DIN EN 857 1SC Hydraulic Hose DN13

Inquire Now

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

You Might Also Like

Q: Why should the high pressure hydraulic tube peel off the outer skin?: Reasons for stripping:1, the inner diameter of the sleeve is a standard series, and a little rubber hose is not suitable for sizing.2, after stripping, the sleeve can be directly pressed on the steel wire layer, the connection is reliable, and it is not easy to pull out.

Q: What is the function between the rubber pipe joint and the installing pipe?: The action of the rubber pipe joint on the installation of pipes:1. Small size, light weight, good elasticity, easy installation and maintenance.2. After installation, the transverse, axial and angular displacement of the pipe vibration can be absorbed. The pipe is not concentric and the flange is not parallel.3 、 after installation, it can reduce the noise caused by vibration of pipes, pumps and so on, and has strong vibration absorption ability.

Q: How far is the gas cooker from the gas riser in the kitchen?: Rubber hose for gas shall use oil resistant rubber hose, length of 1.2-1.5 meters, length not exceeding 2 meters.

Q: Can the natural gas hose not exceed 1.5 meters or 2 meters?: The gas hose on the principle of not more than 1.2 meters, and regularly check the technical requirements, 1-2 must be replaced if the temporary gas can also be longer, if long-term use, as far as possible the use of metal pipe joint and the gas stove can also use metal hose, high safety factor.

Q: Standard for implementation of type KXT-1 rubber joints: This product can reduce vibration and noise, and can be compensated by thermal expansion and cold contraction due to temperature changes. It is widely used in various piping systems. Rubber joint manufacturing standard CB-T 965-95 CJT208-2005 to take over the compensation rubber flexible rubber joint CJT 3013.1-1993 KST flexible rubber joint

Q: Can high speed air flow through a rubber tube and produce static electricity?: As a result of friction, high velocity flow of gas through the rubber pipes will produce static electricity.

Q: Faucet hose connection problem: It is recommended to buy two kinds of hard bellows, soft metal hoses (black silk stripes). When the metal hose is installed, the joint should be horizontal or vertical, and the water pipe and gasket are not sealed properly. It will leak and do not need to be eaten with raw material.

Q: What are the rubber pipe joints perfectly joined to the pipe fittings?: But Hong Sheng rubber hose connector is the main performance of good elasticity, the best damping effect, it is this performance can make the perfect combination of equipment and pipe

Q: Do you need a hose connection to connect the ventilation pipe to the exhaust fan? Under what circumstances? Under what circumstances?: Must be added, never heard without the place, the wind turbine operation produces vibration, and galvanized sheet steel pipe is fixed at a certain place, if not, fan vibration, wind pipe vibration, the wind tube life are not long.

Q: What's the smell of petrol in the car and the trunk?! Especially after a long drive!: Have changed the gasoline pump, or because of the failure to disassemble the steam pump owners, if the car appeared gasoline, do not panic, this is because after the disassembly and assembly, the residue is not cleaned up. In fact, this situation is usually not met, the gasoline pump replacement cycle is 100 thousand kilometers. But now the gasoline filter is also installed in the tank, connected with the gasoline pump, and its replacement cycle is shorter, 40 thousand km, when the replacement of gasoline pump disassembly. In this case, just look at the gasoline pump installed is not correct, in cleaning the perimeter can be.

Send your message to us

*Email

*TEL

*Quantity

*Unit