• Car Solar Panels - Monocrystalline 15W Solar Panel System 1
  • Car Solar Panels - Monocrystalline 15W Solar Panel System 2
Car Solar Panels - Monocrystalline 15W Solar Panel

Car Solar Panels - Monocrystalline 15W Solar Panel

Ref Price:
get latest price
Loading Port:
SHANGHAI
Payment Terms:
TT or LC
Min Order Qty:
-
Supply Capability:
10000000 watt/month

Add to My Favorites

Follow us:


OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

Description: 

Solar modules use light energy (photons) from the sun to generate electricity through the photovoltaic effect.

The majority of modules use wafer-based crystalline silicon cells or thin-film cells based on cadmium telluride or silicon.

The structural (load carrying) member of a module can either be the top layer or the back layer.

Cells must also be protected from mechanical damage and moisture. Most solar modules are rigid, but semi-flexible ones are available,

based on thin-film cells. These early solar modules were first used in space in 1958.

CNBM Solar photovoltaic (PV) Panel is designed for large electrical power requirements.

It is the optimal choice for both on-grid and off-grid power systems.

 CNBM Solar panel offers high performance of power per square foot of solar array.

Monocrystalline silicon(c-Si): often made using the Czochralski process. Single-crystal wafer cells tend to be expensive,

 and because they are cut from cylindrical ingots, do not completely cover a square solar cell module without a substantial waste of refined silicon.

Hence most c-Si panels have uncovered gaps at the four corners of the cells.

Characteristics of Solar Monocrystalline

I. Solar Cell : High efficiency crystalline solar cell.

Even if under the weak light, the solar module can produce maximum power output.

II. Tempered glass (toughened glass): Anti-reflecting coating and high transmission rate glass increase

 the power output and mechanical strength of solar module.

III. EVA and TPT: Using high quality EVA and TPT to prevent destroying and water.

IV. AI frame: Without screw, corner connection. 6 holes on the frame can be installed easily.

V. Junction box: Multi function junction box with water proof.

VI. Long lifetime: ≥25 years; Less power decrease.

VII. Good performance of preventing from atrocious weather such as wind and hails.

VIII. Resisting moisture and etching effectively, not effected by geology.

  

Advantages of Solar Monocrystalline

• CNBM Solar performance guarantees for 25 years

• 10 years guarantee for workmanship

• Timeliness of delivery

• Quality Products certified (TÜV, UL, CE, VDE, ISO)

Product Name:

15W Solar Panel

Cell Type:

Monocrystalline

Cell Efficiency:

18%

Frame Material:

Aluminum alloy

Power Tolerance:

+/-3%

Max Output Power (Wmp):

15W

Max Power Voltage (Vmp):

17.8V

Max Power Current (Imp):

850mA

Open Circuit Voltage (Voc):

21.6V

Short Circuit Current (Isc):

930mA

Dimension::

280*420*18mm

Testing Conditions(STC):                     

Irradiance 1000W/m2, Temperature  25°C, AM 1.5                              

Life Span:

15-20 years

Warranty:

3 years

Monocrystalline15W Solar Panel

FAQ:

1. How long will my inquiry get response?

 Your inquiry related to our products or prices will be replied within 24 hours. 

2. Can I get professional service and suggestion?

Well-trained and experienced staffs to answer all your questions in fluent English. 

3. Do you accept OEM or customized design?

OEM & ODM, any your customized lightings we can help you to design and put into product.

4. What if I need specific design?

Distributorship are offered for your unique design and some our current models.

Q: I have a playstation PSP charger that is 5v 2A, so it takes 0 watts.I have several small solar panels that put out watt a piece and are 4 volts, 250mAhow can I get my 0 watts to be 5v 2A instead of 4v 250mA? the voltages have to match up right?also, what's a 3-T regulator that controls voltage?
The first item is whether the psp charger output is ac or dc. IF, AC then you are stuck as the panels put out DC. (Increasing the voltage enough to cover invertor losses is not practical in this instance!) IF DC, then you need to combine panels to produce 2 Amps, after which it is run through the 3 terminal VOLTAGE regulator to limit the voltage to 5v. That is 8 panels in parallel in 2 groups placed in series = 2amps at 8 volts, then add regulator for 2 amps at 5v. (Parallel increases amps, series increases volts.) Total panels required is 6 panels.
Q: I am doing a project on solar energy at the moment and I was just wondering how.
Sunlight okorder /
Q: I paid for an appraisal and the home was valued at $25,000. The problem I have with this is my house is equipped with solar panels. I paid about $25000 for them. A comparable house sold for $225,000 4 months ago. Same amount of rooms, bathrooms, square feet, lot size and curb appeal (landscaping). But no solar panels. Home prices in my neighborhood have also gone up. I would like to know if there is any way I can dispute this as I feel I just wasted a lot of money on a incorrect appraisal.
Normally solar panels are listed as part of the house that supply heat, like a water heater or furnish. Your house would be appraised the same without the solar panel. Since the house you are references sold 4 months ago this might not be a comp your appraiser would have used. Normally a house would have to be sold within the past 90 days to be used by an appraiser. You are able to challenge the appraisal of the house you paid for. The appraiser would take a second look at the cops he/she used in coming up with the valuation of the property and see if here was something that was over looked. If you want to challenge the appraisal based on the fact that you have solar panels, it is doubtful there would be any changes. By adding the solar panels to your house might have been over built your house for the neighborhood. Look around your neighborhood to see how many other houses have solar panels. Normally in an area where houses are valued at around $200K or so would not normally be equipped with solar panels. This would not add value to your house as other houses in your neighborhood would still appraise for the same, since they would not have solar panels as the house you indicated in your statement did not have. I hope this has been of some benefit to you, good luck. FIGHT ON
Q: I have 2 20 watt Solar panel. I have it hooked up to solar controller and batteries to inverter. Am trying to figure out how much watts am getting. I found the voltage but how do I find the amp reading on a mutimeter?
It is possible your meter does not have the capacity to safely measure more than 300 milliamps which is too small to measure current output from solar panels. Assuming no losses in the system or components, if your meter does not have the capacity to measure 0 Amps, you will need to get one that does. Analogs are better than digitial for this. Most often the 0 Amp circuit of the meter has a discrete positive plug location for the positive test lead. Most have a common ground connection with the rest of the meter functions. If you are measuring current at the battery in the charge mode- Negative lead of meter goes to positive terminal of battery and positive lead of meter goes to the cable that was connected to the positive terminal of the battery. Since the Wattage is a nominal measurement, if you measure between the panel and controller, take measurement on one leg of the panel, as you want to measure the current with the loaded active circuit. Meter is oriented the same way as the measurement at the battery would be made above only this time the meter is between the panel and controller. At peak solar conditions, expect current to be measured at 2.5 to3 Amps or more per panel. Under optimal conditions your panel will have higher output than their ratings indicate. Open circuit can be close to 20 volts. Never short circuit the output of the solar panels. It is volts multiplied by amps that gives you Watts.
Q: I installed a 60watt solar panel on the top of my patio/pergola. This is wired to a charge controller then a battery in my basement. Do I need to run a ground from the solar panel? If so, whats the easiest way to do so? Is a wire attached to the aluminum frame then connected to a foot long rod into the ground enough?
Did you ever evaluate possessing the equipment your self? Why not take all of the tax incentives your self? Why pay an identical fee in 7 years from now? that may not a honest deal. Did you ever verify with them what might ensue once you want to sell your place before the tip of the lease? Our enterprise has put in photograph voltaic panel structures in 8 states in the Northeast and we adore to work out the tip consumer identifying to purchase the photograph voltaic array. we glance on the lease ideas as a final motel if there's a financing situation. the guy who owns it makes the money, short and easy. concerning utilising it whilst the capacity is going down, the inverters can not function whilst there is not any grid capacity. you may proceed to function utilising a battery equipment and yet another inverter, yet that will advance your fee extremely plenty as properly. you should use yet another generator as properly, which may be a less costly fee selection. you want somebody who's staring at on your appropriate interest, and not their very own investor. you've got your equipment value paid returned in basically some years!
Q: Hi everyone, I am a novice in solar energy system. I want to know if I am on the right track. Recently I bought a 30 W solar panel, 5 Amp controller, and a 22 Ah battery, how many watts and what kind of INVERTER do I need? I did an research some said 50 W and some said 300 W. And am I right on the 5 amp controller and 22 Ah battery to provide larger output of electric, or the higher the # the greater output for 30 W solar panel?Really appreciate for anyone who help!!!
must be one of the place who's place have sun
Q: What are the benefits of solar panel heating?What does it cost for solar panels?any other important facts about it?
you can use solar electric panels to make electricty for heat.......although the energy output is so low that doesn't work very well you can use solar hot water heaters to capture the suns heat, even in winter, and give a boost to a hot water heating system, using less energy in the boiler.....
Q: Can solar panels be used in areas with high humidity or saltwater exposure?
Yes, solar panels can be used in areas with high humidity or saltwater exposure. However, it is important to choose solar panels specifically designed for such environments, as they need to be corrosion-resistant and have proper sealing to prevent any damage from moisture or saltwater.
Q: What is the average size of a solar panel?
The average size of a solar panel is typically between 3 to 4 feet wide and 5 to 6 feet tall, with an area of around 15 to 20 square feet.
Q: How do solar panels affect the insurance premiums of a property?
Installing solar panels can have a positive impact on insurance premiums for a property. Solar panels are considered to be an attractive feature as they increase the value of a property and reduce the risk of damage caused by fire or other natural disasters. Furthermore, solar panels are durable and require minimal maintenance, leading to fewer claims made to insurance companies. As a result, insurance providers often offer discounts or lower premiums for properties with solar panels, making it a cost-effective investment in the long run.

Send your message to us

This is not what you are looking for? Post Buying Request

Similar products

Hot products


Hot Searches

Related keywords