T8 LED Tube 0.6m 9w 8500lm

Inquire Now

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

You Might Also Like

Main Technology Index:

Q: What is the distinction between led fluorescent tubes and ordinary daylight bulbs?: The final thing is that leds don't need a regenerator and a rectifier, and ordinary fluorescent lamps need to be used. There are a lot of different details

Q: What causes the red light on both ends: There are two kinds of red light on both ends of the fluorescent tube: 1, if it is the use of long tube, gradually from both ends of black, red in the end, there is a gradual process, is basically a lamp aging, filament will burn out the precursor, exchange tubes can troubleshooting; The lamp tube USES all the time normal, occurrence afore-mentioned phenomenon suddenly, that most is the rectifier is caused by failure, change rectifier can.

Q: What is the minimum starting voltage for the fluorescent tube?: I use the 20 watt fluorescent lamp to measure the lowest maintenance of the tube and the voltage is 98V volts.

Q: How does the traditional daylight lamp tube replace the LED light tube?: You don't have to change any of the lines, you have to remove all of the fluorescent lights, you just leave two lines, and then you connect the two ends of the LED lights

Q: Electronic ballast tube lamp change led lamp tube how to change circuit how to do: Usually direct 220V, in the package of the lamp tube has the wiring diagram, does not use the original ballast, the nature is different

Q: How does the LED fluorescent lamp tube be fixed with the aluminum plate in the tube?: The rivets are not good... You can think about mechanical methods. Such as side pressure. And the method of gluing

Q: What material is LED fluorescent lamp fittings, such as shell, block?: The bottom case is pure aluminum, solving the problem of divergence; The mask is a PC milky white or transparent to solve photoelectric transmission and visual effects. The plug is made of plastic, not easily broken and safe.

Q: Do not have the fluorescent lamp of actuator, how to change LED lamp tube?: To replace the fluorescent lamp ballasts with constant current power supply LED lamp, the lamp again feet according to the requirement of the tube is connected to the power supply is ok, there are several kinds of LED bulb light foot, according to the actual wiring, general instructions are on the tube.

Q: Why don't leds need a rectifier: Leds also require a power supply to drive only the rectifier that is not the tube. Normal LED daylight tubes are not driven. You have to have a power supply drive, and you have a built-in driver but that's going to affect the life span of the power supply and you don't have to be able to do that without the wiring.

Q: What about the normal daylight tubes replaced with LED tubes, ballast and flashers?: The rectifier and the regenerator can be removed, the specific installation method should be changed according to the electric way of the LED lamp tube

Send your message to us

*Email

*TEL

*Quantity

*Unit