Volvo Generator sets
- Ref Price:
-
- Loading Port:
- China Main Port
- Payment Terms:
- TT OR LC
- Min Order Qty:
- -
- Supply Capability:
- -
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Control panel options:
1. Manual starting system with low oil pressure, high water temperature, over speed,
emergency stop and re-install protections.
2. Automatic starting system with LED display and auto-connect to Main power after outage.
3. Parallel control system
4. Remote control, measure, communication control system.
Test Before Shipment
1. Each Generator Set shall be put into Testing more than 4 hours totally, tested on idleload, fully
load and 10% overload.
2. Noise level shall be tested.
3. All of the meters on the control panel shall be tested.
4.The appearance of the Set and the label, nameplate shall be tested. "Voltage available:
50Hz: 380-400-415V/ 220-230-240V; 60Hz: 220-380-416-440-480V/ 110-208-220- 240V.
Any special voltage is also available as client's request.
Packing & Warranty
Packing: Wooden, Plywood or Metal Case.
Delivery Time: Less than 15 working days after receiving prepayment.
Warranty:
One year or 1, 000 hours from the date of shipment
(15 Months or 1, 200 hours for Alternator Part).
Payment Terms:
L/C & T/T ( 30% deposit and 70% balance before delivery)
- Q: What is the normal value of the engine intake manifold vacuum?
- Vacuum meter to measure the vacuum of the intake manifold, idling vacuum gauge pointer in 45 kPa outside the swing back and forth, the engine running vacuum table readings dropped to 37 kPa, it was diagnosed with a cylinder valve seal bad.
- Q: What kind of engine is oil efficient?
- Drag coefficient - the new models tend to be smoother, but in addition to improving visual performance, it is also important to reduce wind resistance. Many people think that wind resistance is only a tiny technical parameter, but in practice it has a lot to do with fuel consumption. Generally speaking, when a vehicle travels at high speed, the biggest resistance comes from the air. Therefore, even if the drag coefficient is reduced by 0.01, fuel consumption will also bring about great difference.
- Q: Does the car change natural gas to the engine?
- In the aspect of engine structure, the main factor that determines the engine power is the compression ratio of the engine. The greater the compression ratio, the higher the thermal efficiency, the greater the effective power. At the same time, the greater the compression ratio, the greater the tendency of the engine to knock. Therefore, the engine compression ratio must also be adapted to the antiknock performance of the fuel. The antiknock performance of gasoline determines that the compression ratio of gasoline engine can not be too large, but the antiknock ability of natural gas is very good, and it can be used to compress relatively large engine, thus increasing its power.
- Q: The high-end car's engine is made of aluminum or cast iron
- Now, the aluminum engine has been used in a large number of models, in foreign countries, Rover's k series engine, BMW M52 inline six-cylinder engine, Nissan's VQ engine, Jaguar-AJ-V8 engine, Mercedes-Benz V6 and V8
- Q: What is the relationship between the clutch and the engine of a car?
- Clutch, Gu thinking, is to play the role of isolation and closed. That is, the clutch of engine and wheel drive. That is to say, when you press the clutch, then the engine's drive is disconnected from the wheel, and the engine's power doesn't reach the wheel to drive the car.
- Q: Doosan engine model
- Komatsu or can, the hydraulic system is the best, that is too dry work, and can not dry live, dig a earth still ok.
- Q: What's the order of ignition for a 4 cylinder gasoline engine?
- Four cylinder engine ignition sequence, only 1243 or 1342, because 14 of the same position with 23 position is collocated. Ditto with, but the difference between the two stroke and four stroke, the intake and the work is moving downwards, compression and exhaust is moving upwards, you say the mixture of air and fuel into the 1 cylinder after compression in the 1 stroke cylinder is 3 cylinder, you may understand is a cylinder with a stroke, is the essence of each cylinder has four stroke, when they can't work in the same stroke at the same time,
- Q: What is the reason for the decrease in engine power?
- Poor tire pressure is also one of the reasons that affect the decline of automobile power, especially when the tire pressure is not enough and the number of passengers is more. Therefore, when filling the tire, must add enough, should be in accordance with the body marked by the tire pressure table for filling
- Q: What are the two major structures of an engine?
- The gas distribution mechanism and crank linkage valve mechanism comprises a valve group and valve driving group. The valve group was divided into the valve exhaust valve valve spring valve spring valve lock valve transmission group by hydraulic tappet cam rocker rocker shaft
- Q: What is the difference between the car's brake and the engine brake?
- Simply put it: cars often say that there are three kinds of braking, 1. driving brake.
Send your message to us
Volvo Generator sets
- Ref Price:
-
- Loading Port:
- China Main Port
- Payment Terms:
- TT OR LC
- Min Order Qty:
- -
- Supply Capability:
- -
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords
