TCA Heavy Duty Petrochemical Processing Pump

Ref Price:

Loading Port:: Shanghai

Payment Terms:: TT or LC

Min Order Qty:: 1 unit

Supply Capability:: 1000 Sets Per Month unit/month

Inquire Now

Add to My Favorites

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

You Might Also Like

Vertical Stainless Steel Centrifugal Pump

WQ Series Sewage Submersible Pump

Vertical Turbine Pump

Horizontal Multistage Pump

Magnetic Drive Pump

P.C Pump

Split Multistage Pump

Vertical Multistage Pump

This type pump are suitable for the transportation of clean or contain particles, low temperature or high temperature, neutral or corrosive liquids.

Q:Will it clog up the oil pump by cleaning the engine oil which is strong enough to clog up the oil circuit?: If the engine is too much carbon deposits, the use of such properties of oil, it is true that such a situation can occur. The first is blocked by the oil pump filter. The oil passages are not blocked, because carbon deposits are filtered first by the filter. Sludge is capable of entering the oil passages.

Q:What is the effect of excessive oil on the oil pump?: Too much oil, will increase the rotational resistance of the crankshaft, reduce the output power of the engine, and the excess oil from entering the combustion chamber in the combustion, burning oil, causing the vehicle to take the blue smoke, and increased fuel consumption, oil residue after combustion (the main component is carbon, very hard) will accumulate in the combustion chamber wall. To reduce the space of the combustion chamber, thereby reducing the engine compression ratio, at the same time, will accelerate the wear of cylinder and piston so as to reduce the service life of the vehicle.

Q:474 new engine replacement and pump axle: Detection of oil channel have blocked, remove the oil pan, thrust washer third Daowagai above, if excessive wear

Q:Audi a6l2.0 engine oil pump timing, right?: I remember it was carved when we took it apart,

Q:My motorcycle has been running for a long time. Now, about 2 bottles of motor oil in one hundred kilometers are too expensive. Can you add the engine oil to the mailbox according to the approximate proportion? Thank you.: You'd better not put it in the tank. Will affect the gasoline combustion, because the oil concentration and gasoline is not the same. And the functions are different. What is the place with what place, with a little or no big problem, but the exhaust pipe will take the blue smoke, the damage to the engine is not great. If so, I suggest going to the 4S shop to take down the tank and clean it.The oil is added to the tank, depending on the type of oil (burning or lubricating oil) and the amount added. If it's the engine oil that has minimal impact on the engine, the mixing ratio should be within 1:25.If the amount of oil added to the tank is more than 1:25, the possibility of carbon deposition in the cylinder head of the engine will increase. Below this value can be assured to use, the smaller the proportion, the smaller the impact on the engine.

Q:How to check the motor oil pump oil supply is normal?: In the premise of the normal amount of oil, usually need to check whether the oil pressure is normal (usually around 0.3MPa), if the oil pressure is low, usually the oil circuit, overflow valve failure or oil pump failure. After cleaning and adjusting the oil relief valve, the pressure is still low. The fault must be the oil pump failure.The effect of the oil pump is to press the engine oil to a certain pressure and force it to the surface of each part of the engine. If the oil pump is damaged or leaking, it is necessary to disassemble the oil pan, take out the oil pump and replace it, and clean or replace the oil pump inlet strainer at the same time.

Q:My car is old Mondeo 6 cylinder, is about 04 years, did not open at home for more than a month, another time machine pump indicator lights, is not always bright, is running 10 meters light, then I re open flameout is good, but there are more than ten meters and bright, so repeated always dare not open far. What's the matter? The oil is absolutely lacking. Please give me some answers, my friends. Thank you.: It's the oil pressure indicator, not the oil pump indicator light.This indicator is used to show the pressure of the engine oil. Open the key door. When the vehicle starts to self check, the indicator light is on and off after starting. The indicator light is always on, indicating that the engine oil pressure is lower than the required standard, you need to repair.If it's on all the time, just see if the oil is enough. How about the oil pressure switch, the wiring harness and the plug?. If it is flashing at some point, the possibility of a problem with the oil pressure switch itself is greater.

Q:How to change the oil pump?: Hello. What car do you want to see?. You'd better go to the repair shop. Can not afford their own

Q:Is it not the oil pump with the wrong oil hole Doutong.: I also installed oil cold, but did not add oil pump, I was directly connected to the body under the oil drain screw mouth, to the oil cold inside filled with oil, will let the oil cold cycleAs for the cylinder head not to oil then I estimate ZL wrong to go head screw screw to find a master travel to see help or not to oil cylinder head was a serious problem as soon as possible.Also help you to exclude whether the car is missing oil, positive or negative pump, there is no answer

Q:How to change the diesel engine oil pump?: First of all, you need to release all the oil, disassemble the engine oil pan, remove the oil pump assembly and replace it.The oil pump is the main component in the lubrication system of diesel engine. Its function is to press the engine oil to a certain pressure and force it to the moving surface of the engine parts. The structure of oil pump can be divided into two types: gear type and rotor type. Gear type oil pump is divided into internal gear type and external gear wheel type, generally referred to as gear pump.

Our main products are all kinds of centrifugal pumps, displacement pumps and vacuum pumps, such as oil pumps, multi-phase pumps, single stage and double suction centrifugal pumps, horizontal split case pumps, multistage pumps, axial-flow pumps, mixed flow pumps, petrochemical pump and submersible pumps. Besides, our company also manufactures electric motors and sells electric motors, building materials, indoor decoration materials, civil electric equipment, devices and instrumentation, as well as exports our mechanical and electric products.

1. Manufacturer Overview
Location	Hunan,China
Year Established	2006
Annual Output Value	US$5 Million - US$10 Million
Main Markets	59.00% Mid East 8.00% North America 8.00% Southern Europe 5.00% Eastern Asia 2.00% Africa 2.00% Oceania 2.00% Southeast Asia 2.00% Western Europe 2.00% South America 2.00% Central America 2.00% Northern Europe 2.00% Eastern Europe 2.00% South Asia 2.00% Domestic Market
Company Certifications

2. Manufacturer Certificates
a) Certification Name
Range
Reference
Validity Period

3. Manufacturer Capability
a)Trade Capacity
Nearest Port	SHANGHAI,GUANGZHOU,DALIAN
Export Percentage	51% - 60%
No.of Employees in Trade Department	6-10 People
Language Spoken:	English, Chinese
b)Factory Information
Factory Size:	Above 100,000 square meters
No. of Production Lines	Above 10
Contract Manufacturing	OEM Service Offered Design Service Offered Buyer Label Offered
Product Price Range	High and/or Average