LED Lighting Tube T5 CE RoHS TUV ETL t5 Bracket Lamp
- Ref Price:
-
- Loading Port:
- Qingdao
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 1000 set
- Supply Capability:
- 100000 set/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
LED Lighting Tube T5 CE RoHS TUV ETL t5 Bracket Lamp Specification:
Material | Aluminium + PC cover |
Body size | 600mm |
Light quantity | SMD2835/96Pcs |
Power Installation | Power external in the tube |
Work voltage | AC100-240V |
Power consumption | 10w |
Power factor | >0.92 |
Work temperature | -20°C~+50°C |
beam angle | 120° |
Color rendering | >80ra |
Color temperature | 2700-7200k |
Luminous flux | 950Lm |
Light-to-Electric conversion yield | 95% |
Life span | 50000hrs |
Main Feature of LED Lighting Tube T5 CE RoHS TUV ETL t5 Bracket Lamp:
1.Magnetic&electronic ballast compatible
2.No need to remove starter or ballast.
3.No professional electrician needed
4.Easy for installation
5.No labor cost, maintenance free
6. instant start.
7. No UV, NO mecury, healthy for human body
8.Power consumption:24w
9.Certificate:CE,RoHS,FCC,PSE,TUV,UL
10.Low power consumption
11.3 years warranty
10.No fluorescent flickering
11.No RF interference, no buzzing noise.
12.No hazard of mercury or lead entering the environment
13.Easy in stallation
14.No dangerous of glass broken
LED Lighting Tube T5 CE RoHS TUV ETL t5 Bracket Lamp Description：
1.Living room, bedroom,kitchen, washroom;
2.School, university, hospital,hotel;
3.Conference,meeting room, show room,showcase;
4.Commercial complexes;
5.Factory,plant,warehouse,office;
6.Supermarket,department store.
Images：
FAQ:
What certificates do you have for your products?
ISO
- Q: How do the fluorescent tubes fail?
- Basic about $15 a good lamp, spend money to repair it is better to buy a new one, and that no repairability, warranty, will usually give you a new selling
- Q: How to meet? The rectifier is very easy to connect
- The ballast electronic ballast is not very long. It is very easy to be bad
- Q: LED daylight tube is the minimum of the W, the maximum number of W
- But there is an unconventional product that can be done in 30W.I hope my answer is useful to you.
- Q: What about the quality gap between leds?
- Yes, there are other factors besides these three conditions that cannot be ignored. Like lampshades, aluminum plates,
- Q: What causes the red light on both ends
- There are two kinds of red light on both ends of the fluorescent tube: 1, if it is the use of long tube, gradually from both ends of black, red in the end, there is a gradual process, is basically a lamp aging, filament will burn out the precursor, exchange tubes can troubleshooting; The lamp tube USES all the time normal, occurrence afore-mentioned phenomenon suddenly, that most is the rectifier is caused by failure, change rectifier can.
- Q: How to remove fluorescent lamp tube
- Rotate the tube 90 degrees and remove from the gaps seen above. Is there a gap between the ends of the lamp holder? If you have to rotate it. If there is no gap, just look at the ends of the lamp holder, a paragraph should be active, you hold the lamp, it toward the activity period of pressure, on the other side can be removed. That's two
- Q: Can a fluorescent tube be used in series?
- Because 20 watts bulb needs about 450 v high voltage to the breakdown, 40 tile tubes need about 550 volts can be breakdown. Usually ballasts provide high voltage is slightly more than, but not more than a lot.
- Q: The T8 nominal 36W standard daylight bulb is only 18W
- This problem is the output power of the ballast for not doing enough, main is not the problem of power factor. For the electronic ballast, the output of active power is low, requirements for the switch tube is low, can use low or inferior triode, such costs are lower. In addition, the output inductor can also be less a few rounds of copper wire, cost is low. So do electronic ballast to make money. The upstairs have their own design of electronic ballast
- Q: What is the reason for the movement of light in the tube
- Flash is because the lamp tube is old, fast, ready for new, it won't last long
- Q: Why do LED bulbs have stroboscopic frequency? The camera
- There is a difference between the eye and the camera. This is caused by the ripple current, and this general customer will be required. It will be down to 10%
Send your message to us
LED Lighting Tube T5 CE RoHS TUV ETL t5 Bracket Lamp
- Ref Price:
-
- Loading Port:
- Qingdao
- Payment Terms:
- TT OR LC
- Min Order Qty:
- 1000 set
- Supply Capability:
- 100000 set/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
