Hot Selling Plastic Body Electric Kettle
- Loading Port:
- China Main Port
- Payment Terms:
- TT or LC
- Min Order Qty:
- 1000 Units unit
- Supply Capability:
- 100,000 Units unit/month
OKorder Service Pledge
OKorder Financial Service
You Might Also Like
Hot Selling Plastic Body Electric Kettle
Specification of Hot Selling Plastic Body Electric Kettle:
Power: | 1000-1200W, 1850-2200W | Voltage: | 110-130V.220-240V |
Frequency: | 50/60Hz | Controller: | Fada Controller |
Capacity: | 1.5 L | Tick Mark: | Inner wall of the label |
Material: | Food Grade Material | Heating Way: | Chassis Built-heating |
Features of Hot Selling Plastic Body Electric Kettle:
1. 360 Degrees rotation base, cordless body;
2. Cord storage design;
3. Indication light at the bottom;
4. Automatic shut-off when water boils;
5. Boil-dry & Overheating protection;
6. 100% boiled water;
7. Press button controlfor cover open.
Package Detail of Hot Selling Plastic Body Electric Kettle:
Units / Carton | 12 Units | QTY LOAD 20' | 3420Units |
Carton Size | 60*37.5*46CM | QTY LOAD 40' | 6900 Units |
N.W./G.W. | 12.5kg /13.5kg | QTY LOAD 40'HQ | 8040 Units |
Certification: CE /ROSH /LFGB
- Q:How can we prevent the electric kettle from drying and burning the thermostat?
- When the electric kettle is not dry, the thermostat needs to be replaced in time, and a new dry burning thermostat is needed.Otherwise, in case of dry fire, the heating system of the electric kettle will be damaged. Then the whole kettle would be scrapped.Anti drying temperature controller is an important electronic component to prevent the heating element of electric kettle from being damaged.
- Q:What is the principle of electric kettle heating?
- The working principle of the electric kettle is: double metal sheet using water vapor from the boiling water to steam temperature components of the deformation, using deformation based on the principle of lever push the power switch, so that the electric kettle is automatically turned off after the water boil. The power failure is not self reset, so the kettle will not automatically reheat after power failure.
- Q:Stainless steel electric kettle surface, why not add a layer of heat insulation plastic? Avoid water when touching the electric kettle. May I ask why?
- Traditional electric kettles are made of metal shell, not plastic, such as the most ancient electric heating tube directly heated aluminum electric kettle. The heat conductivity of stainless steel is only 1/3 of iron. It is one or more of the ten or even twenty times of aluminum. Therefore, if the stainless steel shell can have a certain thickness, the water boils due to poor heat conductivity of stainless steel, not as much as 100 degrees celsius.
- Q:Plastic electric kettle for a long time, it will be poisonous?
- Affirmative。When the kettle is used for a long time, the wall is covered with a thick layer of scale. These phenomena suggest that the clear, clear water does have impurities.
- Q:The electric kettle suddenly stopped working
- Prepare a cross screwdriver first, so long as you can unscrew the three screws at the bottom of the kettle.
- Q:The principle of automatic power-off electric kettle?
- Automatic temperature control circuitThe pot boil dry pot is a power automatic temperature control circuit in series. The temperature sensor circuit. The boiling point of water is one hundred degrees, when the water is dried after the temperature will exceed one hundred degrees, when the temperature sensor will disconnect the circuit. The temperature sensor is simple bimetal, commonly used in electric iron electric water heater appliances. Many kinds of temperature sensors. And the semiconductor temperature sensor. It has the advantages of simple structure, safe use, good reliability.
- Q:Can an electric kettle boil water to a Baidu?
- If you care about water, less than 100 degrees can not open, no way to drink, you can rest assured that most of the bacteria are all right.If it is not high temperature resistant bacteria, with more than 70 degrees of water can cause bacterial death, because biological protein near 70 degrees, there will be freezing, don't destroy; if it is high temperature resistant bacteria, such as some bacteria such as tetanus, because of the "spore" and "protection", so the outer membrane must be at room temperature with 100 degrees of boiling water, and will die in 10 minutes, so the previous hospital disinfection of medical equipment, must use the steam pot in pot under the condition of boiling water, cooking 20 minutes later to ensure complete sterilization.
- Q:How to remove the water pollution of electric kettle?
- Potatoes peel off the scales. Put the potatoes in the kettle, add some water to boil, boil for 10 minutes or so to remove the scale.Five boiled eggs, remove the scale. Electric kettle with long hard except fouling. If you cook two eggs with it, you will get the desired effect.
- Q:What about the strange smell of a new electric kettle?
- Hot boil, so that disinfection and odor have been resolved once, and the rest will be washed under it! Hope to help you
- Q:Principle of preventing dry boil of electric kettle
- The principle of bimetallic plate is that 2 different temperature coefficients of metal processing together, the higher the temperature, the 2 metal deformation difference is bigger, deformation to a certain extent, the pressure to the circuit switch.
1. Manufacturer Overview |
|
---|---|
Location | cixi,China |
Year Established | 2010 |
Annual Output Value | Above US$16 Million |
Main Markets | Mid East;Western Europe;North America |
Company Certifications | ISO 9001:2008; |
2. Manufacturer Certificates |
|
---|---|
a) Certification Name | |
Range | |
Reference | |
Validity Period |
3. Manufacturer Capability |
|
---|---|
a)Trade Capacity | |
Nearest Port | ningbo |
Export Percentage | 0.9 |
No.of Employees in Trade Department | 160 People |
Language Spoken: | English;Chinese;Japanese |
b)Factory Information | |
Factory Size: | Above 5,000 square meters |
No. of Production Lines | 4 |
Contract Manufacturing | OEM Service Offered;Design Service Offered |
Product Price Range | Average |
Send your message to us
Hot Selling Plastic Body Electric Kettle
- Loading Port:
- China Main Port
- Payment Terms:
- TT or LC
- Min Order Qty:
- 1000 Units unit
- Supply Capability:
- 100,000 Units unit/month
OKorder Service Pledge
OKorder Financial Service
Similar products
Hot products
Hot Searches
Related keywords