PVC Ceiling Temperature HDPE Sheet with Best Price

Ref Price:

Loading Port:: China Main Port

Payment Terms:: TT OR LC

Min Order Qty:: -

Supply Capability:: -

Inquire Now

Add to My Favorites

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

Specification

Description

PE Panel/Board/Sheet, PE Solid Panel/Board/Sheet, PE Rigid Panel/Board/Sheet

Length:

Any Length

Thickness:

1~20mm

Surface

Glossy, textured available upon your design

Colors:

natural, grey, red, white, black, yellow, blue, green etc. available upon request

Width:

Width range
0~1300mm
0~1500mm
0~2000mm

Thickness Available
2~20mm
2~10mm
2~4mm

Density

KS-HDPE
A+ grade:0.97
A grade:0.98

KS-LDPE
A+ grade:0.92
A grade:0.93

Features

PP SOLID SHEET	PE SHEET
1) Good heat-resistant performance (+120℃)	1) Not chip, crack, peel or break in very cold weather (-20℃)
2) Excellent formability	2) Vacuum and heat formable grades available
3) Excellent chemical and corrosion resistance
4) High impact strength
5) Low moisture absorbability, non-toxic
6) Very Good welding and processing properties
7 Excellent electrical insulation
8) Good abrasion resistance

Q: Can PVC be used for automatic painting?: Can use. PVC sheet surface can be painted, but must be on the surface of the sheet after the hair (with sandpaper to play again) in order to make the film better "adhesion" on the surface of the plate, and the best use of anti- Paint type.

Q: Whenever we run hot water in the kitchen (faucet or dishwasher), a loud knocking noise comes from the PVC pipes in the basement. It seems to be coming from the main drain pipe which is about 3 or 4 inches in diameter, and it knocks right along the ceiling joists. After a few minutes the knocking stops. Any suggestions?: Any knocking in water pipes is generally associated with the water hammer effect that results from the sudden changes in pressure within the pipes when a faucet or valve is opened and closed. This may be eliminated by installing a commercial hammer arrestor. The other possible and just as likely of a culprit is a worn out flat washer on a faucet. The flat washer which is generally made of neoprene will wear very thin and begin to flap when running the faucet. If you get the hammering when any faucet is turned on or off it is most likely needing a hammer arrestor. If the problem is localized, or at only an individual faucet it is most likely needing a new valve seat and washer.

Q: how to build cat cages out of PVC pipe?: Pvc Cat Cage

Q: Metal and PVC board how to use what bonding: With ordinary strong glue on the line. Strong adhesive is an industrial adhesive, containing organic solvent toluene, storage canned or tube and other containers. Strong glue name In fact, about 6 square centimeters of adhesive can be more than a ton of things stick. Mainly in its main ingredient, cyanoacrylate (C5H5NO2, often used as a chemical buffer).

Q: Looking at my exposed ceiling in the basement, I see two copper pipes coming out of the water heater, one marked in blue (assuming cold) and one in red (hot). These each split between supplying the upstairs and downstairs.After the split, there are galvanized steel pipes. I get great water pressure downstairs in the utility sink and clothes washer.Upstairs, pressure to the dishwasher, kitchen sink, and bathroom shower is terrible. It takes about 10 full seconds to fill a pint of water in the kitchen. You can imagine how long it takes to get a sink full of soapy water.Showers are annoying too with lack of pressure. I'm thinking I'll bring a plumber in to replace the piping to the upstairs. With a very amateur eye, I see about 10-15 total feet that'd need replacing.Is replacing it the answer? Or might there be something that could be locally repaired?Any estimates on cost for this?: if the pipes are in good working order than i wouldnt bother replacing them. the problem is the water pressure is not good enought to push the water up at an increased speed. you will need to instal a water pump to increase water pressure, these arent very expensive look between ?100 to ?200 for a decent one, then say 4 hours of plumbers labour costs at roughlt ?80-?100. the pump will need an electrical feed so the parts for that and electricians labour costs. be careful though as higher water pressure may bring out leeks that u didnt know were there as older pipes sometimes cnt stand the new high pressure.

Q: Before the home decoration Pvc board, now want to get rid of, directly stickers can be wallpaper, or other methods? Do not remove Pvc board paste what can: PVC board above certainly can not paste the wallpaper, one paste will not be long; Second, PVC will generally have seams! It is certainly unreasonable to paste the wallpaper on such a wall. Do not know your home PVC board is what kind of? If all the indoor use of PVC board is not environmentally friendly ah!

Q: In the home improvement of the kitchen with the best material, is the aluminum plate is good, or PVC board or aluminum plate is good: Aluminum buckle board of good quality, durable deformation, but the price is relatively high. Home decoration ceiling is a common part of home improvement. The ceiling is different according to the material of the decorative plate, and the classification is not the same. Ceiling decoration materials is the main basis for distinguishing the name of the ceiling, mainly: light steel keel gypsum board ceiling, gypsum board ceiling, mineral wool board ceiling, plywood ceiling, profiled long strip of aluminum slab ceiling, Glass ceiling, aluminum honeycomb perforation sound-absorbing panels such as ceiling. In the whole room decoration occupies a very important position on the top of the room for the appropriate decoration, not only to beautify the indoor environment, but also create a colorful interior space art image. In the choice of ceiling decoration materials and design programs, to follow the two materials, solid, safe, and beautiful, practical principles.

Q: What is the ignition of PVC?: Generally about 256 ℃, the special temperature of 800 ℃.

Q: Is pvc board insulator?: Seemingly no absolute insulator!

Q: Pvc plate density (g / qm): 1,4 - 1,5. The Which unit (g / qm) qm is what does that mean?: The body or gas is also used in kilograms per liter (kg / L), g per milliliter (g / mL)

Send your message to us

*Email

*TEL

*Quantity

*Unit