SAE 100 R1AT / DIN EN 853 1SN DN12

Inquire Now

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

You Might Also Like

Q: What should I pay attention to when rubber tube is in storage?: Storage should be as follows: (1) should be stored in a ventilated and dry environment, the relative humidity of the air is 50% ~ 80%. (2) should be stored in non corrosive media, and away from the heat source, the temperature is about 5 degrees Celsius conditions. (3) packing should be kept as far as possible without box stacking.

Q: Why should the high pressure hydraulic tube peel off the outer skin?: High pressure hose is generally relatively thick, there are steel wire layer, the purpose of peeling is to connect the tooth and steel layer close combination, the joint is more solid. But not all high-pressure hose needs peeling. Now many large companies do not need peeling. For example, pike.

Q: What does the letter of the high-pressure tubing connector mean?: High pressure oil classification: high pressure wire braided hose, high pressure hose winding wire, large diameter, high pressure hose steel wire (fiber) reinforced nylon elastomer resin pipe, steel wire reinforced soft, high-pressure hose, hose, high temperature resistant polyurethane hose.Structure: high pressure oil pipe consists of steel wire winding skeleton layer and internal and external oil resistant rubber, corrosion resistant synthetic rubber and weather resistant special rubber.

Q: How can we prevent the aging of rubber tubes?: Formula design is the most important. Rubber formula design is directly related to the service life of the product!

Q: How to install the water hose and do you use the tape? Or direct installation?: The pipeline key fixed: if it is not fixed, at the disengaged joint under the action of water pressure, or joint fixed point is the best, because only the most effective joint will be fixed, hard tube and building reliable fixed connection, can guarantee the normal use of the time to extend the hose.

Q: How can the hose of natural gas be connected to the water heater?: The gas source is connected with a gas water heater by using a flexible stainless steel bellows, and the ends of the pipe are pressed into bell mouths by special tools, and two movable nuts are pre sheathed. Connect one end of the pipe to the outlet of the gas meter (tighten the nut), and the other end is connected to the gas inlet of the heater (screw another nut) so that the connection between the gas pipe and the water heater is completed.

Q: What kind of material is the rubber tube with acid, alkali and high temperature resistance made of?: Silicon rubber tube, also known as silicon rubber tube, ordinary silicon hose can withstand temperature of 250 degrees, high temperature resistant material of silicon hose can reach about 350 degrees. And its tear resistance and elasticity are very good. It is widely used in high temperature environment. If you don't understand, you can ask me

Q: How to make sure the rubber hose will not be worn off?: This depends on experience, not carefully measured out of the value is also a great error

Q: Is the installation of submersible pumps mandatory for the installation of flexible rubber joints?: Deep well submersible pump must be equipped with steel pipe, water pipe.Submersible submersible pump, such as submersible sewage pump, according to the use of requirements, consider whether to install the flange connection form, Song River rubber soft joint, so it is not necessary.

Q: The rubber is sheathed on the metal cylinder. How can it be connected?: With the combination of metal rubber is coated with adhesive before production and rubber vulcanization shaping, you can use this temporary experiment 502 geliahao for glue or adhesive, but the disadvantages of this thing with winter is not strong, the metal surface must be clean

Send your message to us

*Email

*TEL

*Quantity

*Unit