Utile6-O Outdoor Rental LED Display High Pixel Density

Inquire Now

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

Utile6-O(Outdoor Rental LED Display)

Features：

1. Simple cabinet: Thin and light design, easy for installation, occupy small space

2. Cabinet with aluminum structure, available in 2 sizes: 500x500mm and 500x1000mm

3. Protection grade IP65 can be use for semi-outdoor and outdoor

4. High contrast rate, high refresh rate, high gray scale, soft image

5. Cabinet thickness: only 86mm

6. Cabinet hollow out design, making lighter weight and better heat dissipation

7. No fan design, no noise

8. Cabinet door with EVA cotton, shockproof

9. Cabinet locking system is easy without the use of tools

Parameter	Value
Pixel Pitch	6.9mm
Pixel configuration	1R1G1B
LED type	3-in-1 SMD3535
Brightness	5500cd/㎡
Color temperature	3000K to 10000K can be adjust
Viewing angle	H: 120°; V:100°
Module size	250mm×250mm
Cabinet size	W500m×H500mm / W500mm×H1000
IP Rating	65/43
Operating Temperature/Humidity	-20℃~+50℃/10~90%RH
Storage Temperature/Humidity	-40℃~+60℃/10~90%RH
Pixels per panel	72×72Dots / 72×144Dots
Processing depth	14bits
Gray scale	16384 levels per color
Contrast ratio	4000:1
Video frame rate	50/60 Hz
Rate refresh	≥1000Hz
Input voltage	110~240VAC
Input power frequency	50~60Hz
Panel power <max>	579W / 410W
Panel power <typical>	199W / 136W
Life Time	≥100,000 Hours
Input signal	S-VIDEO,CVBS,YPbPr,RGB,VGA,DVI,HDMI,HDSDI & DisplayPort,etc
Rigging form	Fixed/Install on the floor
Data interconnection	CAT5 Cable( L≤140m)； multi-mode fiber( L≤500m)； Single mode fiber( L≤20km )

Q: LED display power can not be displayed properly: LED display power can not be normal display of the phenomenon may be caused by a variety of different reasons, encountered this phenomenon Please note that the following aspects can be used to determine the "failure":

Q: 16: 9LED What is the approximate size of the display?: First determine a length or width size, here to length as an example. If the length is 96 meters, then 96 ÷ 16 = 6 × 9 = 54 meters

Q: What is the thickness of the led display?: The thickness of less than 75mm, with the aluminum. Can also be thinner but the material is not easy to find.

Q: LED display how to install it?: This installation and cantilever installation similar, the same application, the screen body with a cabinet design, suitable for indoor, semi-outdoor screen body.

Q: LED display power supply how to configure how many units with the plate is calculated.: According to the unit board power calculation, P10 monochrome in general 10 to 12 blocks, indoor monochrome 12, indoor color 6, full color, then ask the unit board manufacturers, a board of how much power. And then calculate their own bar.

Q: LED display more than the size of the area must be 380v: General LED screen to reach more than 20 square meters will use more than two power lines, and then some will use three-phase electricity. At the same time and time-sharing power system with the use, so as not to impact on the power grid. The maximum power can take 80 percent of the capacity to leave a margin of 20 percent. Also pay attention to the choice of cable, and lightning protection measures.

Q: Led display brightness is not enough because of what are the reasons: Display screen software which can adjust the brightness of the display. If you use the time for a long time, there are reasons for light failure, it is recommended to consider replacement

Q: IPS screen and LED screen difference: LED is the light-emitting diode, so the so-called LED screen is the concept of confusion, in fact, LCD panel with LED as a backlight, but also useful as a backlight CCFL, CCFL is cold cathode fluorescent tube,

Q: Led display speed how to tune: When installing the LED bar screen software, enter the text that needs to be displayed in the blue edit box. After the text editing is finished, click "Frame Properties" to pop up the following dialog box to set the frame properties. Display speed 1 fastest, 16 slowest. After setting the current frame, you can point to "previous frame" or "next frame" to move to another frame. After all the parameters of the frame are set, click the "Exit" button to return to the main window.

Q: Led display point density is what it means: LED display density refers to the LED display per square display the number of pixels, such as P10 model LED display is 10,000 pixels per square point, P16 model refers to the display refers to 3906 pixels per square point.

Send your message to us

*Email

*TEL

*Quantity

*Unit