DCI Lift Check Valve for Drinking Water
- Loading Port:
- China Main Port
- Payment Terms:
- TT OR LC
- Min Order Qty:
- -
- Supply Capability:
- -
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Specifications
Good quality and performance,cost-effective,ligher and smaller in comparison to a conventional swing check valve or lift check
Technical Data
DN40-DN600mm PN1.0-1.6MPa
Body: Cast Iron, Ductile Iron, Carbon Steel, Stainless Steel
Seat: EPDM, NBR,Stainless Steel
Stem: Stainless Steel
Disc: Ductile Iron with Nickel Coating,Ductile Iron with Nylon Coating, Stainless Stee 304/316l, Alu-Bronze
Spring:Stainless Steel
Flange Connection:DIN,ANSI,BS,JIS,UNIVERSAL FLANGE
Product Features
Wafer body style fit between FF or RF flanges
Upper and lower PTFE thrust washers
Resilient Buna-N or EPDM Seat
Dual plate valves give maximum strength with minimum opening time
Torsion springs assist valve closure, preventing flow reversal
Thrust washer reduce friction and wear of valve plate hinges.
- Q: Kitchen double hot and cold faucet bad, how to unload from the stainless steel dish?
- Remove the stainless steel pots on the faucet steps are as follows, detailed: see the basin below the two hoses, one by one unloaded; then remove the basin below the fixed nut: the faucet will be removed from the basin:
- Q: Kohler faucet on the top of the bubble where to sell
- Go to the Kohler store to buy
- Q: Is the size of the washbasin single-hole double-hole faucet the same?
- Pitch is the center of the standard 10 cm, is the same
- Q: Wash basin basin inside the two pipes how to split
- First remove the two pipes, and then in the basin below the fixed faucet can be removed on the red cap.
- Q: I have a deep sink and a high faucet. When the water is turned on to wash hands water gets all over the counter no matter how careful I am. Is there an adaptor that I can add to the end of my faucet? Thanks
- come back on here with the type of sink, on of those Britta drinking purifier things will make it so there is much less water coming out, or buy a new one
- Q: What is the faucet in the basin?
- There is no water outlet and water leakage: when the faucet within the axis of the gasket wear will appear this situation. Solution: Select the corresponding pliers according to the size of the faucet to tap the faucet gland, and remove the wear of the shaft with a clip, and then replace the new pad to solve the problem.
- Q: Heating faucet single switch and double switch which is good
- Look at your own needs. If you have more questions, you can click on ID consultation.
- Q: Wash basin faucet is too low, can not shampoo how to do
- The faucet is too low, only a little higher taps, no other way.
- Q: Kitchen hot and cold water faucet, how to repair? The faucet can be rotated 360. Handle and spool I can remove it. The leaking part is the faucet and the gap of his last section. How to remove the faucet faucet quincy arrogant horny buddy ketone? Question added: 360-degree rotation that section below the base is difficult to screw down, what tips? More
- Kitchen hot and cold faucet leak, you can change the pad or new products. First, the reasons for failure: 1, the general hot and cold water faucet water leakage, are due to the use of time, faucet inside the gasket aging, wear caused. Second, the maintenance method: 1, just open the faucet put on a rubber or silicone pad on the line. 2, just buy a new faucet spool on the line. 3, direct replacement of the faucet.
- Q: Kitchen faucet always close tight, leaking, what is the reason?
- You put the faucet down, there is a rubber pad, and then to repair the bike there is still a cut off on the OK
Send your message to us
DCI Lift Check Valve for Drinking Water
- Loading Port:
- China Main Port
- Payment Terms:
- TT OR LC
- Min Order Qty:
- -
- Supply Capability:
- -
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords