 24V)?
- First look at this lamp,.24V100W, this specification is common in the headlights of large trucks, filled with inert gas, known as the small sunThe power supply comes from the generator or battery, and the mode of operation is to ignite by alternating current and direct current. In comparison with the power supply of the transformer, the method of alternating current ignition is better to save the cost and reduce the cost
- Q: Does the lighting work properly? Doesn't that power equipment start voltage unstable?
- As long as the capacity of the transformer is enough, the voltage fluctuation of the line will be sure to occur when the high power equipment is started. Such fluctuations do not have much impact on the lighting.
- Q: Why the 21 lighting transformer must double winding type safety isolating transformers, prohibited the use of autotransformer.
- So, safety regulations: lighting transformer must double winding type safety isolating transformer, prohibited the use of autotransformer.
- Q: Which is more energy saving by using 24V500W transformer lighting and 220V500W lighting?
- If the transformer is not calculated, the loss is the same. If the calculation is the latter, save electricity.
- Q: Please tell me how to calculate the transformer in the lighting circuit of elevator shaft in building electrical design
- Pe=19.5KW, installed capacityKx=1 coefficient of demandPjs=KxPe=19.5KW, calculated loadCOS, phi, =0.85, power factorIjs=KxPe/3/220/cos phi (Ijs calculates current, voltage, 380V/220V, three-phase)=1*19.5*1000/3/220/0.85=34.76A
1. Manufacturer Overview
Location | Shanghai, China |
Year Established | 2008 |
Annual Output Value | US$50 Million - US$100 Million |
Main Markets | South America Eastern Europe Southeast Asia Africa Oceania Mid East Eastern Asia Western Europe Central America Northern Europe Southern Europe South Asia Domestic Market |
Company Certifications | CE |
2. Manufacturer Certificates
a) Certification Name | |
Range | |
Reference | |
Validity Period |
3. Manufacturer Capability
a) Trade Capacity | |
Nearest Port | Shanghai Port,Ningbo Port,Guangzhou Port |
Export Percentage | 81% - 90% |
No.of Employees in Trade Department | 6-10 People |
Language Spoken: | English, Chinese, Spanish, Arabic, French, Russian |
b) Factory Information | |
Factory Size: | 3,000-5,000 square meters |
No. of Production Lines | 10 |
Contract Manufacturing | OEM Service Offered Design Service Offered Buyer Label Offered |
Product Price Range | Average |
Send your message to us
Horizontal Single Phase SVC AC Voltage Regulator 5KVA
- Loading Port:
- China Main Port
- Payment Terms:
- TT or LC
- Min Order Qty:
- 1 Piece pc
- Supply Capability:
- 2000 Pieces per Month pc/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches