SAE 100 R1AT / DIN EN 853 1SN DN32

Inquire Now

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

You Might Also Like

Q: What is the essential difference between rubber expansion joint and rubber joint?: Nothing different.The metal bellows joint and the rubber soft joint have their respective advantages.Under normal working conditions, there is no problem with rubber soft fittings.If the temperature of the pipe medium is high, the pressure is large and the corrosion is strong, the metal bellows expansion joint must be chosen in this case.

Q: The maximum number of joints for a rubber hose is no more than: Shower hose, shower hose, two joints are nominal diameter of: 1/2 inch (4 thiophene) cylindrical pipe thread. Standard component. Hot and cold bath: take a bath with hot water before going to bed every day. The temperature of the water is within the limits of the body's tolerance. After washing, sleep in hot water for 15 minutes. After bathing was out of a sweat, after 3~4 minutes, and then into a basin of cold water or cold shower. Note that the hot and cold bath must be "hot before cold."".

Q: Acid burette and how to distinguish the basic buret: The following is a rubber tube acid basic titration burette is below the piston

Q: Toilet hose and water tank joints leaking, how to repair?: Remove the joint, wrap the tape, and press again

Q: Petroleum gas has a corrosive effect on ordinary rubber pipes and is easy to cause air leakage. So, what kind of hose must be used?: Petroleum gas is corrosive to ordinary rubber pipes and gaskets and easy to cause air leakage. Therefore, it is necessary to use rubber pipes and gaskets with strong oil resistance

Q: The use of anti slip rubber joints under what circumstances?: Flexible rubber joint is normal for medium temperature water at 0-60 DEG C, such as special medium: oil, acid, high temperature and corrosion resistance and other hard conditions, should use special refractory material rubber joints should be relatively, not blindly on or in general.

Q: How can the hose of natural gas be connected to the water heater?: Both ends of the hose nut with inlet joint head directly said water heater, the key is the nut inside with sealing ring can not forget the good, but also to the right, after tightening will not leak, then good with soap and water leak, do not bubble. But you must point out that the safety requirements can not be connected to the general hose, should be connected to the hard tube (Bai Tieguan), temporary answer, we must pay attention to safety.

Q: Three yuan ethylene propylene rubber joint (high temperature resistant rubber joint) can withstand high temperature: High temperature rubber joint adopts three yuan ethylene propylene rubber processing, can withstand high temperature 140 degrees, if need higher temperature, need to use fluorine rubber, the highest temperature can reach 200 degrees!

Q: Method for connecting glass tube and rubber tube: Put the glass tube wet with water, and then put the rubber tube water preheating, now holding a glass tube, a hand wring rubber tube, you can complete the glass tube and a rubber tube connection.

Q: What's the difference between a silicone tube and a rubber tube?: The main performance of the rubber tube: rubber tube is non-toxic, environmental protection, physical inertia, UV resistance, ozone resistance, resistance to high temperature (-8 to 300), high transparency, strong resilience, resistant to compression permanent deformation, oil resistance, impact resistance, acid and alkali resistance, wear resistance, flame resistance, voltage, conductive properties.

Send your message to us

*Email

*TEL

*Quantity

*Unit