T8 LED Tube SMD Chip High Efficiency 0.6M 8W
- Loading Port:
- Shenzhen
- Payment Terms:
- TT
- Min Order Qty:
- 10 Pcs pc
- Supply Capability:
- 100000 Pcs Per Month pc/month
OKorder Service Pledge
Quality Product, Order Online Tracking, Timely Delivery
OKorder Financial Service
Credit Rating, Credit Services, Credit Purchasing
You Might Also Like
T8 LED Tube SMD Chip High Efficiency 0.6M 8W 1. This product meets the standard of CE certification.
2. With internal No-isolated power supply.
3. Round and the elliptical tube are available.
4. Use the most mature international well-known LEDSMD2845 as the light source, which can ensure the led tub35 as the light source, which can ensure the led tube brightness and long lifetime, also can reduce the light decay.
5. Use the high quality aluminum PCB for LED’s better heat dissipation.
6. High-grade PC cover with nice light transmittance(> 95%),Transparent PC cover and frosted PC cover are available.
7. 180 degrees beam angle makes the lighting effect better.
8. CRI(standard products)>70,it can be over 80 if required.
9. Ambient temperature:-20°C-40°C, surface temperature: 42°C-45°C
10. No mercury, lead or other hazardous materials; no radiation, no electromagnetic radiation, no frequency flash, instant start up, no hurting eyes.
Applications:
Replacement for conventional fluorescent tubes:
1. Hotels
2. Conference/ meeting room
3. Commercial Complexes
4. Residential/ Institution Buildings
5. Schools, colleges & Universities
6. Hospitals General li
2. With internal No-isolated power supply.
3. Round and the elliptical tube are available.
4. Use the most mature international well-known LEDSMD2845 as the light source, which can ensure the led tub35 as the light source, which can ensure the led tube brightness and long lifetime, also can reduce the light decay.
5. Use the high quality aluminum PCB for LED’s better heat dissipation.
6. High-grade PC cover with nice light transmittance(> 95%),Transparent PC cover and frosted PC cover are available.
7. 180 degrees beam angle makes the lighting effect better.
8. CRI(standard products)>70,it can be over 80 if required.
9. Ambient temperature:-20°C-40°C, surface temperature: 42°C-45°C
10. No mercury, lead or other hazardous materials; no radiation, no electromagnetic radiation, no frequency flash, instant start up, no hurting eyes.
Applications:
Replacement for conventional fluorescent tubes:
1. Hotels
2. Conference/ meeting room
3. Commercial Complexes
4. Residential/ Institution Buildings
5. Schools, colleges & Universities
6. Hospitals General li
- Q: The difference between an LED tube and a daylight lamp
- A diving LED tube is usually blue. You are? This light is useful for red grass and sea water tanks. You don't need a koi. If you want to use a white LED lamp mixed with a light-colored LED lamp or a red, blue and green light bulb. Red, blue and red blue (purple) mixed light is bad for viewing. Add a white light blend. You can't raise the two kinds of fish that you raise, and you don't have a lot of light on the lights. As long as it doesn't affect the view, it can continue.
- Q: The difference between the Ledt5 lamp and the temperature 3000k and 2700k
- 3000k lamp tube luminescence is white point, 2700k lamp tube illuminant red a dot.
- Q: Are LED lights like regular daylight bulbs
- LED is much better than ordinary lamp, won't produce ir/uv, not stroboscopic, is the lamp that shield an eye, for many people is too dazzling, can damage eyes, this is wrong, because the LED luminosity of relatively large, so will feel dazzling, it is like looking at the sun, but a lot of shell have frosted now, won't appear this kind of phenomenon; But ordinary lamp produces ultraviolet light and strobe, unfavorable to close for a long time of study and work, but also have a slight noise, leds will not have this kind of phenomenon. You need to know more about LED or purchased, and baidu HI.
- Q: What does philips mean by TLD36w / 54-765
- Yeah, I did it for you, I think it's the bottom, Let's see if it is ~ TLD ~ T8 Dailyght 160-240v (model) 36 ~ 36 w.I hope my answer will work for you.
- Q: If the body is accidentally broken, will it be electrocuted?
- You don't touch the electrodes without touching the two electrodes. But be careful when you break
- Q: Xinda is a popular led lighting tube
- Led fluorescent lights are cheaper and cheaper. The long led fluorescent lighting is a high-end engineering quality, a 12-year brand
- Q: How do LED lamp tube install how connection?
- Leds that do not normally require special orders are mostly built with built-in power, which is directly available. Most can only need to remove the starter on the traditional stent line (is a cylinder bracket highlighted below) mount tubes can be used, if not yet so could you use the stent is a relatively new "electronic" will be a little trouble need you open the stents to get inside the ballast also take off to the inside of the line directly connected to the utility, LED bulb is directly at the mains. Of course, if you understand the circuit and you're not afraid of trouble, it's advisable to remove the "regenerator", because the "ballast" is a power drain.
- Q: Is the normal daylight tube replaced by an LED line
- Step 1: use a screwdriver and a pliers to disconnect the ballast from the wire. But my home is the sun lamp base of zhengtai, the quality is too good, it took 10 years. I didn't even get down to the ballast, which was stuck in a full thick iron base, so I disconnected the wire. The wire that disconnects from the ballast is sure to have two heads, just to disconnect the connection. There is a lot of direct skewers of black tape, some of which use that connector and screw the two wires together. It's the same thing. This is the connector that is used in this case. Disconnect the regenerator, remove the wire and then rewire the two broken wires together and attach the black tape (which is the insulating tape). Put the base back to the original. Install the fluorescent tube, and remember to place the head of the European logo on the base of the current. And when you put it in place, it's going to be OK.
- Q: Why do LED bulbs have stroboscopic frequency? The camera
- It's a huge secret to be able to look at led lights and take a camera, and god lets you discover a huge secret, hehe. Secretly tell you You use your camera to photograph corrugated and stroboscopic, indicating that your led tube is a product that is resistant to pressure and pressure, not a product that is heng-current. Stroboscopic because domestic voltage changes back and forth between 180-260 - v, voltage changes in current led products to you after the impact, and your drive is not out of constant pressure, will only make the led lamp bead to under the impact. Simply put, your led tube is not very good, and it will soon be weak and not very long. Ask you to buy the time to ask clear, the lightning led lamp tube and the bracket on Tmall is the cross current constant pressure, can go to see. I hope I can help you
- Q: What are the components of a T8 LED lamp tube?
- The T8LED fluorescent tube, which is 2.6 cm in diameter, USES a patch lamp. SMD3528, 5050,3020, etc. Use a straight set lamp, a straw hat lamp. Which one do you say is good? LED light has to do with the chip that the lamp USES, if it is a better brand chip, the light effect and stability of the light bead is better. Of course the chips are highlighted and bright. These are not the same, the number of lumens in the tube, the color indices are going to be different. The power of the power can be done. The price aspect is related to the chip brand used by natural and lamp beads, and the packaging process of lamp beads. If the heat is related to the board, it is now generally better to use aluminum. LED daylight bulbs are made up of outer cover, board, lamp, and power source, and cost calculations are taken into account. The price of a typical patch is higher.
We are a leading manufacturer of a broad range of LED strip light and LED Tube light. From 2011, we have integrating sphere spectrometer, high speed automatic placement machine, reflow soldering machine, automatic dispensing machines and other specialized equipment and professional R & D department. LED strip light can produce up to 300000 meters per month.
1. Manufacturer Overview
Location | Shenzhen,China |
Year Established | 2011 |
Annual Output Value | |
Main Markets | Mid East;Western Europe |
Company Certifications |
2. Manufacturer Certificates
a) Certification Name | |
Range | |
Reference | |
Validity Period |
3. Manufacturer Capability
a) Trade Capacity | |
Nearest Port | Shenzhen |
Export Percentage | |
No.of Employees in Trade Department | 20 People |
Language Spoken: | Chinese |
b) Factory Information | |
Factory Size: | Above 4,000 square meters |
No. of Production Lines | About 5 |
Contract Manufacturing | OEM Service Offered;Design Service Offered |
Product Price Range | Cheap |
Send your message to us
T8 LED Tube SMD Chip High Efficiency 0.6M 8W
- Loading Port:
- Shenzhen
- Payment Terms:
- TT
- Min Order Qty:
- 10 Pcs pc
- Supply Capability:
- 100000 Pcs Per Month pc/month
OKorder Service Pledge
Quality Product, Order Online Tracking, Timely Delivery
OKorder Financial Service
Credit Rating, Credit Services, Credit Purchasing
Similar products
Hot products
Hot Searches