DIN EN 857 1SC Hydraulic Hose DN6

Inquire Now

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

You Might Also Like

Q: SolidWorks how do you put rubber hose on the iron pipe?: This is to be made into an assembly. First, parts, iron pipes and rubber pipes are made separately, and then the assembly is made to fit together.

Q: How long is the service life of the gas hose?: The protection work is very important, regular replacement of gas hose and make use of the gas hose gas pipeline safety in general, the gas hose has a life span of two years, usually pay more attention to inspection / check whether the aging hose, wear, corrosion or bad connection, avoid leakage.

Q: What's the detailed size of hose connection for shower?: Hot and cold bath: take a bath with hot water before going to bed every day. The temperature of the water is within the limits of the body's tolerance. After washing, sleep in hot water for 15 minutes. After bathing was out of a sweat, after 3~4 minutes, and then into a basin of cold water or cold shower. Note that the hot and cold bath must be "hot before cold."".

Q: The principle of the common bicycle valve: The main body of the valve core is a small upper end hollow and solid cylinder at the lower end, and a small hole is opened at the lower end of the lower end to connect with the hollow part.

Q: Acid burette and how to distinguish the basic buret: The following is a rubber tube acid basic titration burette is below the piston

Q: Can high speed air flow through a rubber tube and produce static electricity?: As a result of friction, high velocity flow of gas through the rubber pipes will produce static electricity.

Q: How can the rubber tube be used properly and how to use it properly?: Hose selection and installation caused by improper hose rupture. When replacing the hose, the hose wire length, number, shape and size of the joint should be reasonable, and should try to reduce the degree of bending in the hose; tighten union nut, do not make the hose distorted, excessive bending and twisting will reduce the service life of the hose greatly; some easily friction parts should take protective measures to prevent the hose due to wear and burst.

Q: How often do the oil - resistant rubber pipes undergo atmospheric pressure testing?: Low temperature bending test at low temperature: hose clamp on rigid torsion wheel diameter hose diameter 12 times, for 6 hours at a low temperature, twisted 180 degrees within 12s when the measured torque and the standard temperature measured torque ratio. Low temperature bending: hose clamped in the diameter of the hose within 12 times the torsion wheel, parked at low temperatures for 24 hours, in the 10s to reverse 180 degrees, check whether or not the internal and external plastic brittle fracture and damage. Test of low temperature brittleness measurement hose is the most simple specimen should be bent 90 degrees at low temperature, or a hose after freezing compressed 1/2 to see whether the embrittlement, another method is to use a certain weight of the heavy hammer falls freely, to see if the specimen embrittlement impact specimen.

Q: What kind of material does hose screw protection cover have? What are their advantages and disadvantages?: The utility model relates to a pipe protecting sleeve, which is a new product replacing the traditional metal protecting spring used for the protection of traditional rubber hoses. Alias: hose sheath, rubber tube outside protection special nylon spiral sheath, etc..

Q: How do I get the hose for the gas cooker?: Clean the stove inlet, then hose joints and joints into the stove over the red, with a pipe clamp or hose clamp hoop.

Send your message to us

*Email

*TEL

*Quantity

*Unit