• PIR Detector with Dual Element Passive Infrared Detection Technology System 1
PIR Detector with Dual Element Passive Infrared Detection Technology

PIR Detector with Dual Element Passive Infrared Detection Technology

Ref Price:
get latest price
Loading Port:
China Main Port
Payment Terms:
TT OR LC
Min Order Qty:
-
Supply Capability:
-

Add to My Favorites

Follow us:


OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

PIR Detector with Dual Element Passive Infrared Detection Technology



Main Features

1.Detection Mode: Dual Element Passive Infrared Detection Technology
2.Installation Mode:Wall/Ceiling Mounted
3.Operating Voltage:9~16VDC
4.Dimension:70mm*28mm*25mm

Technical Parameter

Model No.
ALN-461
Detection Mode
Dual Element Passive Infrared Technology
Detection Angle
15°
Detection Range
6m*1.3m
Installation Height
2m~3.6m
Installation Mode
Ceiling/Wall Mounted
Power supply
9~16VDC
Current Consumption
≤13mA,12VDC
Working Environment
Temperature: -25℃~55℃
Humidity:RH 95%
White Light Immunity
≥8000LUX
RFI Protection
20V/m (20MHz~1000MHz)
Alarm Output
Dry-Reed Relay;(NC)Contact Capacity: AC/DC 100mA/30V
Tamper Output
(NC)Contact Capacity: AC/DC 50mA/24V
Product Dimension
70*28*25(mm)



Q:So I've purchased at least 20 boxes of Easy Cast Resin in the past year and the bottles of hardener were various shades of yellow, the most common being a rather light yellow. I went ahead and purchased a new box from Michaels last week but I didn't open it until today and the hardener was a shade of yellow that's similar to whiskey. I've heard the product can turn into a shade of amber if you have it more than 6 months, and it would never properly harden. So is the whiskey yellow shade normal and still safe to use or should I just exchange it at the store? I've seen sellers online offer boxes that have a bottle that's a similar shade, so I would really just like to be sure it's safe to use before I open it (I would do a test but if I open/use the product, I wouldn't be able to exchange it and I'd rather not waste my money on something that would end up in the trash).
I'm happy you got caught. Stupid immature young adults like you should a learn a lesson or two on how to treat fire extinguishers and when not to enter a construction site (it's unsafe!)
Q:how much does it cost to put in speed bumps including the cost of labor?
Factory car alarms commonly mess up and cause problems. You can look for a fuse labled security or alarm, however I doubt there will be one. Likely, you will have to disconnect the alarm computer from the car. On Toyotas, these are often right above the steering colum behind the dash. Look online or call the dealership to see were it's located in your ES.
Q:i just wanted 2 no if warnado or camo was out in stores and if they r what store plz. And also is Drobot good im thinking about getting him
Normally you would not use a compression fitting on a copper pipe anyway, it should be soldered. Depending on where you live the average water pressure in most cities will range from 50-80 psi. Measure the outside diameter of the pipe and use the proper fittings for plumbing . Quick couplers are not recommended in any application except a garden hose. Do not forget the water shut-off valve installed before the water heater (cold or supply ) It sounds like you should really let a professional do this installation before you end up with a flood in your basement from trying to diy. If you did install a compression fitting properly you would find that the ferrul would have crimped the original pipe and you would have to cut the pipe to remove it. You may also be using compression fittings for either flexible tubing or garden hose applications. They would of course be slightly different in diameter than copper pipe. Why would you even be using flexible tubing to connect a water heater in the first place? And are you using the proper type of flexible tubing or just a piece of garden hose? Don`t forget that there are 2 types of flexible tubing , one for cold and one for hot water. Don`t use a cold water pipe on hot water .
Q:A person in a laboratory, while dealing with conc. sulfuric acid, accidentally spills some of the acid on his hands.(i) What harm can concentrated sulfuric acid cause on the person's hands and why?(ii) The person then decides to wash his hands with water, while his friend tells him to pour conc. NaOH instead of water on his hands. Suggest which technique is better and why?(iii) Suggest what safety precautions should be taken to avoid such an event in a laboratory?THanks!!!
hi, fire alarms are indicative of a abrupt fire hazard in whichever place you are in !!!!!!!!!! The system of fire alarms consists of specific noise creating setup and with the assistance of these people induce alertness among themselves.
Q:Old school, like people used to keep on their kitchen counters. The glass jars last forever, as do the metal rigging to clamp the lids down, but where can I find the plastic gaskets to replace the old ones? Or could I just make new ones out of leather?
no. the 'stock' alarm system uses a multiplex unit to determine if the interior, engine compartment or trunk have been opened without the alarm first being shut off. their is no provision to add circuits to the multiplex to integrate new sensors into the decision making process. multiplex units use the same wire for multiple signals. you can't cut and splice into those lines arbitrarily or you'll disrupt the communications paths. hope that helps
Q:Can combustible gas detectors be special equipment?
Fire alarm triggering device classified in fire alarm device.
Q:To indicate that the air raid alarm is released, what is the law of the siren?
3. Release the alarm: use: to lift the alarm is in the air raid or war temporarily relieved. Tweets: continuous light for 3 minutes.
Q:I want to stud my chihuahua to a female chihuahua on Oahu, not for a fee but for the pick of the litter. He is papered and a very good looking dog. Know anyone who would?People please don't lecture me about adopting a dog b/c I did that and the dog that I got tore the wallpaper of the wall and I took him back to the humane society. Last time I go down that road!
Very bad idea. Get a colored lens for your helmet instead.
Q:The main water line into one of my apartment buildings broke today, and we replaced it and screwed the new PVC into the old steel main. After about an hour, the smallest amount of water is seeping out of the joint even with the joint tape. Is it possible to use a sealent (caulk or something) on this without having to cut the PVC pipe out again and starting over?
you can use a 4 by 3 sanitary tee. unfortunately the rise in elevation after adapting at floor level will put your pipe centerline elevation at about 9 above concrete floor. then when you add 90 degree elbow looking up to a toilet flange you will be close to 13 or 14 inches above concrete floor. you will need a cast iron chain pipe cutter to cut the vertical cast iron pipe the stack should be supported to prevent it from sagging or falling down. the condition and age of cast iron also can be an issue. the best solution would be to make the pipe connection underground. this will solve all the elevation problems and you could also add a sink or shower if you wish. note: according to code / wye fittings may used on the horizontal and vertical drains. tee fittings are to be installed on vertical drain lines. never lay a tee flat on the horizontal. a macerating toilet might also be cheapest / easiest option but it does demand electric and a tie in point for the drain. downside is pump maintenance or failure. personally the best professional option is an underground tie with concrete floor repair. remember gravity never fails.
Q:i have a fire alarm in my apartment room that is on the roof. if i pull it off there is 3 wires connected to it. black red and white. i like to smoke in my room and not worry about the 5000 fine. if i pull the plug do they know i've tampered with it? can i unplug and plug back in at any time? whats other ways to stop it from going off? i thought about putting a bowl over it and duct taping it to the roof.
Just go to a field, arena, or secluded area. I was watching a video on film making and the host said that was almost shot a cop because the people next door thought it was a real gun. FilmRiot is the channel. Tell any one around that they are not real, just to be sure.

1. Manufacturer Overview

Location
Year Established
Annual Output Value
Main Markets
Company Certifications

2. Manufacturer Certificates

a) Certification Name  
Range  
Reference  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port
Export Percentage
No.of Employees in Trade Department
Language Spoken:
b)Factory Information  
Factory Size:
No. of Production Lines
Contract Manufacturing
Product Price Range

Send your message to us

This is not what you are looking for? Post Buying Request

Similar products

New products

Hot products


Hot Searches

Related keywords