T8 LED Tube 120CM 20w 1700lm Three Years Warranty CRI 70-75 CLEAR COVER PF0.5

Inquire Now

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

You Might Also Like

Main Technology Index:

Q: The LED fluorescent lamp tube breaks the LED light in the inside: The lamp tube of LED fluorescent lamp alone is ok, inside you should see an aluminium base board, above be full of patch small lamp bead.

Q: Put on the new light bulb, why the lamp still not bright: Does your fluorescent lamp use a inductive ballast or an electronic ballast? Is the newly installed lamp tube not bright or filament red but unable to start? If the inductor is completely unlit, check to see if it is installed

Q: How does barton fluorescent lamp holder replace led lamp tube: LED lamp installation has a variety of methods, one of the most common is the old bracket of rectifier and remove the starter, then put in two wires direct access to the ends of the lamp holder.

Q: The Led is good, or the t5 lamp is good: The lamp is easy to use, the failure rate is low but the brightness is not as bright as t5. The lamp tube has a higher failure rate, higher cost! But the effect is greater than the lamp band.

Q: If the body is accidentally broken, will it be electrocuted?: It's possible to do it but just don't touch the tungsten in it. If it's on, your body will burn!

Q: How is the T8LED fluorescent lamp installed?: Installation is simple, make sure your lamp is single head unipolar or bipolar, single head the two ends of the finished confirm the lamp holder as you the polarity of the two ends of the lamp connected wires, and then directly card directly into the lamp inside

Q: Do not have the fluorescent lamp of actuator, how to change LED lamp tube?: Want to change LED lamp to match, the piece of fluorescent lamp is not usable.

Q: How do fluorescent tubes clean: Use alcohol as a wipe.I hope my answer will help you

Q: Why don't leds need a rectifier: Because LED is a direct current is needed to light, and the output voltage of rectifier is an alternating current, so can't use rectifier, now LED lamp is built-in power inside, and use it every time you'd better put fluorescent original rectifier and demolition of the starter, but given the easy to use, now LED lamp can be directly on the original fluorescent lamp holder, do not need to disconnect the rectifier, only need to send a link of the starter circuit cut. Because the regenerator will provide an instantaneous high voltage, it will damage the LED

Q: Led lamp tube t8 good or t5 good: The specification of fluorescent lamp is the diameter of tube, length. Look at your lighting requirements, T8 pipe size, of course, the light effect will be better, the same length of lamp tube T8 will be more than twice as bright as T5, and the brightness is much better. The quality of the lamp is not so good at present. The main view is lamp tube with light, electric power and heat dissipation processing.

Send your message to us

*Email

*TEL

*Quantity

*Unit