H.F pipe line 140 Pipe Mill

Inquire Now

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

You Might Also Like

General Description

Material to be processed:Carbon Steel, Cold Hot Rolled pre slit strip coils of weld able grade with max. 0.2% carbon
Type of Production: * Round Tubes*Squar *Square and Rectangular Hollow Sections
Round Tube Outside Diameter: Min 32 Max 140mm
Square Hollow Section: Min 25x 25 Max 110 x 110 mm
Rectangular Hollow Section: Min 25x 40 Max 90x 130 mm
Tube Thickness: Min 1.2 Max 5.0 mm
Forming Line Speed: Max 70 m/min (Square and Rectangular Hollow Shapes are produced at lower speeds depending on side to wall thickness ratio)
Tube Cut Length: Min 4 Max 12 meter
Length Accuracy: ± 3mm
Drive Motor: DC 110kW +110kW

Line Composion

Q: A roll forming machine, rolling out of the length is always not up to a fixed size, not too small, that is, more than that, what is the cause?: Yes, the width of the bearing plate can be a deviation from the length.

Q: What is rolling forming processing?: A special rolling tool is used to exert certain pressure on the surface of the workpiece so as to make the surface metal flow.

Q: Improvement in rolling forming process: Rigid force, 1000N-3000N, damage to the guide rail of machine tool transmission mechanism, seriously damage the accuracy and life of machine tools.

Q: Introduction of roll forming process: With the progress of technology and the development of production, more and more attention has been paid to the roll forming process.

Q: What kind of material and what heat treatment are used for pressing roller (molding, feeding, cutting force, heavy load, heavy load) of sheet steel rolling machine?: Generally speaking, to consider the use of rollers in the requirements, including: 1., good wear resistance, 2. toughness, 3., high hardness, 4. hardened layer (easy to wear after repeated repair)

Q: What is the surface rolling forming machine process?: Due to the rolling surface of metal plastic deformation, so that the surface microstructure of cold hardening and grain refinement, forming a dense fibrous, and the formation of residual stress, hardness and strength, so as to improve the surface wear resistance, corrosion resistance and compliance.

Q: Process mould for rolling forming process: A movable wire plate, made of the same fixed wire plate, for relative reciprocating motion. Roll forming is the design of different structures on the plate rolling on the workpiece. Roll out all kinds of thread, convex ring, knurling, end chamfering, groove with different width and thickness as well as other required shapes.

Q: Material and equipment for roll forming process: Rolling molding is usually through upsetting a blank cold heading machine, thread rolling machine rolling after processed. The equipment for thread rolling and rolling forming includes various reciprocating flat rolling machines, planetary wire rolling machines, two cylindrical roller spinning machines and three cylindrical roller spinning machines.

Send your message to us

*Email

*TEL

*Quantity

*Unit