Capacitor For Solar Inverter

Hot Products

FAQ

What is the difference between the reactor and the capacitor?
Reactor is the inductive load, there are series and parallel in series, the series is mainly used to limit the short-circuit current, parallel mainly used for ultra-high voltage long-distance transmission, the compensation line capacitance. Capacitors are capacitive loads that are used primarily to compensate for reactive and energy storage. Inductance and capacitance combinations for filtering and so on.
How to identify high voltage capacitors is good or bad
You have no voltage regulator, if there is, with a voltage regulator, an ammeter a voltmeter (available multimeter instead) to the capacitor plus an integer current (controlled by a voltage regulator), and then calculate the capacitance based on the voltage reading and current reading Impedance, and then divided by 3184 calculated by the tolerance value, the results and the capacitor nameplate on the standard almost no capacitance, and the other side of the capacitor is broken
What is the phase-shifting capacitor, what is the difference between it and the general capacitor
Assuming a capacitor has upper and lower poles, the upper plate is connected with the positive pole, the lower plate is connected with the negative electrode, connected with the power source, the potential difference between the two plates is formed, and the potential difference between the two electrodes is equal,
Why does the circuit current gradually decrease when charging the capacitor?
due to the increase in the number of charge, the electrostatic field field strength will gradually increase, increasing the field strength caused by the absorption of electrons to produce exclusion, So that the number of adsorbed charges gradually reduced, the number of charge to reduce the performance of the phenomenon that the charging current is gradually reduced. When the number of charges on the two electrode plates of the capacitor reaches a gradually increasing field strength constraint, the amount of charge is not increased and the equilibrium state is reached, that is, the charge saturation current is zero.
What is the difference between polyester film capacitors and ceramic capacitors?
Ceramic dielectric (type CC) ceramic material dielectric constant ε is very large, so the capacitor volume can be made very small.
Why some Y capacitor is very small, and some Y capacitor is very large?
They all belong to the safety capacitor, which requires the capacitance value can not be too large, and the pressure must be higher. Under normal circumstances, work in the subtropical machine, the required leakage current can not exceed 0.7mA; work in the temperate machine, the required leakage current can not exceed 0.35mA. Therefore, the total capacity of the Y capacitor is generally not more than 4700PF (472).
What is the difference between the power capacitor and the complement?
In fact, in the case of three-phase imbalance, but also a total complement and sub-all have, the three-phase power factor, respectively, 0.53,0.67,0.71, then, in the 0.71 above this part, The reactive power required by the other parts of the two phases is compensated by tipping.
Is the capacitor attached to the carbon foil positive?
The negative electrode of the capacitor is made of electrolyte, the electrolyte is generally composed of boric acid, ammonia, ethylene glycol and other components.