Q:FANUC Oi MC hand wheel failure how to solve ah? Put the MITSUBISHI M70 system is good, on the FANUC move it will not work. Reboot and just move

1. check whether the DC5V voltage is supplied by hand wheel.2., the handwheel of the cable that end, generally connected to the I/O board JA3 socket, to see whether the plug is loose.3. whether the hand wheel cable is broken?. (usually not.).4. hand wheel wiring: +5V, 0V, HA, HB, do not answer the wrong.

Q:A gas Chi Chi sound, hand in hand can feel the place

The valve diaphragm should be broken, so the leakage, to change a ring, Chi Chi is quite serious

Q:What is the handwheel mode above the SIEMENS NC panel?

The handwheel mode is the hand wheel state by which the key is switched. If your device is equipped with a handwheel, press this button to control the movement of the corresponding shaft of the machine by hand wheel. If it is not equipped with a hand wheel, this key is useless.

Q:I use delta handwheel, PLC, and positioning module to control servo motors. Why does the handwheel turn or turn the motor in one direction?.

See if the wiring is in line with the instructions

Q:Would you please tell me which brand of electronic hand wheel is good for CNC machine tools?

Usage is the same, that is, the model is not the same, different functions

Q:I want to add a stepping motor or servo motor to my M7130 grinder on the handwheel so that he can realize automatic feed. How can I achieve this?

Then look at the tool holder on the lathe

Q:Fanuc vertical machining center, manual three axis moving normal. Handwheel XY moving normal,.Z axis does not move, why?

Overshoot: hold the fast middle button and press Z negative.Z axis lock: Z axis lock buttonMotor lock: above the main shaft, the shield is open and a red button is detected.If pneumatic, check pneumatic switch and air pressure

Q:Does the servo drive have an electronic handwheel interface?

Yes, that's the encoder interface

Q:How do I use the hand wheel of this lathe?

One is to adjust the tool, the left and right, is to adjust the tool before and after

Q:What is the handwheel of the valve?

The handle or round wheel that drives the valve switch