Steel Plastic pipe Mill / 102 Pipe Mill
- Ref Price:
-
- Loading Port:
- China Main Port
- Payment Terms:
- TT OR LC
- Min Order Qty:
- -
- Supply Capability:
- -
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Specification
Line Composion
|
- Q: A roll forming machine, rolling out of the length is always not up to a fixed size, not too small, that is, more than that, what is the cause?
- According to my experience, there should be a problem with the boot encoder (also known as the digital wheel). Thank you. I hope I can help you.
- Q: What is rolling forming processing?
- Ironing the surface of the workpiece with a raised micro wave crest to fill the concave micro troughs, thus changing the distribution of the peaks on the surface, and obtaining smaller surface roughness values.
- Q: Improvement in rolling forming process
- Can not meet the slender rod, thin-walled tubes and other rigid parts of the processing.
- Q: Introduction of roll forming process
- With the progress of technology and the development of production, more and more attention has been paid to the roll forming process.
- Q: What kind of material and what heat treatment are used for pressing roller (molding, feeding, cutting force, heavy load, heavy load) of sheet steel rolling machine?
- Non bonding wear of rolled material (especially stainless steel strip, etc.)
- Q: What is the surface rolling forming machine process?
- Different from cutting, mirror rolling is a kind of plastic processing. Not only is the rolling workpiece surface roughness moment can reach Ry0.1-0.8 m, and the wear resistance of the surface hardening process has been improved at the same time fatigue strength also increased 30% advantages in cutting can not get.
- Q: Process mould for rolling forming process
- Rolling forming is more complicated and requires higher than rolling thread. The die design is based on the different shapes of the workpiece, the design of the rolling plate into a cross section or a few sections, can use synchronous type; also can use grading type.
- Q: Material and equipment for roll forming process
- The most common type of roll forming is reciprocating flat wire twisting machine. Therefore, for the manufacturers of cold heading machines and screw rolling mills, the design of rolling dies is only a matter of design.
Send your message to us
Steel Plastic pipe Mill / 102 Pipe Mill
- Ref Price:
-
- Loading Port:
- China Main Port
- Payment Terms:
- TT OR LC
- Min Order Qty:
- -
- Supply Capability:
- -
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords
