K Series 4-4.5T I.C. Counterbalanced Forklift Trucks

Inquire Now

OKorder Service Pledge

Quality Product, Order Online Tracking, Timely Delivery

OKorder Financial Service

Credit Rating, Credit Services, Credit Purchasing

You Might Also Like

Model		CPC40	CPC45
Load capacity	kg	4000	4500
Power type		Diesel
Overall length (without forks)	mm	3195
Max. lifting height	mm	3000
Load center	mm	500
Overall width	mm	1420
Overall height (overhead guard)	mm	2350
Min. turning radius （outside）	mm	2930
Max. travel speed (with/without load)	km/h	22/22.5
Service weight	kg	5950	6200

Q: How does the fork of a forklift know that there is no balance: Heavy load balance: is a problem distortion for the test fork or not. The payload is placed in the middle of the cargo fork. Stop at a few centimetres from the ground (for safety) to measure or measure. The fork tip is separated from the ground. Can be measured.

Q: How many kilograms are on the top of the forklift truck: Second, a forklift is typically designed to prevent a high-flying object from falling and hurling a protective device. So don't put too much weight on the top shelf. Finally, good luck to you!

Q: What is the difference between a forklift and a forklift?: Get on the bus are all used to open 10 minutes A tube is two joysticks A pipe fork tilt But forklift truck is turned to the small ground to don't like a forklift truck to advance have to play to forklift to unload again two or three meters in front of the steering

Q: Battery lift truck charging requirement: Different types of charging machine output parameters are different, and the method should follow the instructions of the charging machine. The electric forklift truck. The wire and socket should be checked before electricity is damaged. If any damage is found, it should be repaired and replaced before recharging. 3, check whether the battery is intact and wiring are in good condition, and open the charging flap, observe the electrolyte is in accordance with the provisions of the liquid level height, add distilled water when necessary, the injection liquid level higher than protective piece of 15 to 20 mm advisable.

Q: Notice those items before the forklift: Before you start, look around and make sure that there is no obstacle to the safety of the car. (2) the braking pressure gauge reading must reach the specified value before it can start. (3) when the forklift truck starts, the driver should make sure that the cargo is stable and reliable. (4) start off slowly and smoothly.

Q: How to drive a forklift? Detailed point!: Machinery driving no matter what, at first there is no shortcut, only practice can achieve the effect, like a reverse driving, you must first put the overall structure of the car general understanding, also need to operate gear, clutch, brake, the most main is to through the training of related departments to drive

Q: Special equipment, the type of vehicle for forklift licence and corresponding driving vehicle: Hello, according to the announcement of the catalogue of the categories and items of the special equipment operations personnel assignment (no. 95 in 2011), this is the rule: Special motor vehicle operation in type field (factory) The name of the vehicle maintenance number N1 Truck driver code N2 The truck driver's driver is named N3 The driver of the internal-combustion car is named N4 The battery tourist driver code N5

Q: Where are the advantages and disadvantages of a battery lifter and a diesel forklift: Working parts of 3. The work part is the direct work of the forklift truck for loading and unloading, which is grouped by the following sections: (1) the tools of withdrawal. It is a variety of work items which are represented by the cargo fork, which is used to fork, pick and shovel the goods. (2) lifting shelves. To install the cargo fork or other work item, and drag the goods up and down. (3) the door frame. It is the skeleton of the work unit, and most of the zero parts of the work unit are installed on the door shelf. The two-section door frame consists of the outer door frame and the inner door frame of the lower lift. The three-section door frame consists of three doors, internal, medium and outer. (4) the leaning mechanism of the door frame. The reclining of the door frame is made up of inclined oil cylinders. (5) the lifting mechanism. Drag and drop power plant and traction gear. It is composed mainly of sprocket, chain and lifting cylinder. (6) hydraulic control system. It is a combination of the lifting of the cargo and the tilt of the door frame and the other actions performed by the hydraulic system. It consists of hydraulic components, pipes and manipulators

Q: Where to test for a forklift?: The forklift card is the certificate issued by the bureau of quality supervision, which is usually a month to two months.

Q: Who sells natural gas forklift: Currently, only anhui forces co., LTD. Has officially passed the enhanced test of the forklift truck, and now anhui forces have been pushed to the international and domestic market. The dual-purpose fuel engine that they match is the E25 type of oil and gas engine in hefei bao power technology co., LTD., which is reliable and dynamic.

Send your message to us

*Email

*TEL

*Quantity

*Unit